select an entry from the Phonebook or Recent
Calls lists. To re-activate Voice Recognition, exit
the manual control mode by pressing and holding
• To browse the menu options, tilt the tuning (
) switch up or down. The system will
always speak the current menu option. Depend-
ing on the audio display, it will also show the
current menu option.
• To exit the manual control mode, press and hold
the PHONE/END ( ) button for 5 seconds.
TROUBLESHOOTING GUIDE
the PHONE/END (
) button. At that time,
pressing the PHONE/SEND (
) button will
The system should respond correctly to all voice
commands without difficulty. If problems are en-
countered, try the following solutions.
start the Hands Free Phone System.
• To select the current menu option, press the
PHONE/SEND (
• To go back to the previous menu, press the
PHONE/END ( ) button. If the current
menu is the Main Menu, pressing the PHONE/
END ( ) button will exit the Phone system.
) button.
Operating tips
Where the solutions are listed by number, try
each solution in turn, starting with number 1, until
the problem is resolved.
• To enter manual control mode, start the Voice
Recognition system and tilt the tuning (
)
switch up or down. The system will speak
“Showing Manual Options” when manual con-
trols are initially activated.
Symptom
Solution
1. Ensure that the command is valid. See “List of voice commands” in this section.
2. Ensure that the command is spoken after the tone.
3. Speak clearly without pausing between words and at a level appropriate to the ambient noise level in the vehicle.
System fails to interpret the command cor-
rectly.
4. Ensure that the ambient noise level is not excessive (for example, windows open or defroster on). NOTE: If it is too noisy to use the
phone, it is likely that the voice commands will not be recognized.
5. If more than one command was said at a time, try saying the commands separately.
6. If the system consistently fails to recognize commands, the voice training procedure should be carried out to improve the recognition
response for the speaker. See “Voice Adaptation (VA) mode” in this section.
1. Ensure that the phone book entry name requested matches what was originally stored. This can be confirmed by using the “List
Names” command. See “Phonebook” (phones with automatic phonebook download function) in this section.
The system consistently selects the wrong
entry from the phone book.
2. Replace one of the names being confused with a new name.
Display screen, heater, air conditioner, audio and phone systems 4-59
English 
