document_0900452a81793dcc.book Seite 138 Mittwoch, 21. März 2007 5:42 17
138
Audi parking system
When the turn signals are on, the display will only show the mark-
ings for the relevant side. To change the display to the other side,
just switch on the opposite turn signals.
A
– Press the control button for Mode A ⇒ page 136,
fig. 150. “Parking mode 2” ⇒ fig. 151 will appear in the
MMI display.
3
4
The light blue A and dark blue A curves show you when to turn the
steering wheel in the other direction, i.e. when the curve touches
the kerb. ⇒ page 137, fig. 152.
– Reverse and align the position of your vehicle in such a
2
way that the dark blue area marking A ⇒ fig. 151
borders onto the vehicle behind or onto the parking
space line marking. If you are not parking next to obsta-
cles ⇒ page 141 the long side of the dark blue marking
should border onto the kerb. The complete dark blue
area marking must fit into the parking space ⇒ page 134,
fig. 146.
5
6
The distance from your rear bumper A to the red line A is approx.
40 cm. From here at the latest, the driver should not reverse any
further ⇒ page 142.
WARNING
Please note that objects which are not touching the ground may
appear to be further away than they actually are (e.g. the bumper
of a parked vehicle, a towing bracket or the rear end of a truck). In
this case you should not use the orientation lines for judging the
distance (accident risk).
– When the vehicle is stationary turn the steering wheel to
the right as far as it will go.
– Reverse into the parking space. If you are not parking
4
next to obstacles ⇒ page 141 the dark blue marking A
should touch the kerb ⇒ page 137, fig. 152. Stop your
vehicle.
Caution
– Turn the steering wheel to the left as far as it will go
(vehicle is stationary).
The MMI display shows the path of the rear end of the vehicle if you
were to reverse using the current steering angle. NB: The front end
of the vehicle swings out further than the rear.
– Continue to reverse into the parking space until the
vehicle is standing parallel to the kerb. When reversing
you must also keep a close watch on the front end of the
Note
To ensure that the reversing camera works properly, the lens of the
camera ⇒ page 131, fig. 143 must be kept clean and free of snow
and ice. Please observe the additional notes on ⇒ page 143.
vehicle ⇒
.
You can use “Parking mode 2” to park on the left or the right side of
the road. For this reason, the blue markings are shown in various
2
shades of blue. The dark blue area marking A and the dark blue
Applies to vehicles: with parking system and towing bracket
4
curve A are used when parking on the right side of the road. The
1
3
light blue area marking A and the light blue curve A are used
Towing bracket
when parking on the left side of the road.
Once the electrical connector for the trailer socket is plugged in on
vehicles with a factory-fitted towing bracket the rear sensors for the
English 
