• The alarm automatically turns off after approxi-
mately 50 seconds. However, the alarm reacti-
vates if the vehicle is tampered with again.
FCC Notice:
For USA:
NISSAN VEHICLE IMMOBILIZER
SYSTEM
The NISSAN Vehicle Immobilizer System will not
allow the power switch to be placed in the
READY to drive position without the use of the
registered key.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the fol-
lowing two conditions: (1) This device may
not cause harmful interference, and (2) this
device must accept any interference re-
ceived, including interference that may
cause undesired operation.
The alarm is activated by:
• Unlocking the door without using the Intelligent
Key, the request switch or the key. (Even if the
door is opened by releasing the door inside lock
knob, the alarm will activate.)
If the power switch fails to place the vehicle into
the READY to drive position using the registered
key, it may be due to interference caused by
another registered key, an automated toll road
device or automated payment device on the key
ring. Restart the EV system using the following
procedure:
• Opening the hood.
How to stop an activated alarm
The alarm will stop when a door is unlocked by
NOTE:
Changes or modifications not expressly ap-
proved by the party responsible for compli-
ance could void the user’s authority to op-
erate the equipment.
pushing the UNLOCK
button on the Intel-
ligent Key, door handle request switch or using
the mechanical key, or when the power switch is
pushed in the ACC or ON position.
1. Leave the power switch in the ON position for
approximately 5 seconds.
For Canada:
2. Place the power switch in the OFF position
and wait approximately 10 seconds.
If the system does not operate as described
above, have it checked by a NISSAN certi-
fied LEAF dealer.
This device complies with Industry Canada
licence-exempt RSS standard(s). Opera-
tion is subject to the following two condi-
tions: (1) this device may not cause inter-
ference, and (2) this device must accept any
interference, including interference that
may cause undesired operation of the
device.
3. Repeat step 1 and 2 again.
4. Place the power switch in the READY to drive
position while holding the device (which may
have caused the interference) separate from
the registered key.
If this procedure allows power switch in the
READY to drive mode, NISSAN recommends
placing the registered key on a separate key
ring to avoid interference from other devices.
Instruments and controls 2-37
English 
