Advertisement

Advertisement

Driving -> Starting/switching off the engine with Keyless Entry and Starting for Your Citroen Spacetourer Van First Generation (2019-2024)

Driving  
F With an automatic gearbox, you should  
Starting/switching off the  
engine with Keyless Entry  
and Starting  
The Keyless Entry and Starting electronic  
key must be inside the vehicle.  
If the electronic key is not detected in this  
zone, a message is displayed.  
Move the electronic key into this zone so  
that the engine can be started.  
If there is still a problem, refer to the "Key  
not detected – Back-up starting" section.  
keep the brake pedal fully depressed and  
not press the "START/STOP" button again  
until the engine is running.  
If one of the starting conditions is not met,  
a reminder message is displayed in the  
instrument panel.  
In some circumstances, it is necessary to turn  
the steering wheel slightly while pressing the  
"START/STOP" button to assist unlocking of  
the steering column.  
Starting the engine  
F Press the "START/STOP" button while  
maintaining pressure on the pedal until the  
engine starts.  
The steering column unlocks and the engine  
starts.  
On certain versions with the automatic gearbox  
(EAT6/EAT8), the steering column does not  
lock.  
With petrol engines, after a cold start,  
preheating the catalytic converter can  
cause noticeable engine vibrations for  
up to 2 minutes while stationary with the  
engine running (accelerated idle speed).  
F With a manual gearbox, put the gear lever  
into neutral.  
F With the electronic key inside the vehicle,  
fully depress the clutch pedal.  
or  
F With an automatic gearbox, place the gear  
selector in mode P or N.  
6
For Diesel engines, when the temperature is  
negative and/or the engine is cold, the start  
will only take place once the preheater warning  
lamp is off.  
As a safety measure, never leave the  
vehicle while the engine is running.  
F With the electronic key inside the vehicle,  
press the brake pedal.  
If this warning lamp comes on after  
pressing the "START/STOP" button:  
Switching off the engine  
F Immobilise the vehicle, engine at idle.  
F With a manual gearbox, preferably put the  
gear lever into neutral.  
F With a manual gearbox, you should keep  
the clutch pedal fully depressed and not  
press the "START/STOP" button again until  
the engine is running.  
129  
Driving  
F With an automatic gearbox, preferably  
select mode P or N.  
Back-up switch-off  
Key not detected  
Back-up starting  
F With the electronic key inside the vehicle,  
press the "START/STOP" button.  
The engine stops and the steering column  
locks.  
In some circumstances, it is necessary to turn  
the steering wheel to lock the steering column.  
On certain versions with the automatic gearbox  
(EAT6/EAT8), the steering column does not  
lock, but the gearbox locks in mode P.  
When the electronic key is not detected or is  
no longer in the recognition zone, a message  
appears in the instrument panel when closing  
a door or trying to switch off the engine.  
When the electronic key is in the recognition  
zone and after pressing the "START/STOP"  
button, the engine does not start:  
F Place the gear selector at P or N for  
vehicles with an automatic gearbox or  
neutral for vehicles with a manual gearbox.  
F Place the electronic key in the back-up  
reader.  
F Press the brake pedal on vehicles with an  
automatic gearbox, or fully depress the  
clutch pedal with a manual gearbox.  
F Press the "START/STOP" button.  
The engine starts.  
If the vehicle is not immobilised, the  
engine will not stop.  
F To confirm the instruction to switch off the  
engine, press the "START/STOP" button for  
about three seconds.  
Never leave your vehicle with the  
electronic key still inside.  
In the event of a fault with the electronic key,  
contact a CITROËN dealer or a qualified  
workshop.  
Switching off the engine leads to a loss of  
braking assistance.  
Emergency switch-off  
In the event of an emergency only, the engine  
can be switched off without conditions (even  
when driving).  
Press the "START/STOP" button for about  
three seconds.  
In this case, the steering column locks as soon  
as the vehicle stops.  
130  
Driving  
On certain versions with the automatic gearbox  
(EAT6/EAT8), the steering column does not  
lock.  
It goes off to confirm the release of the parking  
brake.  
Electric parking brake  
The indicator lamp in the control lever flashes  
during manual application or release.  
After applying the parking brake, the  
simultaneous flashing of the indicator lamps  
in the instrument panel and in the control lever  
warns you to secure the immobilisation of the  
vehicle by engaging a gear (with a manual  
gearbox or by placing the selector at position  
P with an automatic gearbox or by placing  
a chock against one of the wheels (e.g. parking  
on a very steep slope or a steep slope with  
a weak battery).  
Switching the ignition on  
(without starting)  
With the electronic key in the reader or the  
Keyless Entry and Starting key inside the  
vehicle, pressing the "START/STOP" button,  
with no action on the pedals, allows the  
ignition to be switched on.  
The system provides, in automatic operation,  
the application of the parking brake on  
switching off the engine and release as the  
vehicle moves off.  
The driver can take over at any time to apply  
or release the parking brake, by operating the  
control lever:  
F Press the "START/STOP" button, the  
instrument panel comes on but the engine  
does not start.  
F Press the button again to switch off the  
ignition and allow the vehicle to be locked.  
-
by briefly pulling the control lever to apply  
the brake,  
-
by briefly pushing the control lever, while  
pressing the brake pedal, to release it.  
In the event of a battery failure, the  
electric parking brake no longer works.  
As a safety measure, if the parking brake  
is not applied, immobilise the vehicle by  
engaging a gear (with a manual gearbox)  
or placing a chock against one of the  
wheels.  
Automatic mode is activated by default.  
6
With the ignition on, the system  
automatically changes to energy economy  
mode when required to maintain an  
adequate state of charge of the battery.  
The technology adopted for the electric  
parking brake does not allow the fitment of  
15-inch wheels.  
Call a CITROËN dealer or a qualified  
workshop.  
Indicator lamp  
This indicator lamp comes on in the  
instrument panel and in the control  
lever to confirm the application of  
the parking brake.  
131