2010-2016 Subaru XV SUV Starting and operating -> Tire pressure monitoring system (TPMS) (U.S.-spec. models) User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Starting and operating -> Tire pressure monitoring system (TPMS) (U.S.-spec. models) for Your Subaru XV SUV First Generation (2010-2016)

7-32 Starting and operating/Tire pressure monitoring system (TPMS) (U.S.–spec. models)Control system, the Vehicle Dynamics. Even when the Vehicle DynamicsTire pressure monitoringControl OFF indicator light turns system is deactivated, compo-system (TPMS) (U.S.- of the brake control system mayWith the Vehicle Dynamics Control systemmodels)still activate. When the brake controldeactivated, traction and stability en-system is activated, the Vehicle Dy-hancement offered by Vehicle Dynamicsnamics Control operation indicatorControl system is unavailable. Thereforelight should not deactivate the VehicleDynamics Control system except underabove-mentioned . The Vehicle Dynamics Control sys-tem will be activated automaticallywhen the engine is started.. If the switch is held down for 30seconds or longer, the indicator lightturns off, the Vehicle Dynamics Controlsystem is activated, and the systemLow tire pressure warning lightignores any further pressing of theswitch. To make the switch usableThe tire pressure monitoring system pro-again, turn the ignition switch to thevides the driver with a warning message“LOCK” (off) position and restart theby sending a signal from a sensor that in each wheel when tire pressure. When the switch is pressed tois severely the Vehicle Dynamics Con-The tire pressure monitoring system willtrol system, the vehicle’s running per-activate only when the vehicle is driven atformance is comparable with that of aspeeds above 20 mph (32 km/h). Also,vehicle that does not have a Vehiclethis system may not react immediately to aDynamics Control system. Do not de-sudden drop in tire pressure (for example,activate the Vehicle Dynamics Controla blow-out caused by running over asystem except when absolutely neces-sharp object).sary.
7-32 Starting and operating/Tire pressure monitoring system (TPMS) (U.S.–spec. models)
Control system, the Vehicle Dynamics
. Even when the Vehicle Dynamics
Tire pressure monitoring
Control OFF indicator light turns off.
Control system is deactivated, compo-
system (TPMS) (U.S.-spec.
nents of the brake control system may
With the Vehicle Dynamics Control system
models)
still activate. When the brake control
deactivated, traction and stability en-
system is activated, the Vehicle Dy-
hancement offered by Vehicle Dynamics
namics Control operation indicator
Control system is unavailable. Therefore
light flashes.
you should not deactivate the Vehicle
Dynamics Control system except under
above-mentioned situations.
NOTE
. The Vehicle Dynamics Control sys-
tem will be activated automatically
when the engine is started.
. If the switch is held down for 30
seconds or longer, the indicator light
turns off, the Vehicle Dynamics Control
system is activated, and the system
Low tire pressure warning light
ignores any further pressing of the
switch. To make the switch usable
The tire pressure monitoring system pro-
again, turn the ignition switch to the
vides the driver with a warning message
“LOCK” (off) position and restart the
by sending a signal from a sensor that is
engine.
installed in each wheel when tire pressure
. When the switch is pressed to
is severely low.
deactivate the Vehicle Dynamics Con-
The tire pressure monitoring system will
trol system, the vehicle’s running per-
activate only when the vehicle is driven at
formance is comparable with that of a
speeds above 20 mph (32 km/h). Also,
vehicle that does not have a Vehicle
this system may not react immediately to a
Dynamics Control system. Do not de-
sudden drop in tire pressure (for example,
activate the Vehicle Dynamics Control
a blow-out caused by running over a
system except when absolutely neces-
sharp object).
sary.
7-33Starting and operating/Tire pressure monitoring system (TPMS) (U.S.–spec. models)low pressure threshold, the low tirewheel if there is no damage to it andWARNINGpressure warning light should turnif the sealant residue is properlyoff a few minutes off. If the light illuminatesIf the low tire pressure warning lightsteadily after blinking for approxi-illuminates while driving, neverIf this light still illuminates whilemately one minute, promptly con-brake suddenly and keep drivingdriving after adjusting the tire pres-tact a SUBARU dealer to have thestraight ahead while gradually redu-sure, a tire may have significantsystem speed. Then slowly pull off thedamage and a fast leak that causesroad to a safe place. Otherwise anthe tire to lose air rapidly. If you haveaccident involving serious vehiclea flat tire, replace it with a spare tireCAUTIONdamage and serious personal injuryas soon as a spare tire is mounted or a. Do not place metal film or anyCheck the pressure for all four tireswheel rim is replaced without themetal parts in the cargo area/and adjust the pressure to the COLDoriginal pressure sensor/transmittertrunk. This may cause poor re-tire pressure shown on the tirebeing transferred, the low tire pres-ception of the signals from theplacard on the door pillar on thesure warning light will illuminatetire pressure sensors, and thedriver’s after blinking for approxi-tire pressure monitoring systemmately one minute. This indicatesEven when the vehicle is driven awill not function TPMS is unable to monitor allvery short distance, the tires get. FCC WARNINGfour road wheels. Contact yourwarm and their pressures increaseChanges or modifications notSUBARU dealer as soon as possibleaccordingly. Be sure to let the tiresexpressly approved by the partyfor tire and sensor replacement and/cool thoroughly before adjustingresponsible for complianceor system pressures to the standa
7-33
Starting and operating/Tire pressure monitoring system (TPMS) (U.S.–spec. models)
low pressure threshold, the low tire
wheel if there is no damage to it and
WARNING
pressure warning light should turn
if the sealant residue is properly
off a few minutes later.
cleaned off. If the light illuminates
If the low tire pressure warning light
steadily after blinking for approxi-
illuminates while driving, never
If this light still illuminates while
mately one minute, promptly con-
brake suddenly and keep driving
driving after adjusting the tire pres-
tact a SUBARU dealer to have the
straight ahead while gradually redu-
sure, a tire may have significant
system inspected.
cing speed. Then slowly pull off the
damage and a fast leak that causes
road to a safe place. Otherwise an
the tire to lose air rapidly. If you have
accident involving serious vehicle
a flat tire, replace it with a spare tire
CAUTION
damage and serious personal injury
as soon as possible.
could occur.
When a spare tire is mounted or a
. Do not place metal film or any
Check the pressure for all four tires
wheel rim is replaced without the
metal parts in the cargo area/
and adjust the pressure to the COLD
original pressure sensor/transmitter
trunk. This may cause poor re-
tire pressure shown on the tire
being transferred, the low tire pres-
ception of the signals from the
placard on the door pillar on the
sure warning light will illuminate
tire pressure sensors, and the
driver’s side.
steadily after blinking for approxi-
tire pressure monitoring system
mately one minute. This indicates
Even when the vehicle is driven a
will not function properly.
the TPMS is unable to monitor all
very short distance, the tires get
. FCC WARNING
four road wheels. Contact your
warm and their pressures increase
Changes or modifications not
SUBARU dealer as soon as possible
accordingly. Be sure to let the tires
expressly approved by the party
for tire and sensor replacement and/
cool thoroughly before adjusting
responsible for compliance
or system resetting.
their pressures to the standard
could void the user’s authority
values shown on the tire placard.
When a tire is repaired with liquid
to operate the equipment.
Refer to “Tires and wheels” F11-21.
sealant, the tire pressure warning
The tire pressure monitoring system
valve and transmitter may not oper-
does not function when the vehicle
ate properly. If a liquid sealant is
NOTE
is stationary. After adjusting the tire
used, contact your nearest SUBARU
This device complies with Part 15 of
pressures, increase the vehicle
dealer or other qualified service
the FCC Rules and RSS-Gen of IC
speed to at least 20 mph (32 km/h)
shop as soon as possible. Make
Rules. Operation is subject to the
to start the TPMS re-checking of the
sure to replace the tire pressure
following two conditions: (1) this de-
tire inflation pressures. If the tire
warning valve and transmitter when
vice may not cause harmful interfer-
pressures are now above the severe
replacing the tire. You may reuse the
– CONTINUED –
7-34 Starting and operating/Parking your vehicleence, and (2) this device must acceptParking your vehicleCAUTIONany interference received, includinginterference that may cause undesired& Parking brakeNever drive while the parking set because this will cause un-To set the parking brake, depress thenecessary wear on the brake lin-brake pedal firmly and hold it down untilings. Before starting to drive, alwaysthe parking brake lever is fully pulled sure that the parking brakehas been fully released.& Parking tipsWhen parking your vehicle, always per-form the following items.. Apply the parking brake firmly.. For MT models, put the shift lever in the“1” (1st) for upgrade or “R” (Reverse) for adowngrade.. For CVT models, put the select lever inthe “P” (Park) release the parking brake, pull the leverNever rely on the mechanical friction ofup slightly, press the release button, thenthe transmission alone to hold the the lever while keeping the the parking brake is set while theengine is running, the parking brakewarning light illuminates. After startingthe vehicle, be sure that the warning lighthas turned off before the vehicle is to “Parking brake warning” F3-17.
7-34 Starting and operating/Parking your vehicle
ence, and (2) this device must accept
Parking your vehicle
CAUTION
any interference received, including
interference that may cause undesired
& Parking brake
Never drive while the parking brake
operation.
is set because this will cause un-
To set the parking brake, depress the
necessary wear on the brake lin-
brake pedal firmly and hold it down until
ings. Before starting to drive, always
the parking brake lever is fully pulled up.
make sure that the parking brake
has been fully released.
& Parking tips
When parking your vehicle, always per-
form the following items.
. Apply the parking brake firmly.
. For MT models, put the shift lever in the
“1” (1st) for upgrade or “R” (Reverse) for a
downgrade.
. For CVT models, put the select lever in
the “P” (Park) position.
To release the parking brake, pull the lever
Never rely on the mechanical friction of
up slightly, press the release button, then
the transmission alone to hold the vehicle.
lower the lever while keeping the button
pressed.
When the parking brake is set while the
engine is running, the parking brake
warning light illuminates. After starting
the vehicle, be sure that the warning light
has turned off before the vehicle is driven.
Refer to “Parking brake warning” F3-17.

Related Topics

Popular Owner Manuals