OPERATIONOFINSTRUMENTSANDCONTROLS -> Seats for Your Toyota 4 Runner SUV Fourth Generation (2003-2009)

07 12.25  
Front seats—  
—Front seat precautions  
Seats  
While the vehicle is being driven, all ve-  
hicle occupants should have the seatback  
upright, sit well back in the seat and prop-  
erly wear the seat belts provided.  
Driver seat  
D Slightly recline the back of the  
seat. Although vehicle designs vary,  
many drivers can achieve the 250  
mm (10 in.) distance, even with the  
driver seat all the way forward, sim-  
ply by reclining the back of the  
seat somewhat. If reclining the back  
of your seat makes it hard to see  
the road, raise yourself by using a  
firm, nonslippery cushion, or raise  
the seat if your vehicle has that  
feature.  
CAUTION  
The SRS driver airbag deploys with  
considerable force, and can cause  
death or serious injury especially if  
the driver is very close to the airbag.  
The National Highway Traffic Safety  
Administration (“NHTSA”) advises:  
CAUTION  
D Do not drive the vehicle unless the  
occupants are properly seated. Do  
not allow any passengers to sit on  
top of a foldeddown seatback, or  
in the luggage compartment or car-  
go area. Persons not properly  
seated and/or not properly re-  
strained by seat belts can be killed  
or severely injured in the event of  
emergency braking or a collision.  
Since the risk zone for driver airbag  
is the first 50—75 mm (2—3 in.) of  
inflation, placing yourself 250 mm (10  
in.) from your driver airbag provides  
D If your steering wheel is adjustable,  
tilt it downward. This points the air-  
bag toward your chest instead of  
your head and neck.  
you with  
a
clear margin of safety.  
This distance is measured from the  
center of the steering wheel to your  
breastbone. If you sit less than 250  
mm (10 in.) away now, you can  
change your driving position in sever-  
al ways:  
D During driving, do not allow any  
passengers to stand up or move  
around between seats. Otherwise,  
death or severe injuries can occur  
in the event of emergency braking  
or a collision.  
The seat should be adjusted as rec-  
ommended by NHTSA above, while  
still maintaining control of the foot  
pedals, steering wheel, and your view  
of the instrument panel controls.  
D Move your seat to the rear as far  
as you can while still reaching the  
pedals comfortably.  
42  
07 12.25  
—Seat adjustment precautions  
Front passenger seat  
Front seats  
CAUTION  
CAUTION  
CAUTION  
D Do not adjust the seat while the  
vehicle is moving as the seat may  
unexpectedly move and cause the  
driver to lose control of the vehicle.  
The SRS side airbags are installed in  
the driver and front passenger seats.  
Observe the following precautions.  
The SRS front passenger airbag also  
deploys with considerable force, and  
can cause death or serious injury es-  
pecially if the front passenger is very  
close to the airbag. The front passen-  
ger seat should be as far from the  
airbag as possible with the seatback  
adjusted, so the front passenger sits  
upright.  
D Be careful that the seat does not  
hit a passenger or luggage.  
D Do not lean against the front door  
when the vehicle is in use, since  
the side airbag inflates with consid-  
erable speed and force. Otherwise,  
you may be killed or seriously in-  
jured.  
D After adjusting the seat position, re-  
lease the lever and try sliding the  
seat forward and backward to make  
sure it is locked in position.  
D Do not use seat accessories which  
cover the area where the side air-  
bags inflate. Such accessories may  
prevent the side airbags from acti-  
vating correctly, causing death or  
serious injury.  
D After adjusting the seatback, push  
your body back against the seat to  
make sure the seat is locked in  
position.  
D Do not put objects under the seats.  
Otherwise, the objects may interfere  
with the seatlock mechanism or  
unexpectedly push up the seat posi-  
tion adjusting lever and the seat  
may suddenly move, causing the  
driver to lose control of the vehicle.  
D Do not modify or replace the seats  
or upholstery of the seats with side  
airbags. Such change may prevent  
the side airbag system from activat-  
ing correctly, disable the system or  
cause the side airbags to inflate ac-  
cidentally, resulting in death or seri-  
ous injury.  
43  
07 12.25  
—Adjusting front seats  
(manual seat)  
1. SEAT POSITION ADJUSTING LEVER  
D While adjusting the seat, do not put  
your hands under the seat or near  
the moving parts. Otherwise, your  
hands or fingers may be caught and  
injured.  
Hold the center of the lever and pull it  
up. Then slide the seat to the desired  
position with slight body pressure and  
release the lever.  
2. SEAT CUSHION ANGLE ADJUSTING  
KNOB (driver’s seat only)  
To change the angle of the seat cush-  
ion on the front side, turn the knob  
either way.  
3. SEAT HEIGHT ADJUSTING LEVER  
(driver’s seat only)  
To change the height of the seat, pull  
up or push down the lever.  
4. SEATBACK  
LEVER  
ANGLE  
ADJUSTING  
Lean forward and pull the lever up.  
Then lean back to the desired angle  
and release the lever.  
44  
07 12.25  
—Adjusting front seats (power  
seat)  
1. DRIVER’S SEAT: SEAT POSITION,  
SEAT CUSHION ANGLE AND SEAT  
HEIGHT ADJUSTING SWITCH  
CAUTION  
Avoid reclining the seatback any  
more than needed. The seat belts pro-  
vide maximum protection in a frontal  
or rear collision when the driver and  
the front passenger are sitting up  
straight and well back in the seats. If  
you are reclined, the lap belt may  
slide past your hips and apply re-  
straint forces directly to the abdomen  
or your neck may contact the shoul-  
PASSENGER’S SEAT: SEAT POSITION  
ADJUSTING SWITCH  
Move the control switch in the desired  
direction.  
Releasing the switch will stop the seat at  
that position.  
Do not place anything under the front  
seats, as this might interfere with the seat  
movement.  
der belt. In the event of  
a
frontal  
2. SEATBACK  
SWITCH  
ANGLE  
ADJUSTING  
collision, the more the seat is re-  
clined, the greater the risk of death  
or serious injury.  
Move the control switch in the desired  
direction.  
5. SEAT  
LUMBAR  
SUPPORT  
Releasing the switch will stop the seat-  
back at that position.  
ADJUSTING SWITCH (driver’s seat  
only)  
Push the control switch on either side.  
The amount of lumbar support will change  
while the switch is pushed.  
45  
07 12.25  
—Flattening seatbacks  
(manual seat)  
CAUTION  
Avoid reclining the seatback any  
more than needed. The seat belts pro-  
vide maximum protection in a frontal  
or rear collision when the driver and  
the front passenger are sitting up  
straight and well back in the seats. If  
you are reclined, the lap belt may  
slide past your hips and apply re-  
straint forces directly to the abdomen  
or your neck may contact the shoul-  
der belt. In the event of  
a
frontal  
collision, the more the seat is re-  
clined, the greater the risk of death  
or serious injury.  
1. Remove the head restraint. Hold the  
center of the lever and pull it up.  
Then slide the seat further forward  
than the frontmost lock position.  
2. Pull the seatback angle adjusting le-  
ver to unlock and push down the  
seatback.  
When returning the seatback upright, be  
careful not to make yourself hit by the  
seatback which will bound with consid-  
erable spring force.  
3. SEAT  
LUMBAR  
SUPPORT  
ADJUSTING SWITCH (driver’s seat  
only)  
Push the control switch on either side.  
After returning the seat to its original  
position, be certain to replace the head  
restraint.  
The amount of lumbar support will change  
while the switch is pushed.  
46  
07 12.25  
—Flattening seatbacks  
(power seat)  
CAUTION  
D Do not allow passengers to ride on  
the flattened seat while driving; use  
the seat in the normal position.  
D After putting back the seat, try  
pushing the seat and seatback for-  
ward and rearward to make sure it  
is secured in place. Be certain to  
replace the head restraint.  
1. Remove the head restraint. Move the  
seat position adjusting switch for-  
ward to slide the seat further for-  
ward than the frontmost position.  
2. Move the seatback angle adjusting  
switch backward to flatten the seat-  
back.  
After returning the seat to its original  
position, be certain to replace the head  
restraint.  
47  

Related Topics