1-8
Seat, seatbelt and SRS airbags/Seats
To install:
fold down in the event of sudden
! Front seats
braking, or objects may move out
S01AQ0401
Install the head restraint into the holes that
Both the driver9s seat and the front
from the cargo area, which could
are located on the top of the seatback until
passenger9s seat are equipped with head
cause serious injury or death.
the head restraint locks. Press and hold
restraints. Both head restraints are adjus-
the release button to lower the head
table in the following ways.
restraint.
& Head restraints
! Height adjustment
S01AQ040101
S01AQ04
WARNING
The front seat head restraints are
designed to be installed into the
front seats only. The rear seat head
restraints are designed to be in-
stalled into the rear seats only. Do
not attempt to install the front seat
head restraints into the rear seats, or
the rear seat head restraints into the
front seats.
Each head restraint should be adjusted so
1)
Head restraint
that the center of the head restraint is
NOTE
2)
Release button
closest to the top of the occupant9s ears.
It is possible to adjust the angle of the
To raise:
NOTE
front seat head restraints only. When
Pull the head restraint up.
installing the front seat head restraints,
When the head restraint cannot be
To lower:
make sure that the angle of the head
pulled out or installed due to insuffi-
restraints can be adjusted.
Push the head restraint down while press-
cient clearance between the head re-
ing the release button on the top of the
straint and the roof, tilt the seat and
seatback.
then perform the installation and re-
To remove:
moval tasks.
While pressing the release button, pull out
the head restraint.