Get Driving -> Cruise control Guide for Renault Clio 4 Door Fourth Generation (2014-2018)

CRUISE CONTROL (1/5)

Controls

1 Cruise control On/Off switch.

2 Switch to activate and decrease

cruising speed (SET/-).

3 Switch to activate and increase

cruising speed or to recall the mem-

orised cruising speed (RES/+).

4 Switch the function to standby (with

cruising speed saved) (O).

5 Speed limiter On/Off switch.

This function is an addi-

tional driving aid.

It can under no circum-

stances replace the driver’s

The cruise control function helps you to

responsibility to respect speed limits

maintain your driving speed at a speed

or to be vigilant.

that you choose, called the cruising

speed.

The driver must always be in control

of the vehicle.

This cruising speed may be set at any

speed above 19 mph (30 km/h).

Cruise control must not be used

in heavy traffic, on winding or slip-

pery roads (black ice, aquaplan-

ing, gravel) and during bad weather

(fog, rain, side winds etc.).

There is a risk of accidents.

2.96

CRUISE CONTROL (2/5)

Switching on

Activating cruise control

Driving

Press switch 1.

While the vehicle is moving a steady

Once a cruising speed is registered

speed above approximately 19 mph

and the cruise control function is active,

The 6 warning light appears in grey.

(30 km/h), press the 2 (SET/-) switch

you may lift your foot off the accelera-

The “Cruise control ON” message ap-

or the 3 (RES/+) switch: the function

tor pedal.

pears on the instrument panel accom-

is activated and the current speed is

panied by dashes to indicate that the

taken into account.

cruise control function is in operation

The cruising speed replaces the

and waiting to memorise a cruising

dashes. Cruise control is confirmed

speed.

when the memorised speed and warn-

ing light appear in green 6.

If you try to activate the function below

19 mph (30 km/h), the message “Invalid

Please note that you must

Speed” will be displayed and the func-

keep your feet close to the

tion will remain inactive.

pedals in order to react in

an emergency.

2.97

CRUISE CONTROL (3/5)

Exceeding the cruising speed

The cruising speed may be exceeded

at any time by depressing the accelera-

tor pedal. While it is being exceeded,

the cruising speed flashes in red on the

instrument panel.

Then, release the accelerator pedal:

after a few seconds, the vehicle will

automatically return to its set cruising

speed.

Cruising speed cannot be

maintained

When driving down a steep gradient,

the system may be unable to main-

Adjusting the cruising speed

tain the cruising speed: the memorised

speed will flash in red on the instrument

The cruising speed may be changed by

panel and an audible signal sounds at

pressing the following repeatedly:

regular intervals to inform you of this

– the 2 switch (SET/-) to reduce the

situation.

speed;

– the 3 switch (RES/+) to increase the

speed.

Note: press and hold one of the

switches to modify speed by succes-

sive increments.

If the cruise control is no

longer available (after sev-

eral attempts to activate it),

contact an approved dealer.

2.98

CRUISE CONTROL (4/5)

Putting the function on

Returning to the cruising speed

NB: if the speed previously stored is

much higher than the current speed,

standby

If a speed is stored, it can be recalled,

the vehicle will accelerate more rapidly

once you are sure that the road condi-

The function is set to standby if you:

to reach this threshold.

tions are suitable (traffic, road surface,

– 4 switch (O);

weather conditions, etc.). Press the

When the cruise control is set to

switch 3 (RES/+) if the vehicle speed is

standby, pressing switch 2 (SET/-) re-

– the brake pedal;

above 19 mph (30 km/h).

activates the cruise control function

– the clutch pedal or shifting to neutral

without taking into account the stored

When the speed is stored, cruise con-

if the vehicle has an automatic gear-

speed: it is the speed at which the vehi-

trol activation is confirmed by the dis-

box;

cle is moving that is taken into account.

play in green of the cruising speed and,

– depending on the vehicle, the clutch

depending on the vehicle, the 6 warn-

pedal for a prolonged period or upon

ing light is displayed.

prolonged neutral position.

The cruising speed is stored and dis-

played in grey on the instrument panel.

2.99

CRUISE CONTROL (5/5)

Switching off the function

The warning light 6 disappears from

the instrument panel to confirm that the

The cruise control function is inter-

function is no longer active.

rupted:

– when you press the 1 switch. In this

case, the speed is no longer stored;

– when you press the 5 switch. In this

case the speed limiter is selected

and there is no stored speed.

Putting the cruise control

on standby or switching it

off does not cause a rapid

reduction in speed: you

must brake by depressing the brake

pedal.

2.100

Driving -> Cruise control for Your Renault Clio 4 Door Fourth Generation (2014-2018)

Related Topics

Popular Owner Manuals

Latest Owner Manuals