2010-2015 Suzuki Swift 4 Door BEFORE DRIVING -> Theft Deterrent Alarm System User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

BEFORE DRIVING -> Theft Deterrent Alarm System for Your Suzuki Swift 4 Door Second Generation (2010-2015)

Seat Adjustment: 3  
BEFORE DRIVING  
NOTE:  
How to arm the theft deterrent alarm  
system (when enabled)  
Theft Deterrent Alarm System  
• The theft deterrent alarm system gener-  
ates alarms when any of the predeter-  
mined conditions is met. However, the  
system does not have any function of  
blocking unauthorized entry into your  
vehicle.  
The theft deterrent alarm system is armed  
in about 20 seconds after you lock the  
doors.  
Keyless push start system – Use the  
remote controller or push the request  
switch on the driver’s door, passenger’s  
door or tailgate.  
Lock the doors using the keyless push  
start system remote controller, the request  
switch or the keyless entry system trans-  
mitter. The theft deterrent light (1) will start  
blinking, and the theft deterrent alarm sys-  
tem will be armed in about 20 seconds.  
While the system is being armed, the indi-  
cator continues to blink at approximately 2-  
second intervals.  
• Always use the keyless push start sys-  
tem remote controller, the request switch  
or the keyless entry system transmitter  
to unlock the doors when the theft deter-  
rent alarm system has been armed.  
Using a key instead will trigger the  
alarm.  
• If a person who does not know the theft  
deterrent alarm system is going to drive  
your vehicle, we recommend you explain  
the system and its operation to the per-  
son, or disable the system beforehand.  
Mistakenly triggering the alarm may  
cause a nuisance to others.  
Keyless entry system – Use the transmit-  
ter.  
Once the system is armed, any attempt to  
open a door by using any other means (*)  
than the keyless push start system remote  
controller, the request switch or the keyless  
entry system transmitter will cause the  
alarm to be triggered.  
* These means include the following:  
– The key  
– The lock lever on a door  
– The power door locking switch  
(1)  
• Even if the theft deterrent alarm system  
is armed, you should still be careful to  
guard against theft. Do not leave money  
or things of value in your vehicle.  
71LST0203  
2-13  
58MS0-14E  
Adjustable Head Restraints: 3  
Seat Belts and Child Restraint Systems: 3  
BEFORE DRIVING  
NOTE:  
How to stop the alarm  
Checking whether the alarm has been  
triggered during parking  
To prevent the alarm from being acciden-  
tally triggered, avoid arming it while any-  
one remains inside the vehicle. The  
alarm will be triggered if any person  
inside unlocks a door by operating the  
lock lever or power door locking switch.  
• The theft deterrent alarm system is not  
armed when all doors are locked using  
the key from outside, or using the door  
lock levers or the power door locking  
switch from inside.  
Should the alarm be triggered accidentally,  
press the engine switch to change the igni-  
tion mode to “ON” or turn the ignition  
switch to “ON” position. The alarm will then  
stop.  
If the alarm was triggered due to an unau-  
thorized entry into the vehicle and you then  
press the engine switch to change the igni-  
tion mode to “ON” or turn the ignition  
switch to “ON” position, the theft deterrent  
light will blink rapidly for about 8 seconds  
and a buzzer will beep 4 times during this  
period. If this happens, check whether your  
vehicle has been broken into while you  
were away from it.  
NOTE:  
• Even after the alarm has stopped, if you  
lock the doors using the keyless push  
start system remote controller, the  
request switch or the keyless entry sys-  
tem transmitter, the theft deterrent alarm  
system will be rearmed with a delay of  
about 20 seconds.  
• If any of the doors is not operated within  
approximately 30 seconds after the  
doors have been unlocked using the key-  
less push start system remote controller,  
the request switch or the keyless entry  
system transmitter, the doors are auto-  
matically locked again. At the same time,  
the theft deterrent alarm system is  
armed if the system is in the enabled  
state.  
Enabling and disabling the theft deter-  
rent alarm system  
The theft deterrent alarm system can be  
either “enabled” or “disabled”.  
• If you disconnect the battery while the  
theft deterrent alarm system is in the  
armed condition or the alarm is actually  
in operation, the alarm will be triggered  
or re-triggered when the battery is then  
reconnected, although, in the latter case,  
the alarm remains stopped for the period  
between disconnection and reconnec-  
tion of the battery.  
• Even after the alarm has stopped at the  
end of the predetermined operation time,  
it will be triggered again if any door is  
opened without disarming the theft  
deterrent alarm system.  
When enabled (factory setting)  
When the system is enabled, it causes the  
hazard warning lights to flash for about 40  
seconds if any of the alarm trigger condi-  
tions is met. The system also causes the  
interior buzzer to beep intermittently for  
about 10 seconds, which is followed by  
intermittent sounding of the horn for about  
30 seconds.  
How to disarm the theft deterrent alarm  
system  
Simply unlock the doors using the keyless  
push start system remote controller, the  
request switch or the keyless entry system  
transmitter. The theft deterrent light will go  
out, indicating that the theft deterrent  
alarm system is disarmed.  
The theft deterrent light continues to blink  
during this time.  
When disabled  
When the system is disabled, it stays dis-  
armed even if you perform any system  
arming operation.  
2-14  
58MS0-14E  
Seat Belts and Child Restraint Systems: 3  
BEFORE DRIVING  
How to switch the state of the theft  
deterrent alarm system  
You can switch the theft deterrent alarm  
system from the enabled state to the dis-  
abled state, and vice versa, using the fol-  
lowing method.  
1) With the ignition mode “ON” or the igni-  
tion switch in the “ON” position, close all  
the doors and turn the lock knob (1) on  
the driver’s door in the unlocking direc-  
tion (2) (rearward). Turn the knob on the  
lighting control lever to the OFF position  
(5).  
EXAMPLE  
(3)  
(2)  
(4)  
NOTE:  
(3)  
All operations included in the following  
steps 2) and 3) must be completed within  
15 seconds.  
(2)  
2) Turn the knob on the lighting control  
(1)  
74LHT0202  
lever to the  
position (6) and then to  
the OFF position (5). Repeat this opera-  
tion 4 times with the control finally lever  
set to the OFF position.  
(2) UNLOCK  
(3) LOCK  
3) Push the lock end (3) (forward end) of  
the power door lock switch (4) to lock  
the doors, and then the unlock end (2)  
(backward end) to unlock the doors.  
Repeat these operations 3 times and  
finally push the lock end of the switch.  
EXAMPLE  
58MST0204  
(6)  
(5)  
EXAMPLE  
58MST0205  
2-15  
58MS0-14E  
Seat Belts and Child Restraint Systems: 3  
BEFORE DRIVING  
Every time you perform the series of the  
above steps, the state of the theft deterrent  
alarm system changes from the currently  
selected one to the other. You can check  
whether the system is enabled or disabled  
by the number of interior buzzer beeps at  
the end of the procedure as follows.  
Driver’s side  
EXAMPLE  
Windows  
Manual Window Control  
(if equipped)  
(1)  
EXAMPLE  
(3)  
System state  
Number of beeps  
Once  
Disabled  
(2)  
Enabled  
4 times  
74LHT0204  
NOTE:  
The driver’s door has a switch (1) to oper-  
ate the driver’s window, and a switch (2) to  
operate the front passenger’s window or  
there are switches (3), (4), to operate the  
rear left and right passenger windows,  
respectively.  
You cannot disable the theft deterrent  
alarm system while it is in the armed  
condition.  
60G010  
Raise or lower the door windows by turning  
the handle located on the door panel.  
• If you fail to complete the operations in  
step 2) and 3) within 15 seconds, per-  
form the procedure again from the  
beginning.  
• Make sure all doors are closed when  
performing the above procedure.  
Electric Window Controls  
(if equipped)  
The electric windows can only be operated  
when the ignition switch is in the “ON” posi-  
tion or the ignition mode is “ON”.  
2-16  
58MS0-14E  

Related Topics

Popular Owner Manuals