Get Driving -> Parking sensors Guide for Citroen Berlingo SUV Third Generation (2018-2025)

Driving

surface, leaving a tunnel, alternating light and

shade).

– windscreen area located in front of the

camera: dirty, misted, frost-covered, snow-

covered, damaged or covered by a sticker.

– lane markings absent, worn, hidden (snow,

mud) or multiple (roadworks).

Depending on version, in the example shown,

– close to the vehicle in front (lane markings

not detected).

– narrow or winding roads.

only the obstacles present in the shaded area

will be signalled by the audible assistance.

The proximity information is given by an

intermittent audible signal, the frequency of

which increases as the vehicle approaches the

obstacle.

When the distance between the vehicle and

the obstacle becomes less than about thirty

centimetres, the audible signal becomes

continuous.

This system detects and signals the proximity of

obstacles (e.g. pedestrian, vehicle, tree, barrier)

using sensors located in the bumper.

In certain driving conditions (poor road

surface or strong winds), the system may

give alerts independent of the driver's level of

vigilance.

Rear parking sensors

► Engage reverse gear to start the system

(conﬁrmed by an audible signal).

The system is switched oﬀ when reverse gear is

disengaged.

The following situations may interfere

with the operation of the system or

prevent it from working:

– lane markings absent, worn, hidden (snow,

mud) or multiple (roadworks);

The sound emitted by the speaker (right or

left) indicates the side on which the obstacle is

located.

Audible assistance

– close to the vehicle ahead (lane markings

not detected);

Adjusting the audible signal

Depending on version, with

– roads that are narrow, winding, etc.

CITROËN Connect Radio or

CITROËN Connect Nav, pressing this button

opens the window for adjusting the volume of

the audible signal.

Parking sensors

The system signals the presence of obstacles

which are both within the sensors’ detection zone

and in the vehicle path deﬁned by the direction of

the steering wheel.

For more information, refer to the

General recommendations on the use

of driving and manoeuvring aids.

161

Driving

Visual assistance

Side parking sensors

Deactivation/Activation

Without touch screen

This supplements the audible signal, without

taking account of the vehicle's trajectory, by

displaying bars on the screen whose location

represents the distance between the obstacle

and the vehicle (white: more distant, orange:

close, red: very close).

Using four additional sensors located on the

sides of the bumpers, the system records the

position of obstacles during the manoeuvre and

indicates them when they are located alongside

the vehicle.

► To deactivate or activate the system, press

this button.

The indicator lamp is on when the system is

deactivated.

Only ﬁxed obstacles are indicated

correctly. Moving obstacles detected at

the beginning of the manoeuvre may be

indicated mistakenly, while moving obstacles

that appear alongside the vehicle but were

not previously recorded will not be indicated.

When the obstacle is very close, the "Danger"

symbol is displayed on the screen.

With touch screen

The settings are changed via

the Driving/Vehicle touch screen

menu.

The status of the function is saved when the

ignition is switched oﬀ.

Front parking sensors

Supplementing the rear parking sensors, the

front parking sensors are triggered when an

obstacle is detected in front and the speed of the

vehicle is below 6 mph (10 km/h).

Objects memorised during the

manoeuvre will no longer be stored after

switching oﬀ the ignition.

Front parking sensor operation is suspended if

the vehicle stops for more than three seconds in

forward gear, if an obstacle is no longer detected

or the vehicle speed exceeds 6 mph (10 km/h).

The sound emitted by the speaker (front

or rear) locates the obstacle relative to

the vehicle, whether in front of or behind it on

its path.

The rear parking sensors system will be

deactivated automatically if a trailer or

162

Driving

bicycle carrier is connected to a towing device

installed in accordance with the

manufacturer's recommendations.

In this case, the outline of a trailer is displayed

at the rear of the image of the vehicle.

With the ignition on, this system uses a camera

located near the third brake lamp to display

a view of the rear of your vehicle on the

reproduction screen (if it is a panel van or has a

solid partition).

The green lines 3 represent distances of about 1

and 2 metres beyond the edge of your vehicle's

rear bumper.

The turquoise blue curves 4 represent the

maximum turning circle.

The reversing camera is activated automatically

when reverse gear is engaged. The image

is displayed on the reproduction screen. The

reproduction screen switches oﬀ when the

gearbox is in neutral or in a forward gear.

Some objects may not be seen by the

camera.

The parking sensors are deactivated while the

Park Assist function is measuring a space.

For more information on the Park

Assist function, refer to the corresponding

section.

Certain vehicles may be diﬃcult to see

(dark colours, lamps oﬀ) when the

brightness of the screen is reduced using the

vehicle’s lighting dimmer.

Operating limits

If the boot is heavily loaded, the vehicle may tilt,

aﬀecting distance measurements.

The image quality may be aﬀected by the

surroundings, the exterior conditions

(rain, dirt, dust), the driving mode and the

lighting conditions (night, low sun).

In the presence of areas in shade, or in

conditions of bright sunlight or inadequate

lighting, the image may be darkened and with

lower contrast.

Malfunction

In the event of a malfunction when

changing into reverse gear, this warning

lamp lights up on the instrument panel,

accompanied by the display of a message and

an audible signal (short beep).

Have it checked by a CITROËN dealer or a

qualiﬁed workshop.

Obstacles may appear further away than

they actually are.

The blue lines 1 represent the general direction

of the vehicle (the gap corresponds to the width

of your vehicle with the mirrors).

During parking manoeuvres and lane

changes, it is important to check the sides of

the vehicle using the mirrors.

Reversing camera

The red line 2 represents a distance of about

30 cm beyond the edge of your vehicle's rear

bumper.

The rear parking sensors also supplement the

information on the vehicle's surroundings.

For more information, refer to the

General recommendations on the use

of driving and manoeuvring aids.

163

Driving -> Parking sensors for Your Citroen Berlingo SUV Third Generation (2018-2025)

Related Topics

Driving

Popular Owner Manuals

Latest Owner Manuals