2002-2008 Cupra Born SUV High-voltage battery -> Charging cable User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

High-voltage battery -> Charging cable for Your Cupra Born SUV First Generation (2002-2008)

Chargingcable
The charging or discharging process starts  
automatically.  
Functionality  
Note  
The home energy management system con-  
trols the high-voltage battery charging or dis-  
charging process, as necessary.  
Depending on the power supplied by the so-  
lar installation and the household's instan-  
taneous electricity consumption, the charg-  
ing process may start earlier than usual and  
continue later. If necessary, the vehicle au-  
tomatically regulates the available charging  
phases for safety reasons.  
2. Check the desired battery charge level in  
the charging routine proꢁle.  
In the Infotainment system you can choose  
between the charging modes Bi-directional  
charging (charging and discharging) and dis-  
charging (discharging only) of the high-volt-  
age battery.  
Note  
●
It can read the amount of power drawn  
from the home energy management system.  
The vehicle discharges with a maximum  
power of around 10kW.  
Current monitor  
To limit the energy transferred, set the battery  
charge levels in the Infotainment system. The  
lower battery charge level is limited to 20% for  
technical reasons.  
●
The use of the function is limited to avoid  
The instantaneous current ꢀow in the home  
is monitored. Before overloading the house’s  
power grid, the vehicle automatically reduces  
the charging current.  
excessive wear of the high voltage battery.  
When the maximum values on the operat-  
ing hours meter (4,000 h) and energy quan-  
tity meter (10,000 kWh) have been reached  
in the Settingsmenu, contact the technical  
service.  
It is not possible to schedule a charge for a  
departure time.  
In addition, the home energy management  
system can use electricity from the high-volt-  
age battery in the event of a power failure or to  
power a home without a grid connection.  
Bidirectional Charging  
Prerequisites  
Charging cable  
●
●
Vehicle with 77 kWh net battery capacity.  
Compatible home energy management sys-  
tem (HEMS) and two-directional DC charging  
station.  
Introduction  
Note  
Read and follow the home energy manage-  
ment system’s user and operating manual.  
The type of charging cable supplied with the  
vehicle depends on the delivery volume and  
the speciꢁc technical speciꢁcations of each  
country, e.g. charging connector connections  
for power sockets.  
●
A charging location (Routine) has been cre-  
ated in the Infotainment system.  
Selecting the charging mode  
Note  
1. Press the drop-down list of charging  
CUPRA recommends exclusively using the  
supplied charging cable.  
modes and select Bi-directional Charging  
or Discharging ››› page 81.  
Ask specialist personnel for conꢀrmation  
about a suitable home energy management  
system. It is recommended to use a CUPRA  
partner.  
85  
High-voltage battery  
WARNING  
Notes on the charging cable  
WARNING  
●
●
●
●
●
●
●
Handle with care.  
Items that are not secured, or incorrectly se-  
cured can cause serious injury during sudden  
manoeuvres or braking, or in the event of an  
accident.  
The charging cable for electrical sockets  
must always be connected directly to an  
electrical socket. Failure to do so could result  
in ꢀre damage and damage to the charging  
cable or home electrical installation.  
Unroll and roll fully.  
Do not twist or bend it over sharp edges.  
Do not crush it or drive the vehicle over it.  
Always unplug it by pulling on the connector.  
Children should not use the charging cable.  
Keep animals away from the charging cable.  
After use, store it safely and without twisting  
●
Store the charging cable securely in the  
●
luggage compartment.  
Never connect the charging cable to an  
extension lead, cable reel, power strip or  
adapter or timer.  
●
Use the organizer/protective cover provi-  
ded with the cable for this purpose.  
●
it.  
WARNING  
WARNING  
The high voltage system voltage is dangerous  
and can cause burns, other injuries and fatal  
electric shocks.  
Using a charging cable that has been dam-  
aged or tampered with can cause serious in-  
jury and fatal electric shocks.  
Notes on charging connectors and the  
charging cable protection device  
●
Only clean the charging cable when it is  
●
Do not touch the charging connector’s con-  
●
Before each use check that the connectors  
unplugged.  
tacts.  
and the charging cable are undamaged, e.g.  
check for cracks.  
●
Protect from strong sunlight (outside tem-  
●
Never disassemble the charging cable or its  
peratures no higher than 50°C or 122°F).  
NOTICE  
components.  
●
●
Do not drop them.  
Seek information regarding the appropriate  
charging cable and the maximum permitted  
charging current before travelling abroad. If  
possible, use the charging cable supplied in  
the country in question.  
●
Never use a charging cable that is damaged  
Protect from immersion in ꢀuids such as rain  
or has been tampered with.  
water.  
●
If the charging cable does not work cor-  
●
Fit the protective caps after each use.  
rect, get a specialised CUPRA dealer or any  
SEAT dealership to look at it.  
Cleaning the charging cable  
NOTICE  
Clean the surface of the charging cable with a  
The charging cable, as portable electrical  
equipment, may have to be checked periodi-  
cally. This requires a test adapter.  
dry or slightly damp cloth ››› , ›››  
.
86  
Chargingcable
Charging cable for alternating cur-  
rent (AC) charging stations  
NOTICE  
NOTICE  
The charging cable can be damaged if not  
cleaned properly.  
Follow the manufacturer’s instructions and  
indications when using the charging station.  
●
Only water should be used for this pur-  
pose, and never additional cleaning prod-  
ucts.  
Note  
Charging with a charging cable for 16 A is  
not possible at some charging stations that  
support 32 A. This depends on the charging  
station’s equipment.  
●
Water should be prevented from getting  
into the contacts.  
For the sake of the environment  
●
Before charging the vehicle, ꢀnd out about  
the available charging technology.  
Charging cables must be disposed of in an  
environmentally friendly way and should not  
be thrown in the household waste.  
Fig. 75 Charging cable for alternating  
current (AC) charging stations.  
Charging cable for power sockets  
Note  
The maximum charging current is 16 or 32  
amps, depending on the vehicle’s features and  
The maximum charging capacity of the  
safety circuit that is used must be observed.  
If the charging cable is planned into an elec-  
trical socket on the same circuit as other  
consumers, the circuit's fuses may trip.  
the charging cable that is supplied ›››  
.
WARNING  
Charging the high-voltage battery with an in-  
appropriate charging cable could cause short  
circuits, serious injuries and fatal electrical  
shocks.  
Fig. 76 Charging cable for electrical  
sockets  
WARNING  
The charging cable should not be used as an  
extension lead. The charging process could  
be aꢁected.  
87  
High-voltage battery  
If the local mains supply does not allow charg-  
ing at the maximum charging current, the  
charging current can be reduced, depending  
on the charging setting features in the infotain-  
Self-check  
When the charging cable is plugged into the  
electrical socket, the protective device au-  
tomatically performs a self-test. During this  
check, all warning and indicator lamps turn on  
brieꢀy and go out one after the other. Upon  
completion, the operational status at that time  
is displayed.  
ment system ››› page 84.  
Temperature control  
The charging cable temperature control  
switches on when the charging cable over-  
heats, such as when it has been stored in a lug-  
gage compartment exposed to high tempera-  
tures or strong sunlight.  
Operating displays  
Fig. 77 On the charging cable for power  
sockets: Indicator lamps on the protection  
device.  
1
2
One or more control lamps ››› Fig. 77  
,
3
or  
light up green.  
Meaning  
Display ››› Fig. 77  
Meaning  
The charging cable is  
Display ››› Fig. 77  
››› Fig. 77:  
1
4
,
ꢀashing  
The housing connector  
has overheated.  
1
ignition  
1
Indicator lamp of the connector and the  
plugged into the mains  
power supply.  
2
4
,
ꢀashing  
The protection device  
has overheated.  
1
3
2
,
on,  
The high-voltage bat-  
tery is charging.  
2
3
Control lamp of the protection device  
Control lamp of the vehicle  
Failure warning lamp  
ꢀashes slowly  
If the charging process continues with a lower  
current, both the operating indicator and the  
››› page 88  
4
1
2
3
and  
on  
The charging process  
is complete. The high-  
voltage battery has  
charged.  
4
warning lamp ››› Fig. 77  
ꢀash red.  
Charging cable information  
●
Unplug the charging cable from the mains  
and wait for it to cool down.  
Before using the charging cable, also follow the  
instructions displayed on it and on the rear of  
the protective device.  
●
If it disconnects again, or the charging cur-  
rent reduces and the cause does not seem to  
be exposure to an external heat source, make  
sure that the green control lamp is ꢀashing  
››› Fig. 77. Visit a specialised CUPRA dealer or  
any SEAT network dealer to check the charg-  
ing cable. Get an establishment that special-  
ises in electrical installations to check the in-  
frastructure connection.  
Set the charging current  
The charging cable limits the charging current  
according to the available power supply.  
Protection device  
The electronic protection device ››› Fig. 77  
ensures that the charging connector does not  
receive current until it is plugged in to the vehi-  
cle's charging connector.  
88  
Chargingcable
Fault display  
4
If the red warning light  
ꢀashes or turns on  
without one of the indicator lamps ››› Fig. 77  
1
2
3
,
or  
also turning on continuously on  
the status indicator, there is a fault.  
Meaning  
Display ››› Fig. 77  
1
4
4
4
ꢀashing,  
or ꢀashing  
on  
on  
on  
Failure in the power  
supply.  
2
ꢀashing,  
or ꢀashing  
Failure in the protection  
device.  
3
ꢀashing,  
or ꢀashing  
Failure in the vehicle.  
The charging process pauses or is cancelled.  
●
Check the instructions located on the back  
of the protective devices.  
●
Seek professional assistance if the fault per-  
sists.  
Note  
If there is any other mains connection dur-  
ing the charging process, or if the vehicle is  
right next to the high voltage cables, charg-  
ing from an electrical socket is not possible in  
some cases. Additional mains connections:  
●
●
Connecting a 12 volt battery charger.  
Contact with a work tool connect to the  
mains, such as a vehicle lift.  
89  

Related Topics

Popular Owner Manuals