REAR HEAD RESTRAINTS
(for versions/markets where provided)
Upwards adjustment: raise the head
restraint until it clicks into place.
WARNING
WARNING
13) All adjustments must be made with
the car stationary. Head restraints must be
adjusted so that the head, rather than the
neck, rests on them. Only in this case they
can protect your head correctly.
14) To make the best use of the head
restraint's protective action, adjust the
backrest so that you are sitting upright and
keep your head as close as possible to the
head restraint.
15) All adjustments must be carried out
only with the car stationary and engine off.
16) It is absolutely forbidden to carry
out any after-market operation involving
steering system or steering column
modifications (e.g.: installation of
anti-theft device) that could badly affect
performance and safety, invalidate
the warranty and also result in non-
compliance of the car with type-approval
requirements.
Downward adjustment: press button
(A) fig. 15 and lower the head restraint.
STEERING WHEEL
REAR-VIEW
MIRRORS
15) 16)
ADJUSTMENTS
The steering wheel can be adjusted
vertically.
15
F1D0012
INTERIOR MIRROR
The mirror is fitted with a safety device
that causes its release in the event of
a violent impact with the passenger.
Operate lever (A) fig. 17 to adjust the
mirror into two different positions:
normal or anti-glare
WARNING If the rear seats are used,
always set the head restraints in the
"completely raised" position.
To adjust bring the lever (A) fig. 16
downward in position (1), then adjust
the steering wheel to the most suitable
position and lock it in this position
bringing the lever (A) in position (2).
Removal
Proceed as follows to remove the head
restraints:
raise the head restraints to their
maximum height;
press buttons (A) and (B) fig. 15 at
the side of the two supports, then
remove the head restraints by pulling
them upwards.
2
A
1
17
F1D0014
16
F1D0013
17
English 