02 Instruments and controls
Left-side steering wheel lever
Lever positions
Turn signals
When turning
High/low beam headlights
02
Continuous high beams
See page 64 for an illustration of the lighting
panel.
–
Move the lever as far up or down as pos-
sible (to position 2) to start the turn signals.
The turn signals will be cancelled automatically
by the movement of the steering wheel, or the
lever can be returned to its initial position by
hand.
1. Turn the ignition key to at least position II.
2. With the light switch pointing to the symbol
,
* or A*, (see the section
"Lighting panel" beginning on page 64, pull
the turn signal lever toward the steering
wheel (position 4) to toggle between high
and low beams.
When changing lanes
The driver can automatically flash the turn sig-
nals 3 times by:
Moving the turn signal lever up or down to
•
High beam flash
See page 64 for an illustration of the lighting
panel.
position 1 and releasing it.
Moving the lever up or down to position 2
and immediately back to its original posi-
tion.
•
Turn signals, lane change position
Turn signals, position for normal turns
High beam flash
1. Turn the ignition key to position I.
2.
With the light switch in position
pull
NOTE
the turn signal lever to position 3 or 4. The
high beams will flash for approximately
1 second.
Toggle between high and low beams,
Home Safe lighting
This automatic flashing sequence can
be interrupted by immediately moving
the lever in the opposite direction.
•
With the light switch in position
, pull
If the turn signal indicator flashes faster
than normal, check for a burned-out
turn signal bulb.
•
the turn signal lever to position 3. The high
beams will remain on until the lever is
released.
68
* Option/accessory, for more information, see Introduction.
English 
