Convenient features -> Lighting control for Your Hyundai I20 4 Door 2021-2026

Convenient features  
EXTERIOR LIGHTS  
Lighting control  
OBC3050029  
$872ꢀOLJKWꢀSRVLWLRQꢀꢁLIꢀHTXLSSHGꢂ  
OPDE046065  
When the light switch is in the AUTO  
position, the position light and headlight  
will be turned ON or OFF automatically  
depending on the amount of light  
outside the vehicle.  
Even with the AUTO light feature  
in operation, it is recommended to  
manually turn ON the lights when driving  
at night or in a fog, or when you enter  
dark areas, such as tunnels and parking  
facilities.  
To operate the lights, turn the knob at  
the end of the control lever to one of the  
following positions:  
(1) OFF (O) position  
(2) AUTO light position (if equipped)  
(3) Position light position  
(4) Headlight position  
NOTICE  
śꢀ 'RꢀQRWꢀFRYHUꢀRUꢀVSLOOꢀDQ\WKLQJꢀRQꢀWKHꢀ  
sensor (1) located on the instrument  
panel.  
śꢀ 'RꢀQRWꢀFOHDQꢀWKHꢀVHQVRUꢀXVLQJꢀ  
a window cleaner, the cleanser  
may leave a light film which could  
interfere with sensor operation.  
śꢀ ,Iꢀ\RXUꢀYHKLFOHꢀKDVꢀZLQGRZꢀWLQWꢀRUꢀ  
other types of metallic coating on  
the front windscreen, the AUTO light  
system may not work properly.  
5-42  
05  
High beam operation  
OAE046469L  
OAE046453L  
Position light position (  
)
To turn on the high beam headlight,  
push the lever away from you.  
The high beam indicator will light when  
the headlight high beams are switched  
on.  
The position light, license plate light and  
instrument panel light are turned ON.  
To turn off the high beam headlight, pull  
the lever towards you. The low beams  
will turn on.  
WARNING  
Do not use high beam when there are  
other vehicles approaching you. Using  
high beam could obstruct the other  
driver’s vision.  
OAE046467L  
+HDGOLJKWꢀSRVLWLRQꢀꢁ  
)
The headlight, position light, license  
plate light and instrument panel light are  
turned ON.  
Information  
7KHꢀLJQLWLRQꢀVZLWFKꢀPXVWꢀEHꢀLQꢀWKHꢀ21ꢀ  
i
position to turn on the headlight.  
5-43  
Convenient features  
Turn signals and lane change  
signals  
OAE046455L  
To flash the high beam headlight, pull  
the lever towards you, then release the  
lever. The high beams will remain ON as  
long as you hold the lever towards you.  
OTLE045284  
To signal a turn, push down on the lever  
for a left turn or up for a right turn in  
position (A). To signal a lane change,  
move the turn signal lever slightly and  
hold it in position (B).  
The lever will return to the OFF position  
when released or when the turn is  
completed.  
If an indicator stays on and does not  
flash or if it flashes abnormally, one of  
the turn signal bulbs may be burned out  
and will require replacement.  
2QHꢃWRXFKꢀWXUQꢀVLJQDOꢀIXQFWLRQꢀ  
To activate a one-touch turn signal  
function, move the turn signal lever  
slightly and then release it. The lane  
change signals will blink 3, 5 or 7 times.  
You can activate or deactivate the One  
Touch Turn Signal function or choose  
the number of blinks (3, 5, or 7) from the  
User Settings Mode on the LCD display.  
)RUꢀPRUHꢀGHWDLOVꢁꢀUHIHUꢀWRꢀŕ/&'ꢀ'LVSOD\ꢀ  
0RGHVŖꢀLQꢀFKDSWHUꢀꢂꢃꢀꢀ  
5-44  
05  
Front fog light (if equipped)  
Rear fog light  
OPDE046064  
OPDE046066  
To turn on the rear fog lamp:  
Fog lamps are used to provide improved  
visibility when visibility is poor due to  
fog, rain or snow, etc. Use the switch  
next to the headlamp switch to turn the  
fog lamps ON and OFF.  
1. Turn on the position lamp.  
2. Turn the light switch (1) to the front  
fog lamp position.  
3. To turn off the front fog lamp, turn  
the light switch to the front fog lamp  
position again or turn off the position  
lamp.  
Position the light switch in the position  
lamp position, turn the light switch (1)  
to the front fog lamp position, and then  
turn the light switch (1) to the rear fog  
lamp position.  
To turn the rear fog lamps off, do one of  
the following:  
śꢀ Turn off the position light switch.  
śꢀ Turn the light switch to the rear fog  
lamp position again.  
śꢀ When the light switch is in the position  
lamp position, if you turn off the front  
fog lamp, the rear fog lamp will also  
turn off.  
NOTICE  
When in operation, the fog lights  
consume large amounts of vehicle  
electrical power. Only use the fog lights  
when visibility is poor.  
5-45  
Convenient features  
Battery saver function  
The purpose of this feature is to prevent  
the battery from being discharged.  
The system automatically turns off the  
position lamp when the driver turns the  
engine off and opens the driver-side  
door.  
With this feature, the position lamps will  
turn off automatically if the driver parks  
on the side of road at night.  
OAC3059027TU  
If necessary, to keep the lamps on when  
the engine is turned off, perform the  
following:  
Vehicle without front fog lamp  
To turn on the rear fog lamp:  
1) Open the driver-side door.  
Position the light switch in the headlamp  
position, and then turn the light switch  
(1) to the rear fog lamp position.  
To turn the rear fog lamps off, do one of  
the following:  
śꢀ Turn off the headlamp switch.  
śꢀ Turn the light switch to the rear fog  
2) Turn the position lamps OFF and ON  
again using the light switch on the  
steering column.  
Headlamps delay function  
(if equipped)  
If you place the ignition switch in the  
ACC or OFF position with the headlamps  
ON, the headlamps (and/or position  
lamps) remain on for about 5 minutes.  
However, with the engine off if the  
GULYHUŔVꢀGRRUꢀLVꢀRSHQHGꢀDQGꢀFORVHGꢁꢀWKHꢀ  
headlamps (and/or position lamps) are  
turned off after 15 seconds.  
lamp position again.  
The headlamps (and/or position lamps)  
can be turned off by pressing the lock  
button on the remote key or smart  
key twice or turning the light switch to  
the OFF or AUTO position. However, if  
you turn the light switch to the AUTO  
position when it is dark outside, the  
headlamps will not be turned off.  
5-46  
05  
NOTICE  
Headlight levelling device  
If the driver exits the vehicle through  
another door besides the driver  
door, the battery saver function  
does not operate and the headlight  
GHOD\ꢀIXQFWLRQꢀGRHVꢀQRWꢀWXUQꢀ2))ꢀ  
automatically.  
This may cause the battery to  
discharge. To avoid battery discharge,  
WXUQꢀ2))ꢀWKHꢀKHDGOLJKWVꢀPDQXDOO\ꢀIURPꢀ  
the headlight switch before exiting the  
vehicle.  
OBC3050009R  
Daytime running light (DRL)  
(if equipped)  
The Daytime Running Lights (DRL) can  
make it easier for others to see the front  
of your vehicle during the day, especially  
after dawn and before sunset.  
The DRL system will turn the dedicated  
light OFF when:  
1. The parking brake is applied.  
2. The engine is turned off.  
To adjust the headlight beam level  
according to the number of the  
passengers and loading weight in the  
luggage area, turn the beam levelling  
switch.  
The higher the number on the switch  
position, the lower the headlight beam  
level. Always keep the headlight beam  
at the proper levelling position, or  
headlights may dazzle other road users.  
Listed below are examples of  
appropriate switch settings for varying  
loads. For loading conditions other than  
those listed, adjust the switch position to  
the most similar situation.  
Switch position  
Loading condition  
0
Driver only  
Driver + Front  
passenger  
0
1
Full passengers  
(including driver)  
Full passengers  
(including driver) +  
Maximum permissible  
loading  
2
3
Driver + Maximum  
permissible loading  
5-47  
Convenient features  
WARNING  
If the function does not work properly,  
we recommend that the system be  
inspected by a HYUNDAI authorised  
repairer. Do not attempt to inspect or  
replace the wiring yourself.  
Low Beam Assist-Static light  
Whilst driving a corner, for greater  
visibility and safety, either the left or  
right side Low Beam Assist-Static light  
will turn on automatically. The Low  
Beam Assist-Static light will turn on  
when one of the following conditions  
occurs.  
śꢀ Vehicle speed is less than 6 mph (10  
km/h) and steering wheel angle is  
turned approximately 80 degrees with  
the low beam on.  
śꢀ Vehicle speed is between 6 mph  
(10 km/h) to 56 mph (90 km/h)  
and steering wheel angle is turned  
approximately 35 degrees with the low  
beam on.  
śꢀ When the vehicle is in reverse with  
one of the conditions above satisfied,  
the light opposite to the direction the  
steering wheel is turned will turn on.  
5-48