Get KNOWING YOUR CAR -> SEATS Guide for Fiat Doblo Van 2010-2022

10) If you are parked on a slope, do not

leave the sliding door locked in the open

position. An involuntary impact could

unhook the door, causing it to move.

SEATS

DRIVER’S SEAT

(for Cargo versions, where provided)

15)

11) Before leaving the vehicle parked with

the sliding doors open, always check

that they are locked into place.

Longitudinal adjustment

Raise the lever A fig. 24 and push the

seat forwards or backwards: in driving

position your arms should be slightly

bent and your hands should rest on the

rim of the steering wheel.

12) Always use this device when carrying

children.

13) The spring-loaded system was

designed for optimum usage. Accidental

knocks or a strong gust of wind may

release the springs, forcing the doors to

close.

F0V0527

22

14) When closing, shut the right hand door

fully before you close the left hand door.

Never shut the two doors at the same time.

WARNING

2) Make sure that the left sliding side door

is all closed before refuelling to prevent

damage to the door and to the sliding

locking system with fuel filler cap open,

activated during refuelling.

F0V0528

23

F0V0210

24

16)

WARNING

Reclining backrest adjustment

8) Before opening a door, ensure that you

can do it in conditions of safety.

Lift lever B fig. 24 and, slightly

detaching the back from the backrest,

accompany the movement of the

backrest until it is in the desired

position.

9) You must not open the left-hand sliding

side door with the fuel cap open while

refuelling. Check that the fuel cap is closed

while opening/closing the sliding side

door to avoid damage.

22

DRIVER’S SEAT

(for Doblò/Doblò Combi/Cargo

versions, where provided)

Backrest angle adjustment

Turn knob B fig. 25

15)

Driver seat height adjustment

(for versions/markets, where provided)

Lengthwise adjustment

Operate lever C fig. 25 to lift or lower

the rear part of the cushion to achieve

the most comfortable driving position.

Lift the lever A fig. 25 and push the seat

forwards or backwards: in the driving

position your arms should rest on

the rim of the steering wheel.

IMPORTANT Adjustment must be

carried out only when seated in the

relevant seat.

F0V0208

26

16)

FOLDAWAY PASSENGER

SEAT

(for versions/markets, where provided)

Driver seat lumbar adjustment

(for versions/markets, where provided)

The passenger seat can be folded

away on some Cargo versions.

Turn knob D fig. 25 to adjust the

backrest support.

17)

Completely retract the seat for a total

folding down avoiding interference with

the dashboard.

Heated seats

(for versions/markets, where provided)

With the key turned to MAR, press

button A fig. 26 to switch the function

on/off.

Seat folding

To fold the seat, proceed as follows:

open the passenger side door;

When the function is enabled, the LED

on the button turns on.

pull levers A and fold the backrest

forwards in the direction indicated

by the arrow;

then push the backrest B fig.

28down: the seat is now completely

folded over on itself into the "table"

position;

F0V0013

25

23

F0V0144

F0V0146

29

31

Repositioning the seat

ACCESS TO THE REAR

SEATS

(Doblò and Doblò Combi versions)

To return the seat back to its normal

position, proceed as follows:

To access the rear seats, open one of

the sliding side doors (see "Doors"

in this section).

grip tab A fig. 30 and lift the

backrest upwards;

FOLDING TABLE SEAT

(Doblò and Doblò Combi versions,

where provided)

F0V0142

27

On some versions the seat can be

folded into a table position.

20)

Completely retract the seat in table

position for a total folding down

avoiding interference with the

dashboard.

F0V0145

30

operate levers B fig. 31 and lift the

seat further upwards.

IMPORTANT Move the seat only when

there are no rear passengers.

Seat folding

F0V0143

28

18) 19)

pull flap C fig. 29 and push the

backrest down further: the seat is now

completely folded away.

Open the passenger side door;

24

Pull lever A fig. 32 and fold the

backrest forwards in the direction

indicated by the arrow;

pull the tape B fig. 33 behind the

seat backrests and fold the seats and

the backrests forwards.

REMOVING 3RD ROW

SEATS

Proceed as follows:

Push the backrest B fig. 32 down:

the seat is now completely folded over

on itself into the "table" position.

remove the rear seat head restraints;

8

remove the rolling curtain from its

housing;

6

1

5

7

4

3

2

move the seat belt to the side,

making sure that it is fully extended and

not twisted;

2

4

1

3

lift lever A fig. 33 retaining the

backrest and fold the latter forwards.

When you lift the lever, you will see

a red band.

F0V0407

33

pull the tape B fig. 33 behind the

seat backrests and fold the seats and

the backrests forwards;

F0V0201

32

position the head restraint using the

openings under the cushion to insert

the rods;

Repositioning the seat:

operate lever A fig. 32 and lift the

backrest upwards.

push the lever as indicated in fig. 35;

3RD ROW SEAT

MOVEMENTS

Proceed as follows:

F0V0408

34

completely lower the rear seat head

restraints;

Note On the split seats, there are

rubber bands on the lower edge of the

cushion so you can attach the folded

seat to the 2nd row rear seat head

restraint rods (see the plate on the seat

backrest fig. 33).

move the seat belt to the side,

making sure that it is fully extended and

not twisted;

lift lever A fig. 33 retaining the

backrest and fold the latter forwards.

When you lift the lever, you will see

a red band.

F0V0206

35

21)

25

remove the seat from the

attachments on the floor.

FRONT BENCH

(for versions/markets, where provided)

15)

REPOSITIONING 3RD

ROW SEATS

Some versions feature a front bench

with central and side passenger

backrests that fold down to a table.

To fold down the backrests, pull tabs A

or B fig. 37 to fold down the central

or side section of the backrest

respectively fig. 38.

Proceed as follows:

attach the hooks to the floor fig. 36;

F0V0551

38

The central backrest features a

retaining clip that can be used to hold

documents.

IMPORTANT Before folding down the

central backrest, you need to

completely lower the head restraint to

prevent it from interfering with the

gear lever in certain driving conditions.

By pulling tab C fig. 37, you can also

raise the single central and side seat

cushion to access a dedicated storage

compartment fig. 39.

F0V0207

36

push the lever as illustrated in fig.

35 and pull it to make sure that the seat

is still correctly secured;

withdraw the head restraint under

the cushion;

fold the cushion and the backrest

over;

reposition the head restraint;

re-position the rolling curtain in its

housing.

IMPORTANT Make sure that the seat is

properly secured to the fastenings on

the floor and that the lever A fig. 33

is tightened (red band not visible).

F0V0550

37

F0V0552

39

26

Download User Manual App

KNOWING YOUR CAR -> SEATS for Your Fiat Doblo Van 2010-2022

Related Topics

KNOWING YOUR CAR

KNOWING THE INSTRUMENT PANEL

Popular Owner Manuals

Latest Owner Manuals