2010-2016 Renault Scenic 4 Door Getting to know your vehicle -> CHILD SAFETY: choosing a child seat mounting User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Getting to know your vehicle -> CHILD SAFETY: choosing a child seat mounting for Your Renault Scenic 4 Door Third Generation (2010-2016)

CHILD SAFETY: choosing a child seat mounting (1/2)  
There are two ways of attaching child  
seats: via the seat belt or using the  
ISOFIX system.  
Attachment using the ISOFIX  
system  
Before using an ISOFIX  
child seat that you pur-  
chased for another vehicle,  
Authorised ISOFIX child seats are ap-  
proved in accordance with regulation  
ECE-R44 in one of the three following  
scenarios:  
– ISOFIX universal 3-point forward-  
facing seat;  
check that its installation is  
authorised. Consult the list of ve-  
hicles which can be fitted with the  
seat from the equipment manufac-  
turer.  
Attachment via the seat belt  
The seat belt must be adjusted to  
ensure that it is effective in the event of  
harsh braking or an impact.  
Ensure that the strap paths indicated  
by the child seat manufacturer are re-  
spected.  
– ISOFIX semi-universal 2-point seat;  
– specific.  
Always check that the seat belt is cor-  
rectly fastened by pulling it up, then  
pulling it out fully whilst pressing on the  
child seat.  
Check that the seat is correctly held by  
moving it from side to side and back  
to front: the seat should remain firmly  
fixed.  
For the latter two, check that your child  
seat can be installed by consulting the  
list of compatible vehicles.  
Attach the child seat with the ISOFIX  
locks, if these are provided. The ISOFIX  
system allows quick, easy, safe fitting.  
The ISOFIX system consists of 2 rings  
and, in some cases, a third ring.  
The seat belt must never  
be twisted or the tension  
relieved. Never pass the  
Check that the child seat has not been  
installed at an angle and that it is not  
resting against a window.  
shoulder strap under the  
arm or behind the back.  
Check that the seat belt has not  
been damaged by sharp edges.  
If the seat belt does not operate nor-  
mally, it will not protect the child.  
Consult an approved dealer. Do not  
use this seat until the seat belt has  
been repaired.  
Do not use the child seat  
if it may unfasten the seat  
belt restraining it: the base  
of the seat must not rest on  
the buckle and/or catch of the seat  
belt.  
No modifications may be  
made to the component  
parts of the restraint system  
(ISOFIX seat belts, seats  
and their mountings) originally fitted.  
1.33  
CHILD SAFETY: choosing a child seat mounting (2/2)  
The rings are located on the floor and  
indicated by markings on the luggage  
compartment carpet. To access these  
anchoring points, push the rear seat  
forward and lift the cover if necessary.  
4
3
1
Note: for 7-seater vehicles, the rings  
are located on the luggage compart-  
ment floor and are visible.  
6
5
In all cases, attach the strap hook to the  
corresponding ring (3 and 4 for the rear  
side seats and 5 or 6 for the rear centre  
seat) and place the seat in the desired  
position.  
2
Tighten the strap so that the child seat-  
back is in contact with the back of the  
vehicle seat. Do not make any further  
adjustments to the seat position set-  
tings.  
Attachment using the ISOFIX  
system (continued)  
The third ring 3, 4 and 5 (for long chas-  
sis versions) or 6 (for short chassis ver-  
sions) is used to attach the upper strap  
on some ISOFIX seats.  
The two rings 1 are located between  
the seatback and the seat base of the  
seat and are identified by a marking.  
To ensure your child seat can be easily  
fitted and locked on the rings 1, use  
access guides 2 on the child seat.  
The ISOFIX anchorage points have been exclusively designed for child  
seats with the ISOFIX system. Never fit a different type of child seat, seat  
belt or other objects to these anchorage points. Check that nothing is ob-  
structing the anchorage points.  
The child seat strap must  
be attached to the corre-  
sponding ring.  
Do not use any other  
mounting point.  
If your vehicle has been involved in a road accident, have the ISOFIX anchorage  
points checked and replace your child seat.  
1.34  

Related Topics

Popular Owner Manuals