Lights -> Lighting for Your Volkswagen Touareg SUV Third Generation (2018-2025)

WARNING  
Lights  
Incorrect use of turn signals, not using them  
or forgetting to turn them off can confuse  
other road users. This can lead to accidents  
and serious injury.  
Turn signals  
Switching the indicators on and off  
Always signal lane changes and  
overtaking and turning manoeuvres in  
good time by means of intermi- tents.  
Switch off the indicator ane  
changing, overtaking an
manoeuvres have been co
Emergency flashers also
gnition switched
p. 84.  
Fig. 106 On the left-hand side of the steering  
column: Indicator and indicator lever.  
Switch on the ignition.  
Move the indicator lever and high bea
lever from the centre position to the desired  
position:  
lights on and off  
A
B
The right-hand indicator is
The left-hand indicator
Move the lever to the
disengage the indica
If an acoustic signal d
indicators are switched
specialist workshop and
Fig. 107 Next to the steering wheel: light control  
(one variant).  
Comindicatrs  
Tse the comfort indicator, mov
icator and hazard warning light lever up or  
wn only to the point wheit offers resistance  
d then release it. The intor flashes three  
es.  
Switch on the lights  
Switch on the ignition.  
Turn the light control knob to the  
corresponding position:  
Automatic dipped beam switching: The  
dipped beam is switched on and off  
Tengage the comfort icator ahead of  
timeediately move lever in the opposite  
directiohe point ere it offers resistance  
and release it
ambient  
,
automatically depending on  
and weather →  
brightness  
The comfort function of the direction indicators  
Position light and daytime running lights on.  
is  
can be deactivated in a specialist  
workshop.  
The symbol on the control unit lights up.  
of in green.  
Low beam on.  
128  
Instruction manual  
 
Switching off the lights  
The rear lamps are not included in the  
daytime running lamps. A vehicle without its  
rear lamps on cannot be seen by other road  
users in the event of darkness, precipitation  
or poor visibility.  
Switch off the ignition.  
Turn the light control knob to the  
corresponding position:  
The lights are off.  
The "Leaving Home" function (outdoor  
orientation lighting) can be activated p.  
133.  
Parking light or parking light on both sides  
on page 132. The symbol in the control  
unit lights up green.  
Low beam off. As long as the key remains  
in the ignition lock or, in vehicles with  
Keyless Access, as long as the driver's  
door remains closed, the dipped beam  
remains on.  
WARNING  
Automatic activation of the dipped beam  
( ) switches the low beaon and off only when light  
conditions change.  
In special weather fog,  
switch on the dipp
When engaging revstatic  
nering light may lboth sides.  
of the le to better illuthe  
the mauvre  
surroundiuring  
.
Daytime running lights  
Daytime running lamps, fitted depending on
equipment, can increase the visibility o
vehicle when driving in daylight.  
hing fog ts on ad off  
The daytime running lights are swit
each time the ignition is switched on if
og lamps can be switched on with the light  
trol in position , (position light) or (dipped  
beam) with the ignition switched on.  
Switch on the fog lamps : Press the key.  
fig. 107. The indicator light in the button  
ghts up green.  
control is in the position  
tected).  
, or (if brightness i
Daytime running lights citched on or  
off manually.  
ch on the fog light : Press the button  
. The control lamp on the button lights up.  
In addition, the yellow control lamp lights  
up on the control panel.  
WARNIN
If the road is n
cannot see th
difficulty, accid
occur.  
To switch off the fog lamps, press the  
corresponding button again.  
ssistants
the driver is respohat  
the correct lights are s
When the automatic dipped-beam headlamp  
is switched on, the following lights up  
The dipped-beam headlamps or the fog lamp  
also switch on regardless of the ambient  
brightness.  
Always switch on the dipped beam in the  
event of darkneprecipitation or poor  
WARNING  
On vehicles fitted ex-factory with  
towing device, the vehicle's fog lamp is  
automatically switched off when a trailer with a  
built-in rear fog lamp is electrically connected to  
it  
The position light daytime running lights  
do not illuminate ough to illuminate the road  
l enough to seen by other road users.  
Atch on the dipped beam in the  
event of darkness, precipitation or poor  
p. 278.  
Light  
129  
When the "Coming Home" function is activated,  
no acoustic signal sounds when the vehicle is  
Functions of the lights  
on.  
started to indicate that the lights are still  
Position light  
When the light control is set to the position, the  
position lights in both headlamps, certain areas  
of the rear light clusters, the number plate light  
and the light in the centre console buttons and  
the instrument panel buttons are switched on. If  
the ignition is switched on , the daytime running  
lights are also switched on.  
Road light  
Switching the main on and  
off  
When the parking light is on, the indicator light  
lights up yellow in the instrument cluster.  
Automatic dipped beam switchin  
g
When the headlamp control is in the position ,  
the low beam and the instrument and control  
panel lighting are switched on and off  
automatically depending on the existing light  
conditions. When the lights are switched on, the  
yellow indicator light in the light control comes  
on.  
The automatic dipped beam function is only
auxiliary function and cannot always identif
driving situations with sufficient precision.  
e left-hand side of the steering  
cator and indicator lever.  
ch on the ignition and switch on the cross  
Static curve light  
p.  
When turning slowly or when cply,  
a static cornering light com
Mohe indicator and high beam lever  
from centre position to the desired  
position:  
Dynamic bend lighting
In bends, self-directio
provide better illumina
is not a bend). The dyn
works if the dipped bea
vehicle is driving faster th
10 kmm
The main beam comes on.  
The light flashes are activated or the main  
beam is switched off. The light flashes  
remain on as long as the lever is pulled.  
When the high beam is on, the blue indicator  
light is illuminated in the instrument cluster.  
Tdynamic bend lighting can be
d off.  
Adjust  
ate in the menu  
nment.  
of he info-system  
High beam assistant  
Depending on the equipment, the vehicle may be  
equipped with a high beam assistant.  
ible signals to warn thghts have not  
bswitched off  
p. 131.  
Whee key is removeom the ignition  
switch e driveror is opened, warning  
signals souncases described below:  
If the main-beam headlamp is not used  
correctly, accidents and serious injuries could  
occur because it can distract and dazzle other  
road users.  
If the parking light is switched on.  
If the light control is in the position .  
130  
Instruction manual