OPERATIONOFINSTRUMENTSANDCONTROLS -> Power back window for Your Toyota 4 Runner SUV Fourth Generation (2003-2009)

07 12.25  
Power back window  
If the battery is disconnected or run  
down, the power back window may not  
operate automatically and the jam protec-  
tion function will not function correctly af-  
ter you reconnect, replace or recharge the  
battery. In any of these cases, you should  
normalize the power back window with the  
power back window switch.  
Automatic operation: To open or close  
the back window, push and hold the “Ɲ”  
(down) or “Ɯ” (up) switch. The window  
will fully open or close. To stop the win-  
dow partway, push the switch on either  
the “Ɲ” (down) or “Ɯ” (up) side briefly.  
Key off operation: If both front doors are  
closed, it works for 43 seconds even after  
the engine switch is turned off. It stops  
working when either front door is opened.  
To normalize the power back window:  
1. Push the “Ɲ” (down) switch and lower  
the window halfway.  
Jam protection function: During automat-  
ic closing operation or key off closing op-  
eration, the window stops and opens half  
way if something gets caught between the  
window and window frame.  
2. Push the “Ɯ” (up) switch until the win-  
dow closes and hold the switch for a  
second.  
The back window can be operated with  
the switch on the instrument panel or  
the key operation in the back door key-  
hole.  
Make sure that the window opens and  
closes automatically. If the power back  
window cannot be operated properly, have  
it checked by your Toyota dealer.  
If the window receives a strong impact,  
this function may work even if nothing is  
caught.  
The power back window works when the  
engine switch is in the “ON” position.  
OPERATING FROM INSIDE  
CAUTION  
You can open the back window when the  
back window wiper is working. At that  
time, the wiper stops working until the  
window is closed again.  
The engine switch must be in the “ON”  
position.  
D Never try jamming any part of your  
body to activate the jam protection  
function intentionally, as it could re-  
sult in death or serious injury.  
Normal operation: To open or close the  
back window, quickly push and release the  
Ɲ” (down) or “Ɯ” (up) switch.  
If the back window is not fully closed, the  
back window wiper, washer and defogger  
will not work. (See “Back window wiper  
and washer” on page 141 and “Back  
window and outside rear view mirror  
defoggers” on page 142 in Section 15.)  
D The jam protection function may  
not work if something gets caught  
just before the window is fully  
closed.  
30  
07 12.25  
OPERATING FROM OUTSIDE  
The back window can be opened and  
closed with the key operation in the back  
door keyhole.  
To open: Turn the key fully counterclock-  
wise and hold it.  
After the door is unlocked, the window  
begins to open. To stop the window part-  
way, release the key.  
To close: Turn the key fully clockwise and  
hold it.  
After the door is locked, the window be-  
gins to close. To stop the window partway,  
release the key.  
If you push in the window lock switch on  
the driver’s door, the back window cannot  
be operated.  
This door key linked function can be dis-  
abled. For details, contact your Toyota  
dealer.  
Jam protection function: During closing  
operation, the window stops and opens  
half way if something gets caught between  
the window and window frame.  
If the window receives a strong impact,  
this function may work even if nothing is  
caught.  
31  

Related Topics