1-32
Seat, seatbelt and SRS airbags/Child restraint systems
& Installing a booster seat
press the release button on the seatbelt
buckle and allow the belt to retract
S01AG05
completely. The belt will return to the
ELR mode.
If you have installed a child restraint
system for the rear center seating posi-
tion, when you remove the child restraint
system, the seatbelt may not be restored
to the ELR mode even if the seatbelt is
retracted. In this case, lower the head
restraint to the retracted position to allow
the seatbelt to retract moreover. The
seatbelt will return to the ELR mode.
4. To remove the booster seat, press the
Remember that the head restraint is not
release button on the seatbelt buckle and
1. Place the booster seat in the rear
intended to be used at the lowest position
allow the belt to retract.
seating position and sit the child on it.
(retracted position). Therefore, when the
The child should sit well back on the
rear center seat is occupied (including
booster seat.
WARNING
when a child restraint system is installed)
2. Run the lap and shoulder belt through
next time, be sure to raise the head
. Never use a belt that is twisted or
or around the booster seat and the child
restraint to the extended position.
reversed. In an accident, this can
following the instructions provided by its
increase the risk or severity of
NOTE
manufacturer.
injury to the child.
3. Insert the tongue plate into the buckle
When the child restraint system is no
. Never place the shoulder belt
until you hear a click. Take care not to twist
longer in use, remove it and restore the
under the child9s arm or behind
the seatbelt.
ELR function of the retractor. That
the child9s back. If an accident
function is restored by allowing the
Make sure the shoulder belt is positioned
occurs, this can increase the risk
seatbelt to retract fully.
across the center of child9s shoulder and
or severity of injury to the child.
that the lap belt is positioned as low as
possible on the child9s hips.
. The seatbelt should fit snugly in
order to provide full restraint.
Loose fitting belts are not as
English 
