2009-2015 Hyundai Ix35 SUV Features of your vehicle -> WIPERS AND WASHERS User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Features of your vehicle -> WIPERS AND WASHERS for Your Hyundai Ix35 SUV First Generation (2009-2015)

Features of your vehicle  
WIPERS AND WASHERS  
Windshield wiper/washer  
A : Wiper speed control  
· MIST – Single wipe  
· OFF – Off  
Rear window wiper/washer  
(if equipped)  
· INT – Intermittent wipe  
· LO – Low wiper speed  
· HI – High wiper speed  
B : Intermittent wipe time adjustment  
C : Wash with brief wipes (front)  
D : Rear wiper/washer control  
· ON – Continuous wipe  
· INT – Intermittent wipe  
· OFF – Off  
OAM049100N/OAM049048N  
E : Wash with brief wipes (rear)  
* : if equipped  
4 54  
Features of your vehicle  
NOTICE  
If there is heavy accumulation of snow  
or ice on the windshield, defrost the  
windshield for about 10 minutes, or  
until the snow and/or ice is removed  
before using the windshield wipers to  
ensure proper operation.  
NOTICE  
• When you operate the wipers, if your  
vehicle has a problem in any part of  
the wiper operation system, the wiper  
may operate in the LO mode regard-  
less of the wiper switch position. In  
this case, have your vehicle checked  
by an authorized HYUNDAI dealer as  
soon as possible.  
• When the ignition key is removed, the  
wiper blade sometimes may move  
slightly for reducing the deterioration  
of the windshield wipers.  
OAM049101N  
OAM049102N  
Windshield wipers  
Windshield washers  
Operates as follows when the ignition  
switch is turned ON.  
In the OFF position, pull the lever gently  
toward you to spray washer fluid on the  
windshield and to run the wipers 1-3  
cycles.  
MIST : For a single wiping cycle, move  
the lever to this (MIST) position  
and release it. The wipers will  
operate continuously if the lever is  
held in this position.  
Use this function when the windshield is  
dirty.  
The spray and wiper operation will con-  
tinue until you release the lever.  
OFF : Wiper is not in operation  
INT : Wiper operates intermittently at  
the same wiping intervals. Use this  
mode in a light rain or mist. To vary  
the speed setting, turn the speed  
control knob(1).  
If the washer does not work, check the  
washer fluid level. If the fluid level is not  
sufficient, you will need to add appropri-  
ate non-abrasive windshield washer fluid  
to the washer reservoir.  
LO : Normal wiper speed  
HI : Fast wiper speed  
The reservoir filler neck is located in the  
front of the engine compartment on the  
passenger side.  
4 55  
Features of your vehicle  
CAUTION  
To prevent possible damage to the  
washer pump, do not operate the  
washer when the fluid reservoir is  
empty.  
WARNING  
Do not use the washer in freezing  
temperatures without first warming  
the windshield with the defrosters;  
the washer solution could freeze on  
the windshield and obscure your  
vision.  
OAM049103N  
OXM049125  
Push the lever away from you to spray  
rear washer fluid and to run the rear  
wipers 1~3 cycles. The spray and wiper  
operation will continue until you release  
the lever.  
Rear window wiper and washer  
switch  
The rear window wiper and washer  
switch is located at the end of the wiper  
and washer switch lever. Turn the switch  
to the desired position to operate the rear  
wiper and washer.  
CAUTION  
• To prevent possible damage to  
the wipers or windshield, do not  
operate the wipers when the  
windshield is dry.  
ON - Normal wiper operation  
INT - Intermittent wiper operation  
(if equipped)  
• To prevent damage to the wiper  
blades, do not use gasoline,  
kerosene, paint thinner, or other  
solvents on or near them.  
OFF - Wiper is not in operation  
• To prevent damage to the wiper  
arms and other components, do  
not attempt to move the wipers  
manually.  
4 56  

Related Topics

Popular Owner Manuals