2010-2017 Nissan Leaf 4 Door Instruments and controls -> Security systems User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Instruments and controls -> Security systems for Your Nissan Leaf 4 Door First Generation (2010-2017)

SECURITY SYSTEMS  
selected and each setting information display  
can be confirmed.  
1. Timer setting status (charging and  
Climate Ctrl.)  
The timer setting status (ON or OFF) of the  
charge and the climate control can be checked.  
2. Charging timer setting confirmation  
The charging timer starting hours, minutes and  
days for the next charge time that has been set  
can be checked.  
3. Charging time  
Displays the estimated time to charge the Li-ion  
battery to a full charge. When fully charged, the  
remaining charging time is displayed as “--:--”.  
Your vehicle has two types of security systems,  
as follows:  
• Vehicle security system  
4. Climate Ctrl. Timer setting  
confirmation  
The set time for ending hours and days of the  
Climate Ctrl. Timer is displayed.  
• NISSAN Vehicle Immobilizer System  
The security status is shown by the security indi-  
cator light.  
VEHICLE SECURITY SYSTEM  
INDICATOR FOR TIMER  
When the power switch is turned off, this display  
appears for 10 seconds. If the  
pushed within 10 seconds, the display can be  
The vehicle security system provides visual and  
audio alarm signals if someone opens the doors,  
or rear hatch when the system is armed. It is not,  
however, a motion detection type system that  
A
switch  
is  
᭺
Instruments and controls 2-35  
activates when a vehicle is moved or when a  
vibration occurs.  
• the power door lock switch  
• the mechanical key  
The system helps deter vehicle theft but cannot  
prevent it, nor can it prevent the theft of interior or  
exterior vehicle components in all situations. Al-  
ways secure your vehicle even if parking for a  
brief period. Never leave your keys in the vehicle,  
and always lock it when it is left unattended. Be  
aware of your surroundings, and park in secure,  
well-lit areas whenever possible.  
4. Confirm that the security indicator light illumi-  
nates. The security indicator light stays on for  
about 30 seconds. The vehicle security sys-  
tem is now pre-armed. After about 30 sec-  
onds the vehicle security system automati-  
cally shifts into the armed phase. The security  
light begins to flash once every approximately  
3 seconds. If, during this 30-second pre-arm  
time period, the door is unlocked, or the  
power switch is placed in the ACC or ON  
position, the system will not arm.  
Many devices offering additional protection, such  
as component locks, identification markers, and  
tracking systems, are available at auto supply  
stores and specialty shops. Your NISSAN certi-  
fied LEAF dealer may also offer such equipment.  
Check with your insurance company to see if you  
may be eligible for discounts for various theft  
protection features.  
Even when the driver and/or passengers  
are in the vehicle, the system will activate  
with all doors locked and the power switch  
in the OFF position. When placing the  
power switch to the ACC or ON position,  
the system will be released.  
How to arm the vehicle security  
system  
1. Close all windows.  
The system can be armed even if the  
windows are open.  
2. Place the power switch in the LOCK or OFF  
position and remove the Intelligent Key from  
the vehicle.  
Vehicle security system activation  
The vehicle security system will give the following  
alarm:  
3. Close all doors. Lock all doors. The doors can  
be locked with:  
• The headlights blink and the horn sounds  
intermittently.  
• the LOCK  
button on the Intelligent Key  
• any request switch  
2-36 Instruments and controls  
• The alarm automatically turns off after approxi-  
mately 50 seconds. However, the alarm reacti-  
vates if the vehicle is tampered with again.  
FCC Notice:  
For USA:  
NISSAN VEHICLE IMMOBILIZER  
SYSTEM  
The NISSAN Vehicle Immobilizer System will not  
allow the power switch to be placed in the  
READY to drive position without the use of the  
registered key.  
This device complies with Part 15 of the  
FCC Rules. Operation is subject to the fol-  
lowing two conditions: (1) This device may  
not cause harmful interference, and (2) this  
device must accept any interference re-  
ceived, including interference that may  
cause undesired operation.  
The alarm is activated by:  
• Unlocking the door without using the Intelligent  
Key, the request switch or the key. (Even if the  
door is opened by releasing the door inside lock  
knob, the alarm will activate.)  
If the power switch fails to place the vehicle into  
the READY to drive position using the registered  
key, it may be due to interference caused by  
another registered key, an automated toll road  
device or automated payment device on the key  
ring. Restart the EV system using the following  
procedure:  
• Opening the hood.  
How to stop an activated alarm  
The alarm will stop when a door is unlocked by  
NOTE:  
Changes or modifications not expressly ap-  
proved by the party responsible for compli-  
ance could void the user’s authority to op-  
erate the equipment.  
pushing the UNLOCK  
button on the Intel-  
ligent Key, door handle request switch or using  
the mechanical key, or when the power switch is  
pushed in the ACC or ON position.  
1. Leave the power switch in the ON position for  
approximately 5 seconds.  
For Canada:  
2. Place the power switch in the OFF position  
and wait approximately 10 seconds.  
If the system does not operate as described  
above, have it checked by a NISSAN certi-  
fied LEAF dealer.  
This device complies with Industry Canada  
licence-exempt RSS standard(s). Opera-  
tion is subject to the following two condi-  
tions: (1) this device may not cause inter-  
ference, and (2) this device must accept any  
interference, including interference that  
may cause undesired operation of the  
device.  
3. Repeat step 1 and 2 again.  
4. Place the power switch in the READY to drive  
position while holding the device (which may  
have caused the interference) separate from  
the registered key.  
If this procedure allows power switch in the  
READY to drive mode, NISSAN recommends  
placing the registered key on a separate key  
ring to avoid interference from other devices.  
Instruments and controls 2-37  

Related Topics

Popular Owner Manuals