Get Comfort -> Programmable heating Guide for Citroen C5 Suv First Generation (2001-2008)

PROGRAMMABLe He ATING

(De Pe NDING ON COUNTRy )

iii

9 Programmable heating system

warning lamp.

ꢀ

•

LeD lit : Activated.

LeD off : Deactivated.

With the engine off, programmable

heating preheats the coolant cir-

cuit in order to optimise the engine

operating temperature prior to

starting.

The programmable heating sys-

tem can be started immediately or

delayed thanks to its programming

function.

Digital programmer

The heating system’s programmer

is located on the right-hand side of

the dashboard.

1. Time or remaining functioning

time.

2. Increase (time).

3. select programme.

ꢀ. Programme number selected.

5. Immediate start-up of heating.

6. Time adjustment and reading

warning lamp.

7. Reduce (time).

8. Heating mode warning lamp.

immediate start-up

Press button 5.

The screen displays a default

duration of 60 minutes, you are

advised to adjust this to a duration of

30 minutes maximum (see section

“ adjusting the operating duration ”).

The warning lamp 8 lights up and

remains lit for the whole duration of

the system’s operation. The duration

of the system’s operation disappears

after ꢀ0 seconds.

Withtheengineidleorthe

vehiclestationary,itisnor-

maltohearahigh-pitched

whistling noise and to

noticesomesmoke /emis-

sions.

stopping the heating

Press button 5.

The warning lamp 8 and the screen

103

go out.

PROGRAMMABLe He ATING

iii

Delayed start-up

reading the time

Press button 2 or button 7 to dis-

play the time.

When the heating mode is acti-

vated, the remaining operating time

is displayed in place of the time.

Press button 3 then buttons 2 or 7

in the next ꢀ0 seconds, until the

desired start-up time is displayed.

Note : Before programming the

delayed start-up of the heating,

you must ensure that the clock is

set to the correct time.

note : if you wish to recall the other

stored times, press several times on

button 3 in the next ꢀ0 seconds until

the desired programme number is

displayed.

setting the time

Programming the start-up time

start-up may be programmed

between ꢀ minute and ꢁ4 hours in

advance.

you can store up to 3 different start-

up times, but programme only ꢀ

delayed start-up time.

Hold button 3 down and press but-

ton 2 or button 7. Release button 3,

the time is displayed and symbol 6

ﬂashes.

Use the two adjustment buttons 2

(to go forward) or 7 (to go back)

until the correct time is displayed.

Cancelling the programmed time

To cancel the programmed start-up

time, press brieﬂy on button 3.

Factory settings a :

Holding these buttons down will

make the numbers displayed scroll

more quickly.

•

Time 1 : 06:00.

Time 2 : ꢀ6:00.

Time 3 : ꢁꢁ:00.

Note : In the event of a battery

failure, the factory settings are

restored.

Note : The factory settings are

replaced once you adjust them.

The programmed times are stored

until they are re-programmed.

10ꢀ

PROGRAMMABLe He ATING

Note :

•

The pre-selected start-up time

can be modiﬁed or cancelled by

following the instructions previ-

ously given above.

iii

•

In the event of a battery discon-

nection, the programmer must

be re-set (hours, minutes etc.)

ꢀ

selection and activation of a

programmed time

adjusting the operating

duration

always switch off the additional

heating when filling up with

fuel, to prevent any risk of ﬁre

or explosion.

To avoid any risk of intoxica-

tion or asphyxiation, the addi-

tional heating must not be used,

even for short periods, in an

enclosed area such as a garage

or workshop not equipped with

a system for the extraction of

exhaust gases.

Press button 3 and hold it down.

Press button 2 or 7 at the same

time. Release button 3. The time

and symbol 6 are displayed.

Press again on button 3 and hold

it down. Press button 2 or 7 at the

same time. Release button 3. The

operating duration and symbol 8 is

displayed.

Press button 3 until the programme

number corresponding to the

required programmed time is dis-

played. The chosen pre-selected

time is automatically activated

after ꢀ0 seconds if no other but-

tons have been pressed.

To conﬁrm that the mode is acti-

vated, symbols ꢀ and 8 ﬂash until

the heating starts up.

Adjust the operating duration with

button 2 or 7.

Note : The operating duration is

memorised when the time indicated

disappears or by pressing button 3.

When the heating starts up, the

warning lamp 9 lights up on the

dashboard and the programmer

screen.

Do not park the vehicle over

inﬂammable materials (e.g. dry

grass, dead leaves or paper) as

this could present a ﬁre risk.

The programmable heating sys-

tem is supplied by the vehicle’s

fuel tank. Before use, ensure

that the remaining fuel level is

sufﬁcient. If you are using the

reserve fuel tank, we strongly

advise you not to use the pro-

grammable heating system.

adjusting the remaining

operating duration

When heating mode is activated,

the remaining operating time can

be modiﬁed within the range of 10

to 60 minutes using buttons 2 or 7.

105

Comfort -> Programmable heating for Your Citroen C5 Suv First Generation (2001-2008)

Related Topics

Comfort

Popular Owner Manuals

Latest Owner Manuals