Advertisement

Advertisement

Driving -> Distraction detection for Your Citroen Berlingo SUV Third Generation (2018-2025)

Driving  
labels or other objects; they may hamper  
correct operation of the system.  
break after two hours of driving at a speed above  
43 mph (70 km/h).  
This alert is issued via the display of a message  
encouraging the driver to take a break,  
accompanied by an audible signal.  
If the driver does not follow this advice, the alert  
is repeated hourly until the vehicle is stopped.  
The system resets itself if one of the following  
conditions is met:  
Distraction detection  
For more information, refer to the  
General recommendations on the use  
of driving and manoeuvring aids.  
– With the engine running, the vehicle has been  
stationary for more than 15 minutes.  
– The ignition has been switched off for a few  
minutes.  
– The driver's seat belt is unfastened and their  
door is opened.  
Depending on version, the function consists of  
either the "Coffee Break Alert" system alone or  
combined with the "Driver Attention Warning"  
system.  
The system assesses the driver's level of  
alertness, fatigue and distraction by  
identifying trajectory changes in relation to the  
lane markings.  
To do this, the system uses a camera, placed on  
the upper part of the windscreen.  
This system is particularly suited to fast roads  
(speed higher than 43 mph (70 km/h)).  
At a first alert level, the driver is warned by the  
message "Be vigilant!", accompanied by an  
audible signal.  
These systems are in no way designed  
to keep the driver awake or to prevent  
the driver from falling asleep at the wheel.  
It is the driver’s responsibility to stop if feeling  
tired.  
As soon as the speed of the vehicle  
drops below 43 mph (70 km/h), the  
system goes into standby.  
Driving time starts being counted again once  
the speed reaches above 43 mph (70 km/h).  
Take a break if you are feeling tired or at least  
every 2 hours.  
After three first-level alerts, the system triggers  
a further alert with the message "Dangerous  
driving: take a break", accompanied by a more  
pronounced audible signal.  
Driver Attention Warning  
Depending on version, the Coffee Break Alert  
system may be combined with the Driver  
Attention Warning system.  
Activation/Deactivation  
The settings are changed via the  
Driving/Vehicle touch screen  
menu.  
The status of the function is saved when the  
ignition is switched off.  
The following situations may interfere  
with the operation of the system or  
prevent it from working:  
– poor visibility conditions (e.g. insufficient  
road lighting, snowfall, heavy rain, dense fog).  
– dazzle (e.g. headlamps of an oncoming  
vehicle, low sun, reflections on a wet road  
Coffee Break Alert  
The system triggers an alert when it  
detects that the driver has not taken a  
160  
Driving  
surface, leaving a tunnel, alternating light and  
shade).  
6
– windscreen area located in front of the  
camera: dirty, misted, frost-covered, snow-  
covered, damaged or covered by a sticker.  
– lane markings absent, worn, hidden (snow,  
mud) or multiple (roadworks).  
Depending on version, in the example shown,  
– close to the vehicle in front (lane markings  
not detected).  
– narrow or winding roads.  
only the obstacles present in the shaded area  
will be signalled by the audible assistance.  
The proximity information is given by an  
intermittent audible signal, the frequency of  
which increases as the vehicle approaches the  
obstacle.  
When the distance between the vehicle and  
the obstacle becomes less than about thirty  
centimetres, the audible signal becomes  
continuous.  
This system detects and signals the proximity of  
obstacles (e.g. pedestrian, vehicle, tree, barrier)  
using sensors located in the bumper.  
In certain driving conditions (poor road  
surface or strong winds), the system may  
give alerts independent of the driver's level of  
vigilance.  
Rear parking sensors  
► Engage reverse gear to start the system  
(confirmed by an audible signal).  
The system is switched off when reverse gear is  
disengaged.  
The following situations may interfere  
with the operation of the system or  
prevent it from working:  
– lane markings absent, worn, hidden (snow,  
mud) or multiple (roadworks);  
The sound emitted by the speaker (right or  
left) indicates the side on which the obstacle is  
located.  
Audible assistance  
– close to the vehicle ahead (lane markings  
not detected);  
Adjusting the audible signal  
Depending on version, with  
– roads that are narrow, winding, etc.  
CITROËN Connect Radio or  
CITROËN Connect Nav, pressing this button  
opens the window for adjusting the volume of  
the audible signal.  
Parking sensors  
The system signals the presence of obstacles  
which are both within the sensors’ detection zone  
and in the vehicle path defined by the direction of  
the steering wheel.  
For more information, refer to the  
General recommendations on the use  
of driving and manoeuvring aids.  
161