Get Keys and doors -> Alarm system Guide for Subaru XV SUV Second Generation (2017-2022)

2-24

Keys and doors/Alarm system

NOTE

& Battery drainage prevention

Alarm system

function

. The default setting for this function

S02AF

is set as <operational=. The operational/

S02AC03

If a door or the rear gate is not completely

The alarm system helps to protect your

non-operational setting of this function

closed, the interior lights will remain

vehicle and valuables from theft. The horn

can be changed by a SUBARU dealer.

illuminated as a result. However, several

sounds and the hazard warning flashers

Contact your SUBARU dealer to

lights are automatically turned off by the

flash if someone attempts to break into

change the setting.

battery drainage prevention function to

your vehicle.

. When leaving the vehicle, please

prevent the battery from discharging. The

make sure that all doors and the rear

For models with <keyless access with

following interior lights are affected by this

gate are completely closed.

push-button start system=:

function.

. The battery drainage prevention

The system can be armed or disarmed

function does not operate while the

with the keyless access function or access

Switch

Automatically turning

Item

key is in the ignition switch.

position

off

key fob.

The system will not be activated when the

Approximately 20

Map lights

DOOR

minutes later

push-button ignition switch is in the <ACC=

or <ON= position.

Approximately 20

Dome light

DOOR

minutes later

For models without <keyless access

Ignition

Approximately 20

with push-button start system=:

switch light

minutes later

The system can be armed or disarmed

Cargo area

Approximately 20

with the remote transmitter.

DOOR

light

minutes later

The system will not be activated when the

key is inserted into the ignition switch.

Your vehicle9s alarm system has been set

for activation at the time of shipment from

the factory. You can set the system for

deactivation yourself or have it done by

your SUBARU dealer.

2-25

Keys and doors/Alarm system

NOTE

& Alarm system operation

The notifications regarding the map

lights, dome light and cargo area light

S02AF01

When the alarm system is armed, it is

are deactivated as the factory setting. A

triggered by the opening any of the doors

SUBARU dealer can activate the sys-

or the rear gate.

tem. Contact your SUBARU dealer for

The alarm system will activate the follow-

details.

ing alarms when triggered.

. The vehicle9s horn will sound for 30

& Arming the system

seconds.

S02AF04

The alarm system becomes armed when

. The hazard warning flashers will flash

the following operation is performed.

for 30 seconds.

1. Close all windows and the moonroof (if

If any of the doors or the rear gate remains

equipped) and turn the ignition switch to

open after the 30-second period, the horn

the <OFF= position.

will continue to sound for a maximum of 3

2. Carry the key and get out of the

minutes. If the door or the rear gate is

Security indicator light

vehicle.

closed while the horn is sounding, the horn

3. Lock the doors using any of the

All doors and the rear gate will lock, an

will stop sounding with a delay of up to 30

following methods.

electronic chirp will sound once, the

seconds.

. Locking using the remote keyless

hazard warning flashers will flash once,

NOTE

entry system. For details, refer to

and the security indicator light will start

<Remote keyless entry system= F2-17.

The alarm system can be set to trigger

flashing rapidly.

. Locking using the keyless access

the illumination of the following interior

4. Approximately 30 seconds later, the

function (if equipped). For details, refer

lights.

system will enter surveillance state.

to <Locking with the door lock sensor=

. Map lights (illuminates only when

the door interlock switch is in the

When the system is in surveillance state,

F2-8.

. Locking using the power door lock-

<DOOR= position)

the security indicator light will then flash

ing switch. For details, refer to <Locking

. Dome light (illuminates only when

slowly (twice approximately every 2 sec-

using power door locking switch= F2-

the dome light switch is in the <DOOR=

onds), indicating that the system has been

22.

position)

armed for surveillance.

. Cargo area light (illuminates only

when the cargo area light switch is in

the <DOOR= position)

3 CONTINUED 3

2-26

Keys and doors/Alarm system

NOTE

3 The ignition switch is turned to

battery is too weak), you can disarm the

the <ON= position (models without

system without using the access key fob/

. The system can be armed even if the

<keyless access with push-button

remote transmitter.

engine hood, windows and/or moon-

start system=).

roof are open. Always make sure that

The system can be disarmed if you turn the

they are fully closed before arming the

3 Push-button ignition switch is

ignition switch from the <LOCK=/<OFF= to

system.

turned to the <ACC= position (mod-

the <ON= position with a registered key/

. When arming the system, if any of

els with <keyless access with push-

access key fob.

the doors or the rear gate is not fully

button start system=).

NOTE

closed, an electronic chirp sounds five

& Disarming the system

For models with <keyless access with

times, the hazard warning flashers

S02AF05

push-button start system=, if the ac-

flash five times to alert you that the

Perform either of the following procedures.

cess key fob battery is discharged,

doors (or the rear gate) are not properly

. Briefly press a button (for less than 2

perform the procedure described in

closed. When you close the door, doors

seconds) on the access key fob/remote

<Switching power status= F9-17. In

will automatically lock and the system

transmitter.

such a case, replace the battery im-

will automatically arm in 30 seconds.

. Carry the access key fob and perform

mediately. Refer to <Replacing battery

. The 30-second standby time can be

either of the following procedures (models

of access key fob= F11-43.

eliminated if you prefer. Have it per-

with <keyless access with push-button

formed by your SUBARU dealer.

start system=).

. If any of the following actions is

& Alarm system setting

3 Grip the front door handle.

done during the standby period, the

S02AF11

3 Press the rear gate opener button.

To change the setting of your vehicle9s

system will not switch to the surveil-

3 Unlock using the PIN code access.

alarm system for activation or deactiva-

lance state.

tion, do the following.

3 Doors (including the rear gate)

The flashing of the security indicator light

1. Disarm the alarm system. Refer to

are unlocked using the access key

will then change slowly (once approxi-

<Disarming the system= F2-26.

fob/remote transmitter.

mately every 3 seconds from twice ap-

2. Sit in the driver9s seat and shut all

3 Doors (including the rear gate)

proximately every 2 seconds), indicating

doors and the rear gate.

are unlocked using the keyless

that the alarm system has been disarmed.

access function (models with <key-

3. Turn the ignition switch to the <ON=

! Emergency disarming

less access with push-button start

position.

S02AF0501

system=).

If you cannot disarm the system using the

4. Hold down < = of the driver9s power

access key fob/transmitter (i.e. the trans-

3 Any door (including the rear gate)

door locking switch, open the driver9s door

mitter is lost, broken or the transmitter

is opened.

within the following 1 second, and wait 10

2-27

Keys and doors/Alarm system

& If you have accidentally trig-

& Valet mode

seconds without releasing the switch. The

setting will then be changed as follows.

gered the alarm system

S02AF06

When you choose the valet mode, the

S02AF03

alarm system does not operate. In valet

. Type A combination meter

! To stop the alarm

mode, the remote transmitter is used only

S02AF0301

Do any of the following operations:

for locking and unlocking the doors and

Setting

Combination

Horn

status

meter display

. Press any button on the access key fob/

rear gate and panic activation.

remote transmitter.

Activate

ALon

Once

To enter the valet mode, change the

. Turn the ignition switch to the <ON=

Deactivate

ALoF

Twice

setting of your vehicle9s alarm system for

position (models without <keyless access

deactivation mode. Refer to <Alarm system

with push-button start system=).

. Type B combination meter

setting= F2-26. The security indicator light

. Turn the push-button ignition to the

will continue to flash once every 3 seconds

Setting

Combination

<ACC= position (models with <keyless

Horn

indicating that the system is in the valet

status

meter display

access with push-button start system=).

mode.

Activate

AL ON

Once

NOTE

To exit valet mode, change the setting of

Deactivate

AL OFF

Twice

Only registered keys will stop the

your vehicle9s alarm system for activation

NOTE

alarm. If the immobilizer transponder

mode. Refer to <Alarm system setting= F2-

is not registered, the alarm will not

26.

You may have the above setting change

stop.

done by your SUBARU dealer.

Keys and doors -> Alarm system for Your Subaru XV SUV Second Generation (2017-2022)

Related Topics

Popular Owner Manuals

Latest Owner Manuals