2024-2026 Cupra Terramar SUV Miscellaneous situations -> Fuses User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Miscellaneous situations -> Fuses for Your Cupra Terramar SUV First Generation (2024-2026)

346
Miscellaneous situations
Rear towline anchorage
Fig.215 Rear bumper on right: remove the
lid.
Fig.216 Right side of the rear bumper:
towline anchorage screwed in.
The housing of the screw towing eye is on
the right side of the rear bumper behind a lid
›››
Fig.215.
Vehicles tted as standard with a towing
bracket do not have any housing for the screw
towing eye behind the lid. In this case, the tow
hitch needs to be extracted or installed and
used for towing ›››
page322 , ››› .
Bear in mind the instructions for towing
›››page344.
Assemble the rear towing eye (cars without a
factory-equipped towing bracket)
●
Remove the towing eye from the vehicle tool
kit in the luggage compartment ›››page338.
●
Press the upper side of the lid ›››Fig.215 to
unclip it.
●
Remove the lid and let it hang from the vehi-
cle.
●
Screw the towing eye in the housing by
turning it to the maximum anticlockwise
›››Fig.216 , ››› . Use a suitable object
that can completely and securely tighten the
towing eye in its housing.
●
After towing, unscrew the towing eye clock-
wise with a suitable object.
●
Replace the cover and press until the tab
snaps into the bumper.
●
Clean the towing eye if necessary and then
store it in the luggage compartment along with
the other vehicle tools.
NOTICE
●
The towing eye must always be completely
and rmly tightened. Otherwise, it could be
released while towing and tow-starting.
●
If the vehicle is factory-equipped with a
towing bracket, it is only allowed to tow with a
tow bar if this has been specially designed to
be installed with a tow hitch. If an unsuitable
tow bar is used, both the tow hitch and the
vehicle may be damaged. Instead, a tow rope
should be used.
Fuses
Introduction
In general, a fuse can be assigned to various
electrical components. Likewise, an electrical
component can be protected by several fuses.
Only replace fuses when the cause of the
problem has been solved. If a newly inserted
fuse blows after a short time, you must have
the electrical system checked by a specialised
workshop as soon as possible.
Miscellaneous situations
347
Fuses
WARNING
The high voltages in the electrical system can
give serious electrical shocks, causing burns
and even death!
●
Never touch the electrical wiring of the ig-
nition system.
●
Take care not to cause short circuits in the
electrical system.
WARNING
Using unsuitable fuses, repairing fuses or t-
ting jumpers on a live circuit without fuses
can cause a re and serious injury.
●
Never use a fuse with a higher value. Only
replace fuses with a fuse of the same amper-
age (same colour and markings) and size.
●
Never replace a fuse with a metal strip, sta-
ple or similar.
NOTICE
●
To prevent damage to the vehicle’s elec-
trical system, before replacing a fuse always
turn o the ignition, the lights and all electri-
cal components.
●
Protect the fuse boxes when open to pre-
vent the entry of dust or humidity as they can
damage the electrical system.
Note
In the vehicle, there are more fuses than
those indicated in this chapter. These should
only be replaced by a specialist workshop.
Fuses inside the vehicle
Fig.217 On the dashboard on the driver
side: lid of the fuse box.
Fig.218 Right-hand drive vehicles: fuse box
behind the glove box on the passenger side.
Left-hand drive vehicles: open the fuse box
cover under the dash panel
●
Grasp the back of the cover and remove it in
the direction of the arrow ›››Fig.217.
●
To t the cover, place it on the opposite side
and close it in the opposite direction to the
arrow until it audibly clicks into place.
Right-hand drive vehicles: opening the fuse
box inside the glove compartment
●
Open the glove compartment and, if neces-
sary, empty it.
●
Remove the cover from above ›››Fig.218
1
.
●
To t the cover, put it in place and snap on
the top. Close the glove compartment.
348
Miscellaneous situations
Identifying fuses below the dash panel by
colours
Colour
Current intensity in
amps
Light brown 5
Brown 7.5
Red 10
Blue 15
Yellow 20
White or transpar-
ent
25
Green 30
Orange 40
Red 50
NOTICE
●
Always carefully remove the fuse box cov-
ers and ret them correctly to avoid prob-
lems with your vehicle.
●
Protect the fuse boxes when open to avoid
the entry of dust or humidity. Dirt and hu-
midity inside fuse boxes can cause damage to
the electrical system.
Fuses in the engine compartment
Fig.219 In the engine compartment: lid of
the fuse box.
To open the engine compartment fuse box
●
Raise the bonnet ››› on page351.
●
Press the locking tabs to unlock the fuse box
cover ›››Fig.219.
●
Then lift the cover out.
●
To t the cover, place it on the fuse box.
Push the locking tabs down until they click au-
dibly into place.
Replace a blown fuse
Fig.220 Image of a blown fuse.
Preparations
●
Switch o the ignition, lights and all electrical
equipment.
●
Open the corresponding fuse box
›››page347, ›››page348.
Recognise a blown fuse
A blown fuse can be recognised if the metal
strip is melted ›››Fig.220.
●
Point a torch at the fuse to see if it has blown.
Miscellaneous situations
349
Fuses
To replace a fuse
●
Remove the fuse.
●
Replace the blown fuse with one with an
identical amperage rating (same colour and
markings) and identical size.
●
Replace the cover again or close the fuse box
lid.
Fuse placement
Fuses in the vehicle interior
No. Consumers/Amps
3 Trailer 25
5 Parking lock 25
6
On-board network control
unit
30
7 Air conditioning 30
8 Sunroof 25
9 Left door (front and rear) 30
10 USBs 10
11 Trailer 15
12
On-board network control
unit
40
13
On-board network control
unit
40
14 External Ethernet Amplier 40
16 Airbag 7.5
No. Consumers/Amps
18
Anti-theft control unit /
KESSY
7.5
19
Dash panel / Navigation sys-
tem interface (OCUA)
7.5
20 Phone 10
21
Rear Camera, IPA / Sur-
roundings camera / Parking
assistants / Rear bumper /
Internet connection
7.5
22
Interior rear-view mirror /
Interior mirror / Front and
forward camera / Front ra-
dars
7.5
23 Passenger seat 15
24 4x4 Haldex Control Unit 15
25
Front seat belts RGS+EBSS
left
25
26
Right-hand door (front and
rear)
30
27
Rear seat belts RGS+EBSS
right
25
28
PHEV. Switching o the high
voltage system for rescue
tasks. Identied by a yellow
label
15
29 Trailer 15
30 Radio 30
No. Consumers/Amps
31 Trailer 25
33 Driver’s seat 15
34 230V socket (150 W) 30
35
On-board network control
unit
40
36 Air conditioner fan 40
37 Electric rear lid 30
39 Heated steering wheel 10
40 Alarm horn 7.5
41 Gateway 7.5
43 Air conditioning 10
44
Diagnostics / Front courtesy
light / Adaptive lighting /
Interior mirror / Anti-theft
sensor / Electronic parking
brake
7.5
45 Steering column 7.5
46
Display / Head-up-Display
(HUD)
7.5
47 Suspension control unit 10
52
12V socket (centre console
and luggage compartment)
20
58 Park assist 7.5

Related Topics

Popular Owner Manuals