• Additional fastening
points for special attachments
The side rails are hollow profiles. If it is required to drill
there, this may only be performed in the neutral zone
(centre of side rail, but with sufficient distance to the
flange). In addition, spacer bushings must then be welded
in.
• Boreholes which are
applied ex-works at the upper and lower belt of the side rails must not be drilled and/or
extended. In addition, these boreholes must not be used for holding any
instruments, modules, etc.
• Boreholes for connecting
passages for pipes, electric cables, tackle blocks, etc. and for attaching add-on
parts
(clamps, etc.). In exceptional cases, we approve of boreholes to be carried out in the bar of the
side rails
or in the cross-members. In this case, however, it is strongly recommended to get in
touch with us.
Note: Subject to errors and technical amendments. The electronic
version of the body guidelines is the decisive source of up-to-date data on body guidelines
(online body
guidelines). Data status August 2007
51
English 