Connect the pressure gauge to the wheel cylinder (rear). Unscrew
the bleeder valve for this. Operate the brake pedal with
enough pressure to achieve the inlet pressure (see signboard of
braking force regulator), then adjust the outlet pressure.
After the check, bleed the brake system. Tighten the bleeder
valve by MA=4,9+1Nm.
With the specified axle loads, every pressure within the
tolerance limits is permitted (e. g. 600 - 630 kg = 4-7 bar).
General
note:
We recommend
that the attachment manufacturers/equipment suppliers add appropriate
service
instructions and - if required - operating instructions to their supply scope of the
vehicle.
Note: Subject to errors and technical amendments. The electronic
version of the body guidelines is the decisive source of up-to-date data on body guidelines
(online body
guidelines). Data status August 2007
25
English 