Advertisement

Advertisement

Driving -> Reversing camera for Your Citroen C4 SUV Third Generation (2020-2025)

Driving  
The turquoise curves 4 show the maximum  
The parking sensors are deactivated while the  
Park Assist function is measuring a space.  
For more information on the Park Assist  
function, refer to the corresponding section.  
6
turning angle in either direction.  
C4  
Opening the tailgate causes the display  
to disappear.  
When starting the vehicle, the graphic  
and audible aids are only available after  
the touch screen has started up.  
Clean the reversing camera regularly  
using a soft, dry cloth.  
The reversing camera is activated automatically  
when reverse gear is engaged.  
The image is displayed on the touch screen.  
Operating limits  
If the boot is heavily loaded, the vehicle may tilt,  
affecting distance measurements.  
Top Rear Vision - 360  
Vision  
The reversing camera function may be  
supplemented by the parking sensors.  
Malfunction  
In the event of a malfunction when  
changing into reverse gear, these  
With MyCitroën Play or  
MyCitroën Drive  
warning lamps light up on the instrument panel,  
accompanied by the display of a message and  
an audible signal (short beep).  
Have it checked by a CITROËN dealer or a  
qualified workshop.  
For more information, refer to the  
General recommendations on the use  
of driving and manoeuvring aids.  
With the engine running, these systems allow  
views of your vehicle’s close surroundings to be  
displayed on the touch screen using one camera  
for Top Rear Vision and two cameras for 360  
Vision.  
Reversing camera  
The blue lines 1 indicate the general direction of  
the vehicle (the gap corresponds to the width of  
your vehicle including the mirrors).  
The red line 2 represents a distance of about  
30 cm beyond the edge of your vehicle's rear  
bumper.  
For more information, refer to the  
General recommendations on the use  
of driving and manoeuvring aids.  
The green lines 3 represent distances of about 1  
and 2 metres beyond the edge of your vehicle's  
rear bumper.  
139  
Driving  
• "Zoom view".  
• "AUTO view".  
The display is immediately updated with the type  
of view selected.  
the system is activated when the vehicle has  
already moved, the view from above can be fully  
displayed.  
Top Rear Vision  
The system status is not saved when the ignition  
is switched off.  
Rear view  
Operating principle  
The screen is divided into two parts with a  
contextual view and a view from above the  
vehicle in its close surroundings.  
The parking sensors supplement the information  
on the view from above the vehicle.  
Various contextual views may be displayed:  
– Standard view.  
Using one or two cameras, the close  
surroundings of the vehicle are recorded whilst  
manoeuvring at low speed.  
An image from above your vehicle in its close  
surroundings is reconstructed (represented  
between the brackets) in real time and as the  
manoeuvre progresses.  
It facilitates the alignment of your vehicle when  
parking and allows obstacles close to the vehicle  
to be seen. It is automatically deleted if the  
vehicle remains stationary for too long.  
With 360 Vision, the image is created using  
both cameras, when going forward and when  
reversing.  
To activate the camera located near the number  
plate lamps, engage reverse gear and do not  
exceed a speed of 6 mph (10 km/h).  
The system is deactivated:  
– Automatically, at speeds above approximately  
12 mph (20 km/h),  
– Automatically, if the boot is opened.  
– When changing out of reverse gear.  
– By pressing the white arrow in the upper-left  
corner of the touch screen.  
– 180° view.  
– Zoom view.  
AUTO mode is activated by default.  
In this mode, the system chooses the best  
view to display (standard or zoom).  
You can change the type of view at any time  
during a manoeuvre.  
► Press the button in the bottom left-hand  
corner of the touch screen.  
► Select the type of view:  
When the function is activated, it is possible  
that the view from above is not displayed. If  
• "Standard view".  
• "180° view".  
140