See “List of voice commands” and “During a call”
in this section for more information.
2. The system announces: “Press the PHONE/
SEND ( ) button for the hands-free
phone system to enter the voice adaptation
Phone/end
While the Voice Recognition system is active,
mode or press the PHONE/END (
button to select a different language.”
)
press and hold the
button for 5 seconds to
3. Press the
button.
quit the Voice Recognition system at any time.
For information on voice adaptation, see
“Voice Adaptation (VA) mode” in this section.
Tuning switch
While using the Voice Recognition system, tilt the
tuning switch up or down to manually control the
phone system.
4. The system announces the current language
and gives you the option to change the lan-
guage to Spanish (in Spanish) or French (in
French). To select the current language, press
GETTING STARTED
the PHONE/SEND ( ) button. To select
a different language, tilt the tuning switch
CONTROL BUTTONS
The following procedures will help you get
started using the Bluetooth® Hands-Free Phone
System with NISSAN Voice Recognition. For ad-
ditional command options, refer to “List of voice
commands” in this section.
The control buttons for the Bluetooth® Hands-
Free Phone System are located on the steering
wheel.
(
or
) up or down.
NOTE:
You must press the
button within 5
1.
2.
Phone/send button
Phone/end button
seconds to change the language.
Choosing a language
5. If you decide not to change the language, do
not press either button. After 5 seconds, the
VR session will end, and the language will not
be changed.
3. Tuning switch
You can interact with the Bluetooth® Hands-
Free Phone System using English, Spanish or
French.
Phone/send
Press the
answer an incoming call.
button to initiate a VR session or
To change the language, perform the following.
1. Press and hold the
5 seconds.
button for more than
You can also use the
system feedback and give a command at once.
button to interrupt the
Display screen, heater, air conditioner, audio and phone systems 4-51
English 
