Get OPERATING YOUR VEHICLE -> Cruise control (if equipped) Guide for Suzuki Jimny SUV Fourth Generation (2018-2026)

There may be a case that it is difficult to From "4L" position to "4H" position

operate the transfer lever or the gear

noise occurs after driving the vehicle for

a while in the cold weather. There may

be a possibility of difficulty to shift the

transfer lever from "4H" position to "4L"

position. In this case, shift the transfer

lever into "4H" position or "2H" position

and then operate the transfer lever again

after driving for a while.

78RB03028

Stop the vehicle completely, place the

transmission in "N" (Neutral) or depress

the clutch pedal fully (if equipped), then

shift the transfer lever from "4L" position to

"4H" position.

OPERATING YOUR VEHICLE

Cruise control (if equipped)

The cruise control system allows you to

maintain a steady speed without keeping

your foot on the accelerator pedal. The

controls for operating the cruise control

system are on the steering wheel.

You can use the cruise control system

under the following conditions:

For manual transmission vehicle, the

gear position is in 3rd, 4th, 5th.

For automatic transmission vehicle, the

gearshift lever is in "D" position.

When the transfer lever is in "2H" or "4H"

position,

When 4WD indicator light does not blink,

The vehicle speed is about 40 km/h (25

mph) or higher.

A, WARNING

To help avoid loss of vehicle control,

do not use the cruise control system

when driving in heavy traffic, on slip-

pery or winding roads, or on steep

downhills.

3-22

OPERATING YOUR VEHICLE

Setting cruising speed

Cruise control switch

(1)

(1) Cruise switch

(2) "CANCEL" switch

(3) "RES +/SET-" switch

(4) Cruise indicator light

(5) "SET" indicator light

3-23

52RM30190

75RM329

78R803029

(6) Cruise indicator

(7) Set indicator

1) Turn on the cruise control system by

pushing cruise switch (1). When the

cruise indicator light (4) (type A) or

cruise indicator (6) (type B) comes on,

you can set cruising speed.

2) Accelerate or decelerate to the desired

speed.

3) Push down the "RES +/SET -" switch

(3) and turn on the "SET" indicator light

(5) (type A) or set indicator (7) (type B).

Take your foot off the accelerator pedal

and the set speed will be maintained.

A WARNING

If the cruising speed is set by acci-

dent, you cannot decelerate or could

loose control of the vehicle. This

could lead to an accident, resulting in

severe injury or death.

Turn off the cruise control system

and check that cruise indicator (6) is

off when the system is not in use.

Changing speed temporarily

When the cruising speed is maintained, you

can temporarily accelerate or decelerate.

To accelerate, depress the accelerator

pedal. When you take your foot off the pedal,

your vehicle will return to the set speed.

To decelerate, depress the brake pedal.

The set speed will be canceled and "SET"

indicator light (5) or set indicator (7) will go

off.

To resume the previously set speed, push

up the "RES +/SET -" switch (3) and turn

on "SET" indicator light (5) or set indicator

(7) again when vehicle speed is above 40

km/h (25 mph). The vehicle will accelerate

to the previously set speed and maintain

its speed.

Changing cruising speed

Using the accelerator pedal

To reset at a faster cruising speed, acceler-

ate to the desired speed using the accelera-

tor pedal and push down the "RES +/SET-"

switch (3). The new speed will be main-

tained.

Using the brake pedal

To reset at a slower cruising speed, decel-

erate to the desired speed using the brake

pedal and push down the "RES +/SET -"

switch (3). The new speed will be main-

tained.

NOTE:

When the brake pedal is depressed, "SET"

indicator light (5) or set indicator (7) goes

off until the cruising speed is reset.

Using "RES +/SET-" switch

To reset at a faster cruising speed, press

repeatedly or hold push up the "RES +/

SET -" switch (3). Vehicle speed will

steadily increase. When you release the

switch, the new speed will be maintained.

To reset at a slower cruising speed, press

repeatedly or hold push down the "RES +/

SET -" switch (3) until the vehicle has

slowed to the desired speed, and then

release the switch. The new speed will be

maintained.

NOTE:

You can adjust the set speed by approxi-

mately 1 km/h (1 mph) by pushing "RES +/

SET-" switch quickly

Cancelling cruise control

"SET' indicator light (5) or set indicator (7)

will go off and the cruise control will be

canceled temporarily with the following

conditions:

Push "CANCEL" switch (2).

Depress the brake pedal.

For manual transmission vehicle, depress the

clutch pedal.

For automatic transmission vehicle, the

gear position is changed to "L"

When the transfer lever is operated,

The vehicle speed falls more than about

20 percent from the set speed.

Any time the vehicle speed falls below

40 km/h (25 mph).

When the vehicle skids and ESP® is

activated.

To resume the previously set speed, push

up the "RES +/SET-" switch (3) and turn

on "SET' indicator light (5) or set indicator

(7). The vehicle speed must be above 40

km/h (25 mph) when the vehicle is not

under the above conditions.

OPERATING YOUR VEHICLE

To turn off the cruise control system, push

cruise switch (1) and check that the cruise

indicator light (4) or cruise indicator (6)

goes off.

Also, if the malfunction indicator light in the

instrument cluster comes on or blinks, the

cruise control system will be turned off.

NOTE:

If you turn off the cruise control system, the

previously set speed in the memory is

cleared. Reset your cruising speed again.

3-24

OPERATING YOUR VEHICLE -> Cruise control (if equipped) for Your Suzuki Jimny SUV Fourth Generation (2018-2026)

Related Topics

Popular Owner Manuals

Latest Owner Manuals