Advertisement

Advertisement

Driving -> Park Assist for Your Citroen Berlingo SUV Third Generation (2018-2025)

Driving  
This view is only available via the view selection  
menu.  
The system assists with the following  
manoeuvres:  
Selecting the type of manoeuvre  
6
A. Entering a "parallel" parking space  
B. Leaving a "parallel" parking space  
C. Entering a "bay" parking space  
Park Assist  
Operation  
► When approaching a parking area, reduce  
the speed of your vehicle to 19 mph (30 km/h)  
or less.  
For more information, refer to the  
General recommendations on the use  
of driving and manoeuvring aids.  
Activating the function  
This system provides active parking assistance:  
it detects a parking space and then steers in the  
appropriate direction to park in the space while  
the driver controls the driving direction, gear  
changes, acceleration and braking.  
A manoeuvre selection page is displayed on the  
touch screen: by default, the "Entry" page if the  
vehicle has been running since the ignition was  
switched on, otherwise, the "Exit" page.  
► Select the type and side of the manoeuvre to  
activate the parking space search.  
The selected manoeuvre can be changed at  
any time, even while searching for an available  
space.  
The function is activated in the  
Vehicle/Driving touch screen  
menu.  
Select "Park Assist".  
To help the driver monitor the manoeuvre, the  
system automatically triggers the display from  
the Top Rear Vision function and activates the  
parking sensors.  
The system measures the available parking  
spaces and calculates the distances to obstacles  
using ultrasonic sensors built into the front and  
rear bumpers of the vehicle.  
Activating the function deactivates the  
Blind spot monitoring system.  
You can deactivate the function at any  
time until the parking space entry or exit  
manoeuvre begins, by pressing the arrow  
located in the top left-hand corner of the  
display page.  
This indicator lamp comes on to confirm  
the selection.  
Parking space search  
You should drive at a distance of between  
0.50 m and 1.50 m from the row of parked  
vehicles, without ever exceeding 19 mph  
(30 km/h), until the system finds an available  
space.  
The parking space search is suspended at  
higher speeds. The function is automatically  
169  
Driving  
deactivated if the vehicle speed exceeds 31 mph  
(50 km/h).  
accompanied by the "STOP" sign and an audible  
signal.  
Once the vehicle has stopped, an instructions  
page is displayed on the screen.  
To prepare for the manoeuvre, follow the  
instructions.  
The start of the manoeuvre is indicated by  
the message "Manoeuvre under way",  
accompanied by an audible signal.  
Reversing is indicated by this message:  
"Release the steering wheel, reverse".  
The Top Rear Vision function and the parking  
sensors are automatically activated to help you  
monitor your vehicle's close surroundings during  
the manoeuvre.  
Manoeuvre cancelled or finished (red)  
(the arrows indicate that the driver must  
resume control of the vehicle).  
The maximum speeds during manoeuvres are  
indicated by these symbols:  
For ''parallel'' parking, the space must at  
a minimum be equal to the length of your  
vehicle plus 0.60 m.  
For ''bay'' parking, the width of the space  
must be equal to the width of your vehicle  
plus 0.70 m.  
5 mph or 7 km/h, for parking space entry.  
7
3 mph or 5 km/h, for parking space exit.  
5
During manoeuvring phases, the steering  
wheel performs rapid turns: do not hold  
the steering wheel or put your hands between  
the spokes of the steering wheel. Watch out  
for any objects that could interfere with the  
manoeuvre (loose clothing, scarf, tie, etc.).  
Risk of injury!  
It is the driver's responsibility to constantly  
monitor the traffic, especially vehicles coming  
towards you.  
If the parking sensors function has been  
deactivated in the Driving/Vehicle touch  
screen menu, it will be automatically  
reactivated when the system is activated.  
During the manoeuvre  
The system controls the vehicle’s steering. It  
gives instructions on the manoeuvring direction  
when starting "parallel" entry and exit parking  
manoeuvres, and for all "bay" entry manoeuvres.  
These instructions are displayed as a symbol  
accompanied by a message:  
The driver should check that no objects or  
people are obstructing the vehicle’s path.  
The images from the camera(s)  
displayed on the touch screen may be  
distorted by the terrain.  
"Reverse".  
“Go forwards".  
When the system finds an available space, "OK"  
is displayed on the parking view, accompanied  
by an audible signal.  
In shady areas, or in inadequate sunlight  
or lighting conditions, the image may be  
darkened and with lower contrast.  
The manoeuvring status is indicated by these  
symbols:  
Manoeuvre in progress (green).  
The manoeuvre can be permanently interrupted  
at any time, either by the driver or automatically  
by the system.  
Preparing for the manoeuvre  
► Move very slowly until the request to stop  
the vehicle is displayed: "Stop the vehicle",  
170  
Driving  
Interruption by the driver:  
End of the parking space entry or exit  
manoeuvre  
The vehicle stops as soon as the manoeuvre is  
completed.  
The manoeuvre symbol is displayed in red,  
accompanied by the message "Manoeuvre  
completed" on the touch screen.  
When the function is deactivated, this  
indicator lamp goes off, accompanied by  
an audible signal.  
(pavements, studs, etc.) or too thin (trees, posts,  
wire fences, etc.).  
– If the boot is heavily loaded, the tilt of the  
vehicle towards the rear may interfere with the  
distance measurements.  
6
– taking over control of the steering.  
– activating the direction indicator lamps on the  
opposite side to that of the manoeuvre.  
– unfastening the driver's seat belt.  
– switching off the ignition.  
Do not use the function under the  
following exterior conditions:  
– Alongside a soft shoulder (e.g. ditch) or  
quay or on the edge of a drop.  
Interruption by the system:  
– vehicle exceeding the speed limit of  
5 mph (7 km/h) during parking space entry  
manoeuvres, or 3 mph (5 km/h) during parking  
space exit manoeuvres.  
– activation of anti-slip regulation on a slippery  
road.  
– opening of a door or the boot.  
– engine stall.  
– system malfunction.  
– after 10 manoeuvres to enter or exit a parallel  
parking space and after 7 manoeuvres to enter a  
parking bay.  
Interrupting the manoeuvre automatically  
deactivates the function.  
The manoeuvre symbol is displayed in red,  
accompanied by the "Manoeuvre cancelled"  
message on the touch screen.  
A message prompts the driver to take back  
control of the vehicle.  
– When the road surface is slippery (e.g. ice).  
When entering a parking space, the driver may  
be required to complete the manoeuvre.  
If any of the following malfunctions  
occurs, do not use the system:  
– If a tyre is under-inflated.  
– If one of the bumpers is damaged.  
– If one of the cameras is faulty.  
Operating limits  
– The system may suggest an inappropriate  
parking space (parking prohibited, work in  
progress with damaged road surface, location  
alongside a ditch, etc.).  
If the vehicle has undergone any of the  
following modifications, do not use the  
function:  
– When carrying an object extending beyond  
the dimensions of the vehicle (ladder on the  
roof bars, bicycle carrier on the tailgate, etc.).  
– With a non-approved towball in place.  
– With snow chains fitted.  
– When driving on a small-diameter or  
"space-saver" type spare wheel.  
– When the wheels fitted are a different size  
from the original ones.  
– After modifying one or both bumpers  
(added protection).  
– The system may indicate that a space has  
been found but will not offer it because of a fixed  
obstacle on the opposite side of the manoeuvre,  
which would not allow the vehicle to follow a  
trajectory required for parking.  
– The system may indicate that a space has  
been found but the manoeuvre will not be  
triggered, because the width of the lane is  
insufficient.  
– The system is not designed for performing the  
parking manoeuvre on a sharp bend.  
– The system does not detect spaces that  
are much larger than the vehicle itself or that  
are delimited by obstacles that are too low  
The function is deactivated after a few  
seconds; this indicator lamp goes off and  
the function returns to the initial display.  
171  
Driving  
– If the sensors have been repainted other  
than by the CITROËN dealer network.  
– With sensors not approved for the vehicle.  
Malfunctions  
When the function is not activated, this  
indicator lamp will flash briefly and an  
audible signal will be emitted to indicate a  
system malfunction.  
If the malfunction occurs while the system is in  
use, the indicator lamp goes off.  
If the parking sensor malfunction occurs  
during use, indicated by this warning lamp  
coming on, it causes the function to deactivate.  
Contact a CITROËN dealer or a qualified  
workshop.  
In the event of a power steering  
malfunction, this warning lamp is  
displayed on the instrument panel, accompanied  
by a warning message.  
You must stop the vehicle.  
Stop as soon as it is safe to do so and  
switch off the ignition.  
Contact a CITROËN dealer or a qualified  
workshop.  
172  
prefers  
FILL UP WITH  
CONFIDENCE  
WITH TOTAL QUARTZ LUBRICANTS  
For more than 50 years, TOTAL and CITROËN  
have shared common values: excellence, creativity  
and technological innovation.  
It is in this same spirit that TOTAL has developed  
a range of TOTAL QUARTZ lubricants adapted for  
engines in CITROËN vehicles, making them ever  
more fuel efficient and environmentally friendly.  
TOTAL and CITROËN test the reliability and the  
performance of their products under extreme  
motorsport conditions.  
Choose TOTAL QUARTZ lubricants when  
servicing your vehicle; they are your assurance  
of optimum engine life and performance.