2002-2008 Cupra Born SUV Parking and manoeuvring -> Peripheral view system (Top View Camera) User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Parking and manoeuvring -> Peripheral view system (Top View Camera) for Your Cupra Born SUV First Generation (2002-2008)

Parking and manoeuvring  
Go to the selected parking space  
●
The camera is dirty ››› page 315. In addi-  
Peripheral view system  
(Top View Camera)  
tion to dirt and snow, camera visibility can be  
reduced by detergent residue or any type of  
coating.  
Centre the vehicle inside the parking  
space  
1
2
3
4
Road  
●
The system requirements must be met  
Introduction  
Parking space  
››› page 204.  
●
Using 4 cameras, the system generates a rep-  
resentation that is shown on the infotainment  
system display. The cameras are located on the  
radiator grille, the exterior mirrors and the rear  
lid.  
Lateral boundary of the parking space  
Rear boundary of the parking space  
The camera is covered with water.  
●
The vehicle has some type of damage in the  
camera area, e.g. due to a parking impact.  
Parking  
●
The ꢀeld of view of the camera is blocked by  
●
In the infotainment system select  
tants > Parking aid before passing in front of  
the selected parking space.  
> Assis-  
an accessory, e.g. a bicycle carrier system.  
The functions and representations of the Area  
View system may vary depending on whether  
or not the vehicle has ParkPilot.  
●
Changes have been made to the paint in the  
camera area, or structural modiꢀcations have  
been made to a component such as the run-  
ning gear.  
●
With reverse assist connected and in working  
order, press the function button  
.
WARNING  
●
Stop the vehicle in front of the parking space  
The image from the cameras does not make  
it possible to calculate the distance to the  
obstacles (people, vehicles, etc.) precisely,  
so using them could cause serious accidents  
and injury.  
Camera with no visibility, fault message, the  
system disconnects  
2
››› Fig. 152  
●
that the yellow lines enter the parking space.  
The green and yellow lines must match the  
side boundary lines  
.
Reverse while turning the steering wheel so  
●
Clean the camera or remove possible adhe-  
sives or accessories from it ››› page 315.  
●
The camera lenses augment and distort the  
3
.
●
Check for visible damage.  
visual ꢁeld and the objects on the screen are  
seen diꢀerently and imprecisely.  
●
Stop the vehicle when the red line has  
4
reached the rear boundary  
.
Possible solution  
●
Certain objects may not be shown or may  
●
●
Temporarily disconnect the system.  
not be shown very clearly, for example, posts  
or thin rails, due to the screen resolution or if  
light conditions are insuꢀicient.  
Troubleshooting  
Check if one of the causes indicated above  
has occurred.  
The system behaves diꢀerently than expec-  
ted  
●
The cameras have blind spots in which ob-  
●
Once the source of the problem has been  
stacles and people are not registered.  
eliminated, the system may be reconnected.  
There can be several causes:  
●
If the system still behaves unpredictably,  
have it checked by a specialised workshop.  
206  
Peripheralviewsystem(TopViewCamera)  
NOTICE  
A
B
C
D
Front camera area  
Right camera area  
Rear camera area  
Left camera area  
WARNING  
●
The smart technology incorporated into the  
Top View Camera system cannot overcome  
the limits imposed by the laws of physics  
and it only works within the limits of the sys-  
tem. The greater convenience provided by  
the Area View system should never tempt  
you to take any risk that may compromise  
safety. If used negligently or involuntarily,  
it may cause serious accidents and injuries.  
The system is not a replacement for driver  
awareness.  
The camera images are only two-dimen-  
sional. Due to a lack of spatial depth, objects  
that jut out or holes on the road, for exam-  
ple, are more diꢀicult to detect or may not be  
seen at all.  
Function buttons:  
●
In certain circumstances, the camera does  
Exit the current display.  
not capture objects such as beams, fences,  
posts or thin trees, which could damage the  
vehicle.  
Adjust the display: bright, contrast and  
colour.  
●
The system displays the auxiliary lines and  
boxes regardless of the vehicle's environ-  
ment, no objects are detected. The driver is  
responsible for determining that the vehicle  
will ꢁt in the parking space.  
Depending on the equipment: connect-  
ing and disconnecting the ParkPilot  
sound.  
●
Adapt your speed and driving style to  
suit visibility, weather, road and traꢀic condi-  
tions.  
●
Do not be distracted from the traꢀic by  
The aerial view is generated by combining the  
looking at the screen.  
images from all the cameras ››› Fig. 153.  
The top view can be selected by pressing the  
vehicle inside the zone.  
Area View system  
●
Monitor the area around the vehicle at  
all times, since the cameras do not capture  
small children, animals and certain objects in  
all situations.  
The system will automatically switch between  
front and rear camera view according to the  
direction of travel.  
●
The system will probably be unable to rep-  
resent all areas clearly.  
A
Press on the diꢁerent areas ››› Fig. 153  
to  
D
of the top view or reduced top view to select  
and set the corresponding view, which will be  
highlighted in orange.  
Fig. 153 Display of the Area View system:  
aerial view.  
There are four diꢁerent views to choose from  
››› Fig. 153:  
207  
Parking and manoeuvring  
●
On moving from a horizontal plane to a  
Conditions necessary for the use of the Area  
View system  
Views of the peripheral vision sys-  
tem (modes)  
slope.  
●
On moving from a slope to a horizontal  
●
●
The doors and the rear lid must be closed.  
The image must be reliable and clear. For this  
The red lines are indicate a distance of approx.  
40 cm away from the vehicle.  
plane.  
●
●
If the vehicle is heavily loaded at the rear.  
If the vehicle approaches protruding objects.  
reason, for example, the camera lens must be  
clean.  
Aerial views (bird's eye view)  
These objects may be outside the cameras'  
angle of visibility.  
●
The area around the vehicle must be clearly  
Main mode:  
and totally visible.  
The vehicle and its immediate vicinity  
seen from above are shown. Depending  
on the equipment, the ParkPilot's path  
may also be displayed.  
●
The area for parking or manoeuvring should  
Note  
be a ꢂat surface.  
●
The vehicle should not be loaded very heav-  
To become familiar with the system and  
its functions, CUPRA recommends that you  
practice handling the Area View system in an  
area where there is not too much traꢀic or in  
a car park.  
ily at the rear.  
●
●
The driver must be used to the system.  
Front camera views (front view)  
There should be no damage to the vehicle in  
Cross traꢀic.  
the camera area. If the position or installation  
angle of the cameras have been changed, e.g.  
after a rear-end collision, the system should be  
checked by a specialised workshop.  
This visualization helps to monitor traꢁic  
to the left, front and right of the vehicle  
and can be used, for example, when ex-  
iting garages or narrow exits  
Connecting and disconnecting  
Connecting  
Angle parking.  
Special characteristics  
●
●
Select reverse gear.  
The area in front of the vehicle is shown.  
Orientation lines are shown to give guid-  
ance.  
The images on the area view system cameras  
are only two-dimensional. Due to a lack of spa-  
tial depth, it is diꢁicult or impossible to make  
out on-screen any holes there may be on the  
ground, objects jutting out from the ground or  
parts protruding from other vehicles.  
OR: in the infotainment system select  
>
Assistants > Parking assistant > Park assist.  
Switching oꢀ  
Side camera views (side view)  
●
Drive forward at a speed of at least 15 km/h  
Right and left sides.  
(9 mph).  
Situations in which the objects or other vehi-  
cles appear to be further away or closer than  
they really are:  
The areas located directly to the side of  
the vehicle seen from above are repre-  
sented in order to navigate possible ob-  
stacles more precisely.  
●
OR: press the function button.  
208  

Related Topics

Popular Owner Manuals