FRONT HEADRESTS
To adjust side supports B
Depending on the vehicle, sections B
can be adjusted independently to the
desired position.
2
A
To remove the headrest
Raise it to its highest position (tilt the
seatback backwards if necessary).
Press button 1 on each rod 3 and lift it
until it is released.
B
B
1
3
To refit the headrest
Pull out the headrest rods 3 as far as
possible by pulling from the top. Take
care to ensure they are clean and cor-
rectly aligned and, if there are any prob-
lems, check that the notches are facing
forwards.
Insert the headrest rods into the holes
(tilt the seatback backwards if neces-
sary).
Lower the headrest until it locks, press
button 2 and lower the headrest as far
as possible.
Check that each rod 3 on the seatback
is securely locked.
To raise the headrest
Pull the headrest upwards to the de-
sired height.
The three upper positions can
be manipulated without pressing
button 2. However, it is preferable to
press this button to lower the head-
rest.
To lower the headrest
Press button 2 and guide the headrest
down to the desired height.
The headrest is an impor-
tant safety component:
ensure that it is in place and
To adjust the angle of the
headrest
Depending on the vehicle, move sec-
tion A towards or away from you to the
required position.
in the correct position. The
distance between your head and the
headrest and the distance between
the head and section A should be
as small as possible.
1.14
English 
