Get Keys and Doors -> Wireless remote control Guide for Toyota Aurion 4 Door First Generation (2006-2012)

KEYS AND DOORS

Wireless remote control—

For your Toyota dealer to make you a new

key with a built-in transponder chip, your

dealer will need your key number and key

(vehicles with standard-type ignition switch)

or electronic key (vehicles with smart entry

and start system). However, there is a limit

to the number of additional keys your Toyota

dealer can make for you.

If you make your own duplicate key, you

will not be able to cancel the system or

start the engine.

NOTICE

Vehicles with standard-type ignition switch

Do not modify, remove or disassemble

the engine immobiliser system. If any

unauthorised changes or modifications

are made, proper operation of the sys-

tem cannot be guaranteed.

Vehicles with smart entry and start system

1. Lock switch

2. Unlock switch

3. Alarm switch

4. Boot lid open switch

5. Indicator light

The wireless remote control system is

designed to lock or unlock all the doors,

open the boot lid, or activate the alarm

system

from

distance

within

approximately 1 m of the vehicle.

The remote control cannot be used when the

key is in the ignition switch (vehicles with

standard-type ignition switch) or the ignition

switch is set to ACC or ON (vehicles with

smart entry and start system).

KEYS AND DOORS

When you operate any switch, press it slowly

and securely. On vehicles with smart entry

and start system, the indicator light will flash

once.

NOTICE

To avoid the possibility of theft or an ac-

cident causing serious injury, contact

your Toyota dealer as soon as you lose

your wireless remote control trans-

mitter. See “If you lose your wireless re-

mote control transmitter” on page 236

in Section 4.

The wireless remote control transmitter is an

electronic component.

NOTICE

Observe the following instructions to

avoid damage to the wireless remote

control transmitter:

It is possible to disable the wireless remote

control system. For details, contact your

Toyota dealer.

D Do not leave the remote control in

places where the temperature be-

comes high such as on the dashboard.

D The remote control should only ever

be disassembled for battery replace-

ment.

D Avoid knocking the remote control

hard against other objects or drop-

ping it.

D Avoid immersing it in water.

Additional wireless remote control trans-

mitters are available. Contact your Toyota

dealer for detailed information.

If the wireless remote control transmitter

does not operate correctly.

D Check if you are close to radio transmis-

sion towers or powerful transmission de-

vices such as radio stations, mobile

towers, CB radios or airports. If you are,

try using the remote control in a different

location.

D The battery may have been discharged.

Check the battery in the transmitter. To

replace the battery, see “Replacing trans-

mitter battery (with standard-type ignition

switch)” on page 21, or “Replacing trans-

mitter battery (with smart entry and start

system)” on page 23 in this Section.

KEYS AND DOORS

—Locking and unlocking doors

Locking operation (vehicles with standard-

type ignition switch)

Unlocking operation (vehicles with smart

entry and start system)

To lock and unlock all the doors, press the

switches slowly and securely.

To lock: Press the lock switch. All the doors

are locked simultaneously. At this time, one

beep will sound and the turn signal lights

flash once.

Check to see that all the doors are securely

locked.

If any door is not securely closed, or if the

key is in the ignition switch (with standard-

type ignition switch) or key left in the vehicle

(vehicles with smart entry and start system),

locking cannot be performed by the lock

switch and a beep will sound continuously for

10 seconds.

Locking operation (vehicles with smart entry

and start system)

To stop the beep, take out the key from the

vehicle or press the unlock switch.

The answerback function can be changed.

For details, contact your Toyota dealer.

To unlock: Press the unlock switch. All the

doors are unlocked simultaneously. At this

time, two beeps will sound and the turn signal

lights flash twice.

When you unlock the doors using the wire-

less remote control, the illuminated entry

function will be activated. For further informa-

tion, see “Illuminated entry system” on page

95 in Section 1--5.

Unlocking operation (vehicles with stan-

dard-type ignition switch)

Keys and Doors -> Wireless remote control for Your Toyota Aurion 4 Door First Generation (2006-2012)

Related Topics

Keys and Doors

Popular Owner Manuals

Latest Owner Manuals