2010-2016 Renault Scenic 4 Door Getting to know your vehicle -> SEAT BELTS User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Getting to know your vehicle -> SEAT BELTS for Your Renault Scenic 4 Door Third Generation (2010-2016)

SEAT BELTS (1/3)  
Always wear your seat belt when trav-  
elling in your vehicle. You must also  
comply with the legislation of the par-  
ticular country you are in.  
Before starting, first adjust your driv-  
ing position, then ask all occupants  
to adjust their seat belts to ensure  
optimum protection.  
Adjusting your driving  
position  
1
– Sit well back in your seat (having  
first removed your coat or jacket).  
This is essential to ensure your back  
is positioned correctly;  
Make sure that the rear seats are  
locked in position properly so that  
the rear seat belts will operate effi-  
ciently. Refer to the information on  
“rear seat functions” and “adjusting  
the rear seats” in Section 3.  
– adjust the distance between the  
seat and the pedals. Your seat  
should be as far back as possible  
while still allowing you to depress  
the clutch pedal fully. The seatback  
should be adjusted so that your arms  
are slightly bent when you hold the  
steering wheel;  
– adjust the position of your head-  
rest. For maximum safety, your head  
must be as close as possible to the  
headrest;  
– adjust the height of the seat. This  
adjustment allows you to select the  
seat position which offers you the  
best possible view;  
– adjust the position of the steering  
wheel.  
2
Adjusting the seat belts  
Sit with your back firmly against the  
seatback.  
Seat belts which are incor-  
rectly adjusted or twisted  
may cause injuries in the  
event of an accident.  
Shoulder strap 1 should be as close as  
possible to the base of the neck but not  
on it.  
Use one seat belt per person,  
whether child or adult.  
Lap belt 2 should be worn flat over the  
thighs and against the pelvis.  
Even pregnant women should wear  
a seat belt. In this case, ensure that  
the lap belt is not exerting too much  
pressure on the abdomen, but do  
not allow any slack.  
The belt should be worn so that it is  
as close as possible to your body, ie.:  
avoid wearing heavy clothing or keep-  
ing bulky objects under the belts, etc.  
1.19  
SEAT BELTS (2/3)  
Driver’s seat belt reminder  
and, depending on the vehi-  
cle, front passenger seat belt re-  
minder  
ß
6
This lights up on the instrument panel  
when the engine is started, then, if the  
driver’s or front passenger’s seat belt  
(if this seat is occupied) is not fastened  
and the vehicle has reached approxi-  
mately 12 mph (20 km/h), it flashes and  
a bleep sounds for around 120 sec-  
onds.  
1
4
5
3
Note: an object placed on the passen-  
ger seat base may activate the warning  
light in some cases.  
5
Rear seat belt reminder (depending  
on vehicle)  
Locking  
Adjusting the height of the  
front seat belts  
Press button 6 to adjust the seat belt  
height so that shoulder strap 1 is worn  
as shown previously. Press button 6  
and raise or lower the seat belt. Make  
sure that the seat belt is locked in posi-  
tion correctly after you have adjusted it.  
Unwind the belt slowly and smoothly  
and ensure that buckle 3 locks into  
catch 5 (check that it is locked by pull-  
ing on buckle 3).  
If the belt jams, allow it to return slightly  
before attempting to unwind it again.  
If your seat belt is completely jammed,  
pull slowly, but firmly, so that just over  
3 cm unwinds. Allow it to return slightly  
before attempting to unwind it again.  
If there is still a problem, contact an ap-  
proved dealer.  
Warning light  
ß
lights up and, de-  
pending on the vehicle, it is accompa-  
nied by a message on the instrument  
panel for approximately 30 seconds  
each time the vehicle is started, a door  
is opened or a rear seat belt is fastened  
or unfastened. Check that the rear pas-  
sengers are wearing seat belts and that  
the number of seat belts shown as fas-  
tened corresponds to the number of  
rear seat places occupied.  
Unfastening  
Press button 4 and the seat belt will be  
rewound by the inertia reel. Guide the  
belt.  
1.20  
SEAT BELTS (3/3)  
The following information applies to the vehicle’s front and rear seat belts.  
– No modification may be made to the component parts of the originally fitted restraint system: belts, seats and their  
mountings. For special operations (e.g. fitting child seats), contact an authorised dealer.  
– Do not use devices which allow any slack in the belts (e.g. clothes pegs, clips, etc.): a seat belt which is worn too  
loosely may cause injury in the event of an accident.  
– Never wear the shoulder strap under your arm or behind your back.  
– Never use the same belt for more than one person and never hold a baby or child on your lap with your seat belt around  
them.  
– The belt should never be twisted.  
– Following an accident, have the seat belts checked and replaced if necessary. Always replace your seat belts as soon as  
they show any signs of wear.  
– Make sure that the buckle is inserted into the appropriate catch.  
– Ensure that no objects are placed in the area around the seat belt catch as they could prevent it from being properly se-  
cured.  
– When refitting the rear seats, make sure the seat belts are correctly positioned so that they can be used correctly.  
– Make sure the seat belt catch is properly positioned (it should not be hidden away, crushed or flattened by people or ob-  
jects).  
1.21  

Related Topics

Popular Owner Manuals