LAMPS AND BULBS
3. Disconnect the cable connector from the
bulb socket and pull out the bulb
4. Place the bulb holder on the lower edge
of the mounting and press it in until it
engages in the bulb socket
5. Reconnect the cable connector and
install the headlamp cover again.
Xenon lamps*
The service life of these bulbs is very long
and the probability of a failure is very low,
provided that they are not switched on and
off an unusual number of times. If one of
these bulbs should nevertheless fail, it is
possible to continue driving with great cau-
tion using the fog lamps, provided traffic
laws in your area do not prohibit this.
1 Low beams
Turn signal indicators, front
H7 bulb, 55 watts
21 watt bulb
1. Open the bonnet
2. Reach into the opening for the turn sig-
nal indicators from above
2 High beams
H7 bulb, 55 watts
3. Apply gentle pressure to the bulb holder
while turning it to the left
4. Remove and replace the bulb.
The H7 bulb is pressurized. Therefore,
wear safety glasses and protective
gloves. If the lamp is damaged there is a
risk of injury.<
Have any work on the xenon lamp
system, including bulb replacement,
carried out only by a MINI Dealer or a work-
shop that has specially trained personnel
working in accordance with the specifica-
tions of the MINI manufacturer. Due to
high voltage, there is a risk of fatal injury if
work on the xenon lamps is carried out
improperly.<
Parking lamps and standing lamps
5 watt bulb
Replacing bulbs
The parking lamps and standing lamps are
integrated in the lamp housing of the turn
signal indicator.
The headlamps are integrated into the
engine compartment.
1. Gently pull the retaining wire of the
headlamp cover and guide it outwards
2. Fold down the headlamp cover
1. Turn the bulb holder to the left and pull
out
2. Remove and replace the bulb.
122
English 
