2014-2018 Renault Clio 4 Door Driving -> Detection of road signs User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Driving -> Detection of road signs for Your Renault Clio 4 Door Fourth Generation (2014-2018)

DETECTION OF ROAD SIGNS (1/4)
Note: make sure the windscreen is not
For vehicles equipped with a navigation
obscured (dirt, mud, snow, condensa-
system and if the vehicle is travelling in
1
tion etc.).
a country where the speed units differ
from those of the vehicle, the system
For vehicles which are equipped with it,
displays the speed limit sign in the unit
the system also uses information from
of the country, alongside the speed limit
the navigation system.
converted to the unit used by the vehi-
Once the speed limiter is activated, you
cle’s instrument panel.
can adjust the speed limiter indication
For countries where the speed limit is
displayed by the system.
reduced during rainy weather on some
If the limit speed is exceeded, the dis-
types of roads, on vehicles equipped
play panel is modified to warn the driver.
with a navigation system, the system
can modify the limited speed after a few
seconds of wiping the windscreen.
Special situations
The system detects speed limit signs
The system does not take into account
on the side of the road and displays the
exceptional speed limit measures, such
speed limit on the instrument panel.
as peak pollution days.
It mainly uses information taken from
the camera 1, attached to the wind-
screen behind the rear view mirror.
2.88
DETECTION OF ROAD SIGNS (2/4)
– press the 4 or 5 control repeatedly
2
to reach the “Settings” menu and
press 6 OK;
– press the 4 or 5 control repeatedly to
reach the “DRIVING ASSIST” menu
and press 6 OK;
– press the 4 or 5 control repeatedly
to reach the “Speed alert” menu and
press 6 OK;
– press the 6 OK switch to activate or
3
4
deactivate the function:
=
function activated
<
6
5
function deactivated
Activating/deactivating the
With the function activated, depend-
ing on local regulations, you can acti-
system
vate the “Risk area display” option. The
system will notify you of the distance
Vehicles fitted with a multimedia
separating you from this zone, and
screen 2
while you are travelling in the zone.
To activate or deactivate the function,
refer to the multimedia instructions.
Vehicles not fitted with a multimedia
screen
Select “ON” or “OFF”.
– With the vehicle stopped, press the
switch 3 as many times as required
to reach the “Vehicle” tab;
2.89
DETECTION OF ROAD SIGNS (3/4)
If the speed limit is exceeded, the circle
7
8
around the panel flashes (7 warning
light) along with a sound signal to warn
the driver.
9
10
Operation
Varying the limit speed
If the speed limit notification differs from
Warning lights
the detected speed value, press and
The function displays the following
hold the following switches:
warning lights:
– 9 (RES/+) to increase the notification
7 Speed limit road signs.
speed to the detected speed;
– 10 (SET/-) to reduce the notification
8 Additional road signs (start or end
speed to the detected speed.
of “No overtaking” zone, slip road
speed limit, speed in case of a cara-
van, speed limit with length of appli-
cation, etc.).
2.90
DETECTION OF ROAD SIGNS (4/4)
Operating faults
The system cannot detect the speed
limit if:
– the windscreen is not clean;
– the camera is blinded by the sun;
– there is insufficient visibility (night,
fog etc.);
– the signs are not legible (snow, etc.)
or are hidden (by another vehicle or
by trees);
– the information taken from the navi-
gation system is not up to date.
This function is an additional driving aid. This function is not under any
circumstances intended to replace the due care and attention of the
driver, who should at all times be in control of the vehicle.
The driver should always adapt their speed to the traffic conditions, re-
gardless of the system indications.
The system detects speed limit signs and does not detect other signs (e.g. entry/
exit to/from urban areas, etc.).
The system may not detect all speed limit signs or may interpret them incorrectly.
The driver should not ignore signs that are not detected by the system and should,
as a priority, comply with the traffic signage and the highway code.
In the event of poor visibility (fog, snow, frost, etc.), it is possible that the system
may not indicate the correct speed to the driver.
The driver should always adapt their speed to the traffic conditions, regardless of
the system indications.
2.91

Related Topics

Popular Owner Manuals