Memory function
Fig. 1 On the driver seat: Memory buttons.
The memory buttons can be used to store and recall settings for the driver seat.
Storing the driver seat settings
1. Switch on the electronic parking brake.
2. Put the gearbox into neutral.
3. Switch on the ignition.
4. Adjust the driver seat.
5. Press the
→ Fig. 1 button for longer than one second.
6. Press the desired memory button within approximately 10 seconds.
An acoustic signal confirms that the settings have been stored.
Retrieving the driver seat settings
1. When the vehicle is stationary, the ignition is switched off and one vehicle door is open, briefly press the
corresponding memory button.
After around ten minutes, the stored position canno longer be adjusted automatically. The adjustment process
is cancelled if one of the memory buttons is pressed again.
Or: With the driver door closed or ignition switched on, press and hold the corresponding memory button until
the stored position has been attained.
If the driver door is opened later than approximately 10 minutes after unlocking the vehicle, the driver seat is
not adjusted automatically.
Personalisation
You can save and access your individual seat setting in a user account via the personalisation function
(→ Personalisation).
After switching off the ignition and locking the vehicle, the driver seat settings are stored in the user account.
The driver seat settings are restored after the vehicle is unlocked and the driver door is opened.
The seat responds to selecting or changing a user account as follows:
—Vehicle stationary or moving no faster than 5 km/h(3 mph): Seat is moved. You can cancel the movement at any
time by tapping the appropriate function button in the Infotainment system or by pressing a button on the driver
seat.
—The vehicle speed is higher than 5 km/h(3 mph): Seat is not moved. All other setup configurations are adopted.
145
English 