Advertisement

Advertisement

Driving -> Reversing camera for Your Citroen Spacetourer Van First Generation (2019-2024)

Driving  
The rear parking sensors system will  
-
A front or rear impact to the vehicle can  
distort the settings of the sensors, which is  
not always detected by the system: distance  
measurements may be incorrect.  
The tilting of the vehicle if the boot is  
very loaded can affect the distance  
measurements.  
The sensors may be affected by poor  
weather conditions (heavy rain, thick fog,  
snowfall, etc.).  
In bad or wintry weather, ensure that the  
sensors are not covered by mud, ice or  
snow.  
When reverse gear is engaged, an audible  
signal (long beep) indicates that the  
sensors may be dirty.  
Certain sound sources (motorcycle,  
lorry, pneumatic drill, etc.) may trigger  
the audible signals of the parking sensor  
system.  
be deactivated automatically if a trailer  
or bicycle carrier is connected to  
a towing device installed in line with the  
manufacturer's recommendations.  
In this case, the outline of a trailer is  
displayed at the rear of the image of the  
vehicle.  
-
-
The parking sensors are deactivated while the  
Park Assist system is measuring a space.  
For more information on the Park Assist, refer  
to the corresponding section.  
High pressure jet wash  
When washing your vehicle, direct the  
lance at least 30 cm away from the  
sensors.  
Operating fault  
If the system fails, when reverse  
Operating limits  
gear is engaged this warning lamp  
flashes for a few seconds before  
lighting up continuously, together  
with the Service warning lamp.  
-
Certain obstacles located in the sensors'  
blind spots may not be detected or no  
longer be detected during the manoeuvre.  
Sounds such as those emitted by noisy  
vehicles and machinery (e.g. lorries,  
pneumatic drills, etc.) may interfere with the  
vehicle's sensors.  
Reversing camera  
-
A message appears, accompanied by an  
audible signal.  
Contact a CITROËN dealer or a qualified  
workshop.  
-
-
Certain materials (fabrics) absorb sound  
waves: pedestrians may not be detected.  
Accumulated snow or dead leaves on the  
road surface can interfere with the vehicle's  
sensors.  
The reversing camera is activated automatically  
when reverse gear is engaged.  
178  
Driving  
Depending on version, the image is displayed  
on the touch screen or the instrument panel.  
The blue lines 1 represent the general direction  
of the vehicle (the gap represents the width of  
your vehicle except for the door mirrors).  
The red line 2 represents a distance of about  
30 cm beyond the edge of your vehicle's rear  
bumper.  
Vision 360  
The reversing camera function may be  
supplemented with parking sensors.  
The green lines 3 represent distances of about  
one and two metres beyond the edge of your  
vehicle's rear bumper.  
The reversing camera cannot, in any circumstances,  
replace the need for vigilance on the part of the driver.  
The turquoise blue curves 4 represent the  
maximum turning circle.  
This system allows the near surroundings of  
the vehicle to be viewed in the instrument panel  
using cameras.  
Opening the tailgate causes the display to  
disappear.  
They are situated at the front and rear of the  
vehicle, as well as under the door mirrors.  
Depending on the angle of view chosen (front  
view, rear view or 360° panoramic view), the  
Vision 360 system provides a specific visual aid  
in particular driving conditions, such as when  
entering a blind crossroads or manoeuvring in  
areas with reduced visibility.  
Clean the reversing camera regularly  
using a soft, dry cloth.  
The representation with overlaid lines helps the  
manoeuvre.  
6
High pressure jet wash  
When washing your vehicle, do not direct  
the lance from less than 30 cm from the  
lens of the camera.  
They are represented by lines marked  
"on the ground" and do not allow you to  
determine the position of tall obstacles (for  
example: other vehicles, etc.) relative to  
the vehicle.  
Once activated, this function is operational up  
to 9 mph (15 km/h). Above 19 mph (30 km/h),  
the system deactivates automatically.  
Some distortion of the image is normal.  
It is normal to have a part of the number  
plate showing in the bottom of the screen.  
179