2009-2017 Seat Ibiza SUV Fuses and bulbs -> Fuses User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Fuses and bulbs -> Fuses for Your Seat Ibiza SUV Fourth Generation (2009-2017)

Fuses and bulbs  
WARNING  
Note  
Fuses and bulbs  
●
The high voltages in the electrical system can  
give serious electrical shocks, causing burns  
and even death!  
One component may have more than one  
fuse.  
Fuses  
●
Several components may run on a single  
fuse.  
●
Never touch the electrical wiring of the igni-  
tion system.  
Introduction  
●
Due to the constant updating of vehicles,  
fuse assignments based on equipment and  
the use of the same fuse for various electrical  
components, it is not possible to provide an  
up-to-date summary of the fuse positions for  
the electrical components at the time this  
manual was printed. For detailed information  
about the fuse positions, please consult a  
technical service.  
Take care not to cause short circuits in the  
electrical system.  
Vehicle fuses  
Read the additional information carefully  
WARNING  
›››  
page 25  
Using unsuitable fuses, repairing fuses or  
bridging a current circuit without fuses can  
cause a fire and serious injury.  
Only replace fuses with a fuse of the same  
amperage (same colour and markings) and  
size.  
»
●
Never use a fuse with a higher value. Only  
replace fuses with a fuse of the same amper-  
age (same colour and markings) and size.  
In general, a fuse can be assigned to various  
electrical components. Likewise, an electrical  
component can be protected by several  
fuses.  
●
Never repair a fuse.  
●
Never replace a fuse by a metal strip, staple  
or similar.  
Only replace fuses when the cause of the  
problem has been solved. If a newly inserted  
fuse blows after a short time, you must have  
the electrical system checked by a special-  
ised workshop as soon as possible.  
CAUTION  
To prevent damage to the vehicle's electric  
system, before replacing a fuse always turn  
off the ignition, the lights and all electrical  
elements and remove the key from the igni-  
tion.  
●
Additional information and warnings:  
●
Working in the engine compartment  
››› page 166.  
●
If you replace a fuse with higher-rating  
fuse, you could cause damage to another part  
of the electrical system.  
●
Protect the fuse boxes when open to pre-  
vent the entry of dust or humidity as they can  
damage the electrical system.  
195  
Advice  
Identifying fuses situated below the driver-  
side dash panel by colours  
To replace a fuse  
Note  
●
Remove the fuse.  
In the vehicle, there are more fuses than  
those indicated in this chapter. These should  
only be changed by a specialised workshop.  
●
Replace the blown fuse by one with an  
Colour  
Grey  
Amp rating  
identical amperage rating (same colour and  
markings) and identical size ›››  
2
3
.
Purple  
Light brown  
Brown  
Red  
●
Replace the cover again or close the fuse  
Replacing a blown fuse  
box lid.  
5
7.5  
10  
15  
20  
25  
CAUTION  
If you replace a fuse with higher-rating fuse,  
you could cause damage to another part of  
the electrical system.  
Blue  
Yellow  
White or trans-  
parent  
Changing the bulbs  
Green  
30  
40  
General notes  
Orange  
Fig. 173 Image of a blown fuse  
Before changing any bulb, first turn off the  
failed device.  
Preparation  
CAUTION  
●
Switch off the ignition, lights and all elec-  
trical equipment.  
Do not touch the glass part of the bulb with  
your bare hands. The fingerprints left on the  
glass will vaporise as a result of the heat gen-  
erated by the bulb, reducing bulb life and  
causing condensation on the reflector sur-  
face, thus reducing effectiveness.  
●
Always carefully remove the fuse box cov-  
ers and refit them correctly to avoid problems  
with your vehicle.  
●
Open the corresponding fuse box  
●
››› page 195.  
Protect the fuse boxes when open to avoid  
the entry of dust or humidity. Dirt and humid-  
ity inside fuse boxes can cause damage to  
the electrical system.  
Identifying a blown fuse  
A bulb must only be replaced by one of the  
same type. The type is indicated on the bulb,  
either on the glass part or on the base.  
A fuse is blown if its metal strip is ruptured  
››› Fig. 173.  
Point a lamp at the fuse. This will make it  
easier to see if the fuse is blown.  
Below, the light source used for all functions  
is broken down.  
196  

Related Topics

Popular Owner Manuals