BONNET
Opening
Proceed as follows:
pull lever A fig. 77 in the direction
indicated by the arrow;
operate lever B fig. 78, lift the
bonnet and, at the same time, release
the supporting rod C fig. 79 from its
catch D, then insert the end of the rod
into housing E in the bonnet (large hole)
and push to safety position (small
hole), as shown in the figure.
F0V0048
78
Closing
Proceed as follows:
Hold the bonnet up with one hand
and with the other remove rod C from
housing E and fit it back into its catch
D;
30) 31) 32) 33)
Lower the bonnet to approximately
20 centimetres above the engine
compartment and let it come down.
Make sure that the bonnet is
F0V0049
79
WARNING
completely closed and not just secured
in safety position. If it is not perfectly
closed, do not try to press the bonnet
down but open it and repeat the
procedure.
30) Incorrect positioning of the supporting
rod may cause the bonnet to drop
suddenly. Perform this operation only when
the vehicle is stationary.
F0V0047
77
34)
31) Before opening the bonnet, make sure
that windscreen wiper arm is not raised,
but is rather positioned against the
windscreen.
55
English 