PRACTICAL INFORMATION -> CHANGING A REAR BULB (407SW) for Your Peugeot 407 4 Door First Generation (2004-2011)

PRACTICAL INFORMATION  
10  
Left and right foglamps: P21W.  
Carefully unclip the tailgate interior  
trim.  
Detach the sealing film located be-  
hind the lamp in question.  
Remove the bulb holder turning it a  
quarter of a turn.  
Change the faulty bulb.  
When refitting, ensure that the bulb is  
positioned correctly in the bulb holder.  
Unclip the lamp (2 clips).  
Disconnect the connector and re-  
move the lamp.  
Unclip the bulb holder moving  
aside the 4 tabs.  
Unscrew the bulb and change it.  
Reconnect the connector.  
Refit the bulb holder. When refitting  
it, ensure that the lamp is correctly  
positioned and secured, reclipping  
the rear part then the front part.  
CHANGING A REAR BULB  
(407SW)  
Wing lamps  
Number plate lamps: W5W.  
Insert a thin screwdriver in one of  
the exterior holes of the transpar-  
ent cover.  
Push it towards the outside to unclip it.  
Remove the transparent cover.  
Change the faulty bulb.  
Third brake lamp (diodes)  
1. Brake lamps/sidelamps: P21/5W.  
2. Reversing lamps: P21W.  
3. Direction indicators: P21W.  
These three bulbs are changed by re-  
moving the lamp.  
Remove the corresponding boot  
side flap to gain access to the  
lamp.  
Remove the lamp fixing nut inside  
the boot.  
All work on the diode lamps must be  
carried out by a PEUGEOT dealer.  
In some climatic conditions  
(e.g. low temperature or hu-  
midity), the presence of misting  
on the internal surface of the  
glass of the headlamps and rear lamps  
is normal; it disappears after the lamps  
have been on for a few minutes.  
Note: if necessary, use the wheelbrace  
to remove the nuts.  
118