INSERTING/ REMOVING
THE SMARTPHONE
To insert the smartphone into the
support, proceed as follows:
lay the smartphone on the front base
and release it. The load on the spring
inside the docking station will allow the
gripping hand to close;
10) 11) 12)
IMPORTANT
block the smartphone by turning
the ring (A) fig. 52 so that it clicks into
10) When the car is moving, the
smartphone must be used in the docking
station only in a horizontal position and
without any inclination (see fig. 53). Any
other position of the docking station is
allowed only with the car stopped, with the
sole purpose of facilitating the insertion of
the smartphone in the station.
position
.
11) The maximum dimensions of the
usable smartphones are: 67 mm (width)
and 11 mm (depth).
52
F1D0703
12) The maximum weight of smartphone
that can be installed is 180 g.
ensure that the ring nut (A) fig. 52 is
turned to position
;
54
F1D1017
insert the smartphone horizontally in
its seat, placing it on the base of the
docking station, and press to open the
gripping hand fig. 53;
ROOF RACK/ SKI
RACK
The rear knob (B) fig. 54 allows
possible adjustments depending
on the weight and geometry of the
smartphone.
The attachments (B) fig. 55 are located
in the areas illustrated in the figure and
can only be accessed with the doors
open and after removing the flaps (A)
fig. 55 from the roof. Lineaccessori
To remove the smartphone from the
docking station:
turn the ring (A) fig. 52 so that it
clicks into position
MOPAR has a dedicated roof rack/ski
®
;
rack for this car. Follow the instructions
contained in the assembly kit to fit the
roof rack/ski rack.
take out the smartphone by pressing
it down to open the gripping hand;
remove the smartphone from the
docking station and release it. The load
on the spring inside the docking station
will allow the gripping hand to close
after the phone has been removed.
53
F1D1016
40
English 