PRACTICAL INFORMATION
2 - Main beam headlamps: H7-55W.
Remove the protective cover cor-
responding to the faulty bulb.
Disconnect the connector.
5 - Front foglamps: H11 - 55W.
Turn the wheels to full lock.
Access to the bulb is via the flap in the
front mud flap.
CHANGING A FRONT BULB
Handle the bulbs with a dry cloth.
Consult a PEUGEOT dealer.
The headlamps are fitted with polycar-
bonate glass with a protective coating.
Do not clean them with a dry or abra-
sive cloth, nor with a detergent or sol-
vent product.
Ensure that the liquid used to fill the
wash-wipe and headlamp wash reser-
voir is of good quality.
Press the end of the securing clips
to free the bulb. Change the bulb.
When fitting the new bulb, ensure
that the direction notches are po-
sitioned correctly and the securing
clips are fixed properly.
Reconnect the connector.
Refit the protective cover.
3 - Sidelamps: W5W.
High pressure washing:
when using a high pressure
washer on stubborn dirt, do
not persist on the headlamps,
the other lamps and their surrounds
to avoid damaging their coating and
seals.
In certain climatic conditions (low tem-
perature, humidity), condensation on
the inside surface of the headlamp
glass and rear lights glass is normal;
it disappears a few minutes after the
lighting is switched on.
Remove the protective cover, dis-
connect the connector and then
remove the bulb and change it.
Put the connector back in place.
Reconnect the connector.
Refit the protective cover.
Front lamps
In the engine compartment, remove
the cover secured by one or two but-
terfly screws, a plastic retainer clip and
two quarter turn screws.
1 - Dipped beam headlamps: H1-55W
or D2S-35W xenon bulb.
4 - Direction indicators:
PY21W (amber).
Turn the bulb holder a quarter turn
and remove it.
Change the bulb.
WARNING: RISK OF ELEC-
TROCUTION
Amber coloured bulbs (direc-
tion indicators and side re-
peaters) must be replaced
with bulbs of identical specifi-
cation and colour.
Xenon bulbs must be replaced by a
PEUGEOT dealer.
116
English