Get Getting To Know Your Vehicle -> Wipers And Washers Guide for Fiat 500 E 4 Door Second Generation (2020-2024)

42 GETTING TO KNOW YOUR VEHICLE

NOTE:

In order to preserve the life of the battery, the light will

turn off after 15 minutes.

FRONT WINDSHIELD WIPER OPERATION

REAR WINDSHIELD WIPER

Rotate the windshield wiper knob to one of the first

two detent positions for intermittent settings, the third

detent for low wiper operation and the fourth for high

wiper operation.

The rear wiper/washer controls are located on the

windshield wiper lever on the right side of the steering

column. The rear wiper/washer is operated by rotating

a switch, located on the left side of the lever.

WIPERS AND WASHERS

The windshield wiper/washer controls are located on

the lever on the right side of the steering column.

There are five different modes of operation for the front

windshield wipers.

Smart washing function

NOTE:

If the front wipers are moving and the vehicle is shifted

in REVERSE, the rear wiper will perform one round up to

clean the rear window.

Pull the stalk towards the steering wheel (unstable

position) to operate the windshield washer.

Keep the lever pulled to activate both the windshield

washer jet and the windshield wiper with a single

movement; the latter turns on automatically if you keep

the lever pulled for more than half a second.

NOTE:

Rotate the center portion of the lever

upward to the first detent for intermittent

operation and to the second detent for

continuous rear wiper operation.

The windshield wipers/washers will only operate while

the vehicle’s ignition system is in the ON/RUN position.

WARNING!

To use the washer, push the lever forward

and hold while spray is desired. If the

Sudden loss of visibility through the windshield

could lead to a collision. You might not see other

vehicles or other obstacles. To avoid sudden icing

of the windshield during freezing weather, warm

the windshield with the defroster before and during

windshield washer use.

lever is pushed while in the intermittent

setting, the wiper will turn on and operate

for several wipe cycles after the end of the lever is

released, and then resume the intermittent interval

previously selected.

NOTE:

Mist

As a protective measure, the pump will stop if the

switch is held for more than 30 seconds. Once the lever

is released, the pump will resume normal operation.

Use the Mist feature when weather conditions make

occasional usage of the wipers necessary. Push the

lever upward to the MIST position and release for a

single wiping cycle.

Windshield Wiper/Washer Lever

If the lever is pushed while the wiper is in the off

position, the wiper will operate for several wipe cycles,

then turn off.

1 — Push Forward For Rear Washer

2 — Rotate For Rear Wiper Operation

3 — Rotate For Front Wiper Operation

4 — Pull For Front Washer

NOTE:

The mist feature does not activate the washer pump;

therefore, no washer fluid will be sprayed on the

windshield. The washer function must be used in order

to spray the windshield with washer fluid.

If the rear wiper is operating when the ignition is placed

in the OFF position, the wiper will automatically return

to the parked position.

5 — Push Up For Mist

GETTING TO KNOW YOUR VEHICLE 43

NOTE:

● The Rain Sensing feature can be turned on and off

through the Uconnect system page 113.

CAUTION!

In the event of low high voltage battery levels or

very cold/very hot weather, remember to connect

the vehicle to a power outlet to enable climate

programming.

Failure to follow these cautions can cause damage to

the heating elements:

● Use care when washing the inside of the rear

window. Do not use abrasive window cleaners on

the interior surface of the window. Use a soft cloth

and a mild washing solution, wiping parallel to the

heating elements. Labels can be peeled off after

soaking with warm water.

TEMPERATURE CONTROL OVERVIEW

● Do not use scrapers, sharp instruments, or

abrasive window cleaners on the interior surface

of the window.

● Keep all objects a safe distance from the window.

Rain sensing stalk

1 — Automatic Wiping - Slow

RAIN SENSING WIPERS — IF EQUIPPED

2 — Automatic Wiping - Fast

Rotate the switch the first detent for slow operation or

the second detent for fast operation.

This feature senses rain or snowfall on the windshield

and automatically activates the wipers. Rotate the end

of the windshield wiper lever to one of the two detent

positions to activate this feature.

Uconnect 5 NAV With 10.25–

inch Display Automatic Climate Controls

Place the ring in the O (off) position when not using the

system.

MAX A/C Button

NOTE:

Press and release the MAX A/C button

on the touchscreen to change the current

setting to the coldest output of air. The MAX

A/C indicator illuminates when MAX A/C is

on. Pressing the button again will cause the MAX A/C

operation to exit. Pressing other settings will cause the

MAX A/C to exit.

In the event of a rain sensor failure, a dedicated

telltale on the instrument cluster will appear to warn

the customer (if equipped).

● The Rain Sensing feature will not operate when the

wiper switch is in the LO, HI, or OFF position. Only in

one of the intermittent positions.

● The Rain Sensing feature may not function properly

when ice or dried saltwater is present on the

windshield.

CLIMATE CONTROLS

The Climate Control System allows you to regulate the

temperature, air flow, and direction of air circulating

throughout the vehicle. The controls are located on the

touchscreen and on the instrument panel below the

radio.

● Use of products containing wax or silicone may

reduce rain sensor performance.

Getting To Know Your Vehicle -> Wipers And Washers for Your Fiat 500 E 4 Door Second Generation (2020-2024)

Related Topics

Getting To Know Your Vehicle

Getting To Know Your Instrument Panel

Popular Owner Manuals

Latest Owner Manuals