Advertisement

Advertisement

Practical information -> Changing a wiper blade for Your Citroen Spacetourer Van First Generation (2019-2024)

Practical information  
Load reduction mode  
System which manages the use of certain  
functions according to the level of charge  
remaining in the battery.  
Changing a wiper blade  
Before removing a front  
wiper blade  
If a telephone call is being made at this  
time, it will be maintained for around  
10 minutes with the Bluetooth hands-free  
system of your audio system.  
When the vehicle is being driven, the load  
reduction function temporarily deactivates  
certain functions, such as air conditioning,  
heated rear screen, etc.  
Exiting the mode  
These functions will be automatically restored  
The deactivated functions are reactivated  
automatically as soon as conditions permit.  
the next time the vehicle is used.  
In order to restore the use of these functions  
immediately, start the engine and let it run:  
-
for less than ten minutes, to use the  
equipment for approximately five minutes,  
for more than ten minutes, to use the  
equipment for up to approximately thirty  
minutes.  
Energy economy mode  
System which manages the duration of use of  
certain functions to conserve a sufficient level  
of charge in the battery.  
F Within one minute after switching off the  
ignition, operate the wiper control stalk to  
position the wiper blades vertically on the  
windscreen.  
-
After the engine has stopped, you can  
still use functions such as the audio and  
telematics system, windscreen wipers, dipped  
beam headlamps, courtesy lamps, etc. for  
a maximum combined duration of about forty  
minutes.  
Let the engine run for the duration specified to  
ensure that the battery charge is sufficient.  
Do not repeatedly and continuously restart the  
engine in order to charge the battery.  
or  
F More than one minute after switching off the  
ignition, straighten the arms manually.  
Removing  
F Lift the corresponding wiper arm.  
F Unclip the wiper blade and remove it.  
7
Switching to this mode  
A message appears in the instrument panel  
screen indicating that the vehicle has switched  
to economy mode and the active functions are  
put on standby.  
A flat battery prevents the engine from  
starting.  
For more information on the 12 V battery,  
refer to the corresponding section.  
Refitting  
F Position and clip the new wiper blade to the  
arm.  
F Fold down the wiper arm carefully.  
195  
Practical information  
After refitting a front wiper  
blade  
Version without longitudinal Version with longitudinal  
bars  
bars  
F Switch on the ignition.  
F Operate the wiper control stalk again to  
park the wiper blades.  
The replacement of wiper arms should be  
carried out only by a CITROËN dealer or  
a qualified workshop.  
Roof bars  
When fitting roof bars, use only the four fixing  
points located on the roof frame. These points  
are masked by the vehicle doors when closed.  
The roof bar fixings include a stud which should  
be fitted to the opening in each fixing point.  
As a safety measure and to avoid  
damaging the roof, it is essential to use  
the transverse bars approved for your  
vehicle.  
You must fit the transverse bars to the  
longitudinal bars at the fixing points indicated  
by engraved markings on the longitudinal bars.  
Observe the fitting instructions and the  
conditions of use in the user guide supplied  
with the bars.  
Recommendations  
F Distribute the load evenly, avoiding  
overloading on one side.  
F Arrange the heaviest part of the load as  
close as possible to the roof.  
F Secure the load firmly and fit a warning flag  
if it overhangs the vehicle.  
F Drive gently: the vehicle will be more  
susceptible to the effects of side winds (the  
stability of the vehicle may be affected).  
F Remove the roof bars once they are no  
longer needed.  
196