Get KNOWING THE INSTRUMENT PANEL -> DIGITAL DISPLAY Guide for Fiat Doblo Van 2010-2022

SPEEDOMETER

IMPORTANT The needle will point to E

and warning light A will flash to indicate

a fault in the system. Contact a Fiat

Dealership to have the system

checked.

DIGITAL DISPLAY

This shows the speed at which the

vehicle is travelling.

STANDARD SCREEN

The standard screen fig. 114 can

display the following information:

REV COUNTER

The rev counter shows the engine rpm.

IMPORTANT The electronic injection

control system gradually shuts off

the flow of fuel when the engine

is “over-revving” resulting in a gradual

loss of engine power.

Headlamp alignment position (only

with dipped headlamps on).

ENGINE COOLANT

TEMPERATURE

INDICATOR

Milometer (distance covered in km or

miles).

This shows the temperature of the

engine coolant fluid and starts working

when the fluid temperature exceeds

approx. 50°C.

Time (always displayed, even with the

key extracted and the front doors

closed).

When the engine is idling, the rev

counter may indicate a gradual or

sudden increase of the speed.

This behaviour is standard as it takes

place during the activation of the

climate control system or the fan. It

should not be considered as a fault. In

such cases, a slight increase in engine

idle speed helps to sustain the battery

charge.

In normal usage, the needle should

hover around the middle of the scale.

C Low engine coolant temperature.

H High engine coolant temperature.

The warning light on the gauge may

light up (and a message on the

multifunction display may appear on

certain versions) to indicate that the

coolant fluid temperature is too high; in

this case, stop the engine and contact

a Fiat Dealership.

Start&Stop function indication (for

versions/markets, where provided).

Gear Shift Indication (for versions/

markets, where provided).

Note With key removed (when opening

at least one of the front doors) the

display turns on and shows the time

and distance covered for a few

seconds.

FUEL LEVEL GAUGE

This shows the amount of fuel left in the

fuel tank.

E tank empty.

10)

F tank full (see the instructions provided

in the “Vehicle refuelling” paragraph).

The warning light on the gauge comes

on to indicate that approximately 8-10

litres of fuel are left in the tank.

Do not travel with the fuel tank almost

empty: any gaps in fuel supply could

damage the catalytic converter.

WARNING

10) If the needle for the engine coolant

temperature reaches the red area, stop the

engine immediately and contact a Fiat

Dealership.

F0V0011

114

CONTROL BUTTONS

SET-UP MENU

– press briefly the MENU

button to

store the new setting and go back to

the previous menu option.

To scroll up through the screen and

the related options or to increase

the displayed value.

The menu comprises a series of

functions arranged in a circular way,

which can be selected through the

and buttons to access the

different selection operations and

settings (setup) given in the following

paragraphs.

Selecting “Set Clock”

Press briefly to access the menu and/or

– briefly press button MENU

select the first value to change (hours);

– press buttons and (with single

presses) to select the new setting;

go to next screen or to confirm the

required menu option. Hold down to go

back to the standard screen.

The setup menu can be activated by

briefly pressing the MENU

– briefly press the MENU

button to

button.

To scroll down through the screen

and the related options or to

decrease the displayed value.

store the new setting and go to the

next setup menu option (minutes);

– after setting the values with the same

procedure, go back to the previous

menu item.

Single presses on the and buttons

will scroll the setup menu options.

Management modes differ according to

the characteristic of the option

selected.

Hold down the MENU

button

The menu comprises the following

functions:

– to quit the setup menu if you are in

the menu;

ILLU

– to quit to the menu if you are setting

an option;

SPEED

HOUR

UNIT

– to save only the settings already

stored (and confirmed by pressing the

button).

F0V0509

115

BUZZ

BAG P

DRL

The environment of the Set Up menu is

timed; when the menu is exited due

to expiry of the time allowed, only the

changes already stored by the user

(confirmed beforehand by a brief press

NOTE Buttons and activate

different functions according to the

following situations:

Selecting a menu option

– within the menu, they allow you to

scroll up and down through the

options;

– briefly press the MENU

select the menu option to set;

button to

of the MENU

button) will be saved.

– press buttons and (with single

presses) to select the new setting;

– during setting operations they

increase or decrease the value.

Adjusting the vehicle

interior lighting (ILLU)

- press or to select speed limit

activation (On) or deactivation (Off);

Setting the clock (Hour)

With this function, it is possible to set

the time.

To adjust, proceed as follows:

- if the function is on, press

select the required speed limit and then

or to

This function is available, with the

dipped headlamps on and at night, to

adjust the brightness of the instrument

panel, buttons, sound system display

and automatic climate control display.

During the daytime, and with the

press MENU

to confirm;

- briefly press the MENU

button;

NOTE The speed may be set in the

range from 30 to 200 km/h, or from 20

to 125 mph according to the previously

chosen unit (see “Setting the distance

unit”) described below. The setting

will increase/decrease by five units each

the “hours” will flash on the display;

- press the or button to adjust;

- briefly press the MENU ESC

button; the “minutes” will flash on

the display;

dipped headlamps on, the instrument

panel, buttons and sound system

and automatic climate control displays

are set to maximum brightness.

- press the or button to adjust;

- press the MENU

time the

down the

button is pressed. Hold

button to automatically

button briefly to

press the MENU button briefly:

the display will show the wording ILLU;

return to the menu screen or hold the

button down to return to the standard

screen without storing.

increase/decrease the setting rapidly.

Complete the adjustment with single

presses of the button when you

approach the desired value.

press button and to set the

required brightness level;

Setting the distance unit

(Unit)

press the MENU

button briefly

- press the MENU

button briefly to

to return to the menu screen or hold

the button down to return to the

standard screen without storing.

With this function it is possible to set

the unit.

To adjust, proceed as follows:

return to the menu screen or hold the

button down to return to the standard

screen without storing.

- press the MENU

button briefly:

To cancel the setting, proceed as

follows:

Setting a speed limit

(SPEEd)

the display will show the wording (Unit)

and the previously set unit (km) or (mi);

- press or to select the required

unit.

- briefly the press MENU

(On) will flash on the display;

button;

This function is used to set a speed

limit (km/h or mph); the driver is alerted

when this limit is exceeded (see

“Warning lights and messages”).

To set the desired speed limit, proceed

as follows:

- press the button; (Off) will flash on

the display;

- press the MENU

button briefly to

return to the menu screen or hold the

button down to return to the standard

screen without storing.

- press the MENU

button briefly to

return to the menu screen or hold the

button down to return to the standard

screen without storing.

- press the MENU

button briefly:

the display will show the wording

(SPEED) and the unit (km/h) or (mph)

previously set;

Download User Manual App

KNOWING THE INSTRUMENT PANEL -> DIGITAL DISPLAY for Your Fiat Doblo Van 2010-2022

Related Topics

KNOWING YOUR CAR

KNOWING THE INSTRUMENT PANEL

Popular Owner Manuals

Latest Owner Manuals