2002-2008 Cupra Born SUV Driving -> Gear selection User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Driving -> Gear selection for Your Cupra Born SUV First Generation (2002-2008)

Driving  
A message to this eꢀect is displayed in the Dig-  
ital Cockpit.  
e-Sound does not work  
Gear selection  
The control lamp lights up yellow and an audio  
signal sounds.  
There is a fault in the electric drive system or  
the high-voltage on-board network.  
Gear selector  
A message to this eꢀect is displayed in the Dig-  
ital Cockpit.  
●
Go immediately to a specialised workshop  
and request the electric drive system be  
checked.  
●
Contact a specialised workshop.  
It is possible to continue driving.  
It is possible to continue driving.  
The drive system cannot be connected  
The vehicle key is not recognized  
If an unauthorised vehicle key is used or there  
is a fault in the system, a message to this eꢀect  
is displayed in the Digital Cockpit.  
A message to this eꢀect is displayed in the Dig-  
ital Cockpit.  
If the vehicle key’s button battery is almost or  
fully run out, the key may not be recognized.  
●
●
Use an authorised key.  
Fig. 116 Gear selector with the electronic  
parking brake button.  
If the fault persists, seek specialist assistance.  
An emergency start must be performed:  
●
Place the vehicle key on the base of the cen-  
The vehicle has a forward gear D/B and a re-  
verse gear R.  
tral armrest drawer, as close to the  
as possible.  
symbol  
The gear selector has a button for the elec-  
tronic parking brake. To change from neutral  
N to another position, switch on the ignition,  
depress the brake pedal and turn the selector  
●
Depress the brake pedal or press the igni-  
tion/start button.  
●
The ignition is switched on.  
in the desired direction ››› Fig. 116 (arrow):  
The drive system cannot be switched oꢀ  
An emergency disconnection must be per-  
formed:  
– Permanent forward drive position  
The electric drive system is in the normal  
program (automatic brake energy recupera-  
tion when the eco-eꢀicient driving assistant is  
switched on ››› page 142).  
●
●
Stop the vehicle.  
Press the ignition/start button twice within a  
few seconds, or press and hold it once.  
●
The drive and ignition system switches oꢀ.  
146  
Gear selection  
Stop and start moving uphill  
●
When the TCS is switched oꢀ, the drive  
– Intense braking energy recuperation  
wheels may skid, especially if the road is wet,  
slippery or dirty. This can cause the vehicle to  
be neither steered nor controlled.  
You should use the Auto-Hold function when  
the vehicle's drive system is switched on and  
you stop the vehicle or start driving uphill  
Intense recuperation of braking energy during  
deceleration phases ››› page 142.  
››› page 188.  
– Change between D and B  
WARNING  
When stopping uphill with a gear selected,  
always prevent the vehicle from rolling back-  
wards by depressing the brake pedal or apply-  
ing the electronic parking brake. Do not re-  
lease the brake pedal until you want to move  
oꢀ.  
Change between D and B by turning the  
gear selector forwards one position from D/B  
If the vehicle is left unattended with the drive  
system connected, accidents and serious in-  
juries can occur.  
››› Fig. 116. The selector always returns to  
the initial position. Turning it forwards again  
changes back to D.  
●
Never leave the vehicle unattended with  
the drive system connected.  
●
Always switch oꢀ the ignition. When doing  
– Electronic parking brake  
WARNING  
so, the electronic parking brake is applied  
automatically.  
The drive wheels are locked mechanically.  
Only apply it when the vehicle is stationary  
››› page 187.  
If the wrong gear position is selected, control  
of the vehicle may be lost, resulting in an ac-  
cident and serious injury.  
●
When parking or leaving the vehicle, always  
check that the electronic parking brake is  
applied.  
●
Never accelerate when selecting a gear po-  
sition.  
●
When leaving the vehicle, always make sure  
– Neutral  
that all the doors, windows, rear lid and bon-  
net are fully closed and locked.  
The electric drive system is in the neutral  
position. No movement is transmitted to the  
wheels and the braking eꢀect of the electric  
engine does not occur.  
WARNING  
●
When the drive system is switched on and  
gear position D/B or R is selected, the vehicle  
should be stopped by depressing the brake  
pedal.  
Rapid acceleration can cause loss of traction  
and the vehicle skidding, especially on slip-  
pery roads. This could cause loss of control of  
the vehicle, accidents and serious injury.  
●
Never engage reverse gear while the vehi-  
– Reverse gear  
cle is in motion.  
●
Only accelerate quickly if visibility,  
Reverse gear is selected. Only select this posi-  
tion only when the vehicle is stationary.  
weather, road and traꢀic conditions permit,  
and if your vehicle’s deceleration behaviour  
and driving style do not endanger other road  
users.  
Driving down slopes  
When driving downhill, the braking energy re-  
cuperation should be activated whenever pos-  
●
Always adapt the driving style to traꢀic  
conditions.  
sible ››› page 142.  
147  

Related Topics

Popular Owner Manuals