Technical specification
The wireless charger and NFC reader is designed to work in ambient temperatures between -35 °C and 85 °C.
Wireless charger
Frequency Band: 127,7±10kHz
Maximum Magnetic Field Strength: 65,69dBµA/m @10m
NFC card reader
Frequency Band 13.56MHz ±10%
Maximum Magnetic Field Strength: 42dBµA/m @10m
Declaration of conformity
CE RED
Hereby, Hefei Invispower Co.,Ltd declares that the radio equipment NFCRꢀINTERNAL (model: NFCꢀIꢀSXꢀ21548) and Model-Wireless charging (model:
WPCꢀ15SNꢀ21493) are in compliance with Directive 2014ꢃ53ꢃEU.
The Maximum Permissible Exposure (MPE) level for this equipment is based on a distance of 20 cm between the equipment and the human body. To comply
with RF exposure requirements, it is recommended to maintain a distance of at least 20 cm between the equipment and body parts during use.
UKCA
Hereby, Hefei Invispower Co.,Ltd declares that the radio equipment NFCRꢀINTERNAL (model: NFCꢀIꢀSXꢀ21548) and Model-Wireless charging (model:
WPCꢀ15SNꢀ21493) are in compliance with UK Radio Equipment Regulations (SI 2017ꢃ1206).
FCC ID
& IC
This device complies with part 15 of the FCC rules and with RSS-Gen,RSSꢀ216 rules of Canada. Operation is subject to the following two conditions:
ꢁ. This device may not cause harmful interference, and
ꢂ. This device must accept any interference received, including interference that may cause undesired operation.
Any changed or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. FCC
RF Radiation Exposure Statement: This equipment complies with FCC RF Radiation exposure limits set forth for an uncontrolled environment. This device and
its antenna must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with a
minimum distance of 20cm between the radiator and your body. Note: This equipment has been tested and found to comply with the limits for a Class B di-
gital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential in-
stallation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
IDéclaration d'avertissement ISED Son fonctionnement est soumis aux deux conditions suivantes:
ꢁ. Cet appareil ne doit pas provoquerd'interferences nuisibles, et
ꢂ. Cet appareil doit accepter toute interference recue, y compris les interferences pouvant entrainerun fonctionnement indesirable.
Les changements ou modifications non expressement approuves par la partie responsable de la conformité peut annuler l'autorite de l'utilisateura utilizer
l'equipement. Déclaration d'exposition aux radiations RF de l'ISED: Cet équipement est conforme aux limites d'exposition aux rayonnements RF de l'ISED
définies pour un environnement non contrôlé. Cet appareil et son antenne ne doivent pas être situés ou fonctionner conjointement avec une autre antenne ou
un autre émetteur
ANATEL This equipment is not entitled to protection against harmful interference and may not cause interference to properly authorized systems. For more informa-
Este equipamento não tem direito à proteção contra interferência prejudicial e não pode causar interferência em sistemas devidamente autorizados. Para
The content of this manual represents the status of the user manual at the time of printing and may not be completely valid in future
instances. For more information, refer to the first page for the complete disclaimer note.
385 / 396
English 
