2010-2017 Nissan Leaf 4 Door Instruments and controls -> Trip computer User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Instruments and controls -> Trip computer for Your Nissan Leaf 4 Door First Generation (2010-2017)

When the power switch is pushed to the ON  
position, modes of the trip computer can be  
25. Parking brake release warning  
This warning appears when the vehicle speed is  
above 4 MPH (7km/h) and the parking brake is  
applied.  
A
selected by pushing the  
Each time the switch  
display will change as follows:  
switch  
.
᭺
A
is pushed, the  
᭺
Charging time → Energy economy → State of  
charge → Average speed → Driving distance and  
elapsed time→ Setting → Warning check  
TRIP COMPUTER  
Switches for the trip computer are located on the  
left side of the combination meter panel. To op-  
erate the trip computer, push the following  
switches:  
A
switch  
᭺
B
switch  
᭺
Instruments and controls 2-27  
NOTE:  
• Immediately after charging has finished,  
the charge time will be displayed as “--:--”.  
• The estimated charging time stops updat-  
ing if the air conditioner is turned on while  
the Li-ion battery is charging. The esti-  
mated charging time updates approxi-  
mately 15 minutes after the air condi-  
tioner is turned off.  
• The 6 kW and the 3 kW charging time  
typically shows different times to reach a  
full charge.  
• However, the same charging time may be  
shown for both the 6 kW and the 3 kW based  
on the Li-ion battery state of charge and battery  
temperature.  
Charging time  
Displays the estimated time to a full Li-ion charge  
based on the Charging Mode selected.  
Energy economy  
Average energy economy:  
The average energy economy mode shows the  
average energy economy since the last reset.  
Resetting the average energy economy is done  
B
• The system may automatically slow the battery  
charge to prevent the battery from becoming  
overcharged.  
The time needed to charge the Li-ion battery  
charges based on:  
by pushing and holding the  
switch  
for  
᭺
• Outside temperature  
longer than 1 second. (The average speed is also  
reset at the same time.)  
• Li-ion battery temperature  
• Available electrical power supplied to the  
charger  
The display is updated every 30 seconds. At  
about the first 0.3 mile (500 m) after a reset, the  
display shows “----”.  
2-28 Instruments and controls  
Instant energy economy:  
The instant energy economy mode shows the  
instant energy economy via a moving bar graph.  
When regenerated energy is being stored in the  
Li-ion battery while driving, the instant energy  
economy display will show the maximum value.  
State of charge (%)  
Average speed  
Displays the vehicles current state of charge.  
The average speed mode shows the average  
vehicle speed (MPH or km/h) since the last reset.  
The average speed (MPH or km/h) can be reset  
B
by pushing the  
second.  
switch  
for longer than 1  
᭺
The display is updated every 30 seconds. For the  
first 30 seconds after a reset, the display shows  
“----”.  
Instruments and controls 2-29  
A
B
The  
switch  
and  
switch  
are  
᭺
᭺
used in the settings mode.  
B
Push the  
menus.  
switch  
switch  
to scroll through the  
to select a menu.  
᭺
A
Push the  
᭺
Skip:  
A
Push the  
check mode.  
switch  
to move to the warning  
to select other menus.  
᭺
B
Push the  
switch  
᭺
Clock:  
The clock can be adjusted in this menu.  
• Back  
Driving distance and elapsed time  
Select this submenu to return to the top page  
of the settings mode.  
Driving distance:  
The driving distance mode shows the total distance  
(miles or km) the vehicle has been driven since the  
last reset. The distance can be reset by pushing the  
B
• Set Clock  
Adjust the time (hour and minute) of the clock.  
switch  
for longer than 1 second. (The  
᭺
For models without navigation system, the day of  
the week can also be set to use it for the climate  
control timer setting. (See “Climate Ctrl. timer” in  
the “Display screen, heater, air conditioner, audio  
and phone systems” section.)  
elapsed time is also reset at the same time.)  
Elapsed time:  
Settings  
The elapsed time mode shows the time since the  
last reset. The displayed time can be reset by push-  
Settings cannot be accessed while driving.  
The message, “settings can only be ac-  
cessed when stationary” is also displayed  
on the vehicle information display.  
• 24/12Hr (24 hours or 12 hours)  
B
ing the  
switch  
for longer than 1 second.  
᭺
Select either the 24-hour clock display or the  
12-hour display.  
(The driving distance is also reset at the same  
time.)  
2-30 Instruments and controls  
Maintenance:  
• Outside temp  
• Back  
Select this submenu to return to the top page  
of the settings mode.  
• Sound 1  
Select this submenu to display the low outside  
temperature (On or Off).  
There are 5 submenus under the maintenance  
menu.  
• Back  
Units:  
• Sound 2  
• Sound 3  
• Off  
Select this submenu to return to the top page  
of the settings mode.  
Units displayed can be set for the following items  
on this menu.  
• Tire  
• Back  
Select this submenu to set or reset the dis-  
tance for replacement of the tires.  
Select this submenu to return to the top page  
of the settings mode.  
Factory settings:  
Select this menu to reset all values to the factory  
default settings except for the odometer settings.  
• Other -1, -2 and -3  
• Temperature  
• Speed  
Select this submenu to set or reset the dis-  
tance for replaceable/maintenance items. Up  
to three other items can be monitored. Set  
other items if required.  
NOTE:  
Language:  
When resetting to the factory settings, all  
previous settings made are restored to the  
default settings.  
Select this submenu to choose the language  
displayed.  
Alarms:  
To return to the top page of the settings mode,  
select “BACK”.  
To return to the top page of the settings mode,  
select “BACK”.  
The alarms menu can be set to notify the follow-  
ing items. There are 3 submenus under the  
alarms menu.  
Effects:  
• Back  
The start up sound can be selected or turned off  
from this menu.  
Select this submenu to return to the top page  
of the settings mode.  
5 submenus under the effects menu.  
• Driver Alert  
When a menu item is selected, the selected  
sound plays.  
Select this submenu to set the driver alert  
period.  
Instruments and controls 2-31  

Related Topics

Popular Owner Manuals